- 您現在的位置：買賣IC網 > PDF目錄373543 > TA31002 (友順科技股份有限公司) TELEPHONE TONE RINGER PDF資料下載
參數資料
| 型號： | TA31002 |
| 廠商： | 友順科技股份有限公司 |
| 英文描述： | TELEPHONE TONE RINGER |
| 中文描述： | 音頻電話機鈴聲 |
| 文件頁數： | 3/4頁 |
| 文件大?。?/td> | 33K |
| 代理商： | TA31002 |
UTC TA31002A LINEAR INTEGRATED CIRCUIT
UTC
UNISONIC TECHNOLOGIES CO., LTD.
3
APPLICATION NOTE
The application circuit illustrates the use of the
UTCTA31002A device in typical telephone tone ringer
application.
The AC ringer signal voltage appears
across the TIP and RING inputs of the circuit and
is attenua-
ted by capacitor C1 and resistor R1.
C1 also provides isolation from DC voltage (48V)
on the exchanged line.
After full wave rectification by the bridge
diode, the wave form is filtered by capacitor C4 to
provide a DC supply for the tone ringer chip.
As this voltage exceeds the initiation voltage (Vsi),
oscillation starts.
With the components shown , the output frequency
chops between 512Hz (F
H1
) and 640 Hz(F
H2
)
at a 10 Hz(F
L
) rate.
The loudspeaker load is coupled through a 1300
to 8
transformer.
The output coupling capacitor C5 is required with
transformer coupled loads.
When driving a pizeo-ceramic transducer type load,
the coupling C5 and transformer (1300
:8
) are
not required.
However, a current limiting resistor is required.
The low frequency oscillator oscillates at a rate (F
L
)
controlled by an external resistor (R2) and capacitor
(C2).
The fequency can be determined using the relation
F
L
=1/1.289 R2* C2. The high frequency oscillates
at a FH1,F
H2
controlled by an external resistor (R3)
and capacitor (C3). The frequency can be determined
using the relation F
H1
=1/1.504 R3*C3 and F
H2
=
1/1.203 R3*C3.
Pin 2 of the UTC TA31002A allows connection of
external resistor RSL, which is used to program the
slope of the supply current vs. supply voltage
characteristics (see Fig.3), and hence the supply
current up to the initiation voltage (Vsi). This initiation
voltage remains constant independent of RSL.
The supply current drawn prior to triggering varies
inversely with RSL, decreasing for increasing value
of resistance. Thus, increasing the value of RSL, will
decrease the amount of AC ringing current required to
trigger the device. As such, longer sucribser loops are
possible since less voltage is dropped per unit length of
loop wire due to the lower current level. RSL can
also be used to compensated for smaller AC coupling
capacitors (C5 on Fig.4) (higher impedance) to the
line which can be used to alter the ringer
equivalence
number of a tone ringer circuit.
The graph in Fig.3 illustrates the variation of supply
current with supply voltage of the UTC
TA31002A.
Three curves are drawn to show the variation of
initiation current with RSL. Curve B ( RSL=6.8K)
shows the I-V characteristic for UTC TA31002A
tone ringer. Curve A is a plot with RSL<6.8K
and shows an increase in the current drawn up to the
initiation voltage Vsi. The I-V characteristic after
initiation remains unchanged. Curve C illustrates the
effect of increasing RSL above 6.8K
initiation current decreases but again current
alter triggering is unchanged.
相關PDF資料 |
PDF描述 |
|---|---|
| TA31101 | COMPANDER IC FOR CORDLESS TELEPHONE |
| TA31101P | COMPANDER IC FOR CORDLESS TELEPHONE |
| TA31101AF | COMPANDER IC FOR CORDLESS TELEPHONE |
| TA31101AP | COMPANDER IC FOR CORDLESS TELEPHONE |
| TA31101F | COMPANDER IC FOR CORDLESS TELEPHONE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TA31002_07 | 制造商:UTC-IC 制造商全稱:UTC-IC 功能描述:TELEPHONE TONE RINGER |
| TA31002A | 制造商:UTC-IC 制造商全稱:UTC-IC 功能描述:TELEPHONE TONE RINGER |
| TA31002AF | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Telephone Ringer |
| TA31002AP | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Telephone Ringer |
| TA31002-D08-T | 制造商:UTC-IC 制造商全稱:UTC-IC 功能描述:TELEPHONE TONE RINGER |
發布緊急采購，3分鐘左右您將得到回復。