- 您現在的位置：買賣IC網 > PDF目錄231084 > TC573802ECTRT SPECIALTY ANALOG CIRCUIT, PDSO5 PDF資料下載
參數資料
| 型號： | TC573802ECTRT |
| 元件分類： | 模擬信號調理 |
| 英文描述： | SPECIALTY ANALOG CIRCUIT, PDSO5 |
| 封裝： | EIAJ, SC-74A, SOT-23A, 5 PIN |
| 文件頁數： | 6/11頁 |
| 文件大?。?/td> | 72K |
| 代理商： | TC573802ECTRT |
4
Linear Regulator Controller
TC57 Series
TC57-2
1/25/00
2001 Microchip Technology Inc.
DS21437A
DETAILED DESCRIPTION
The TC57 series of precision low dropout regulator
controllers use an external PNP transistor to accommodate
a wide range of output currents. A series resistor (RB) limits
the maximum base current drawn from the PNP transistor.
Limiting the base drive both determines the regulator’s
output current capability, as well as limits ground current
when the device is operated in dropout. The PNP transistor’s
VCE(SAT) is the only factor limiting dropout voltage.
Transistor Selection
The PNP pass transistor must have satisfactory power
dissipation, current gain, and collector current specifications
to suit the application at hand. The maximum output current
the circuit can deliver is influenced by hFE. The highest
guaranteed output current is given by:
ILOAD(MAX) = 25 mA x hFE(MIN)
The transistor’s actual power dissipation (PD) is equal to
the maximum load current times the maximum input/output
voltage differential, or:
PD = ILOAD(MAX) x (VIN(MAX) –VOUT(min))
The ideal transistor has a minimum hFE of 100, and a
VCE(SAT) of less than 0.6V at full output current. For example,
the Zetex FZT749 has an hFE of 170 at a collector current of
1A, and a guaranteed VCE(SAT) of 0.3V at a base current of
100 mA. It is packaged in a SOT223 and is recommended
for use with the TC57. Other transistors are also suitable,
depending on the required input and output voltages and
output current (Table 2a).
Base-Current Limiting Resistor (Figure 2)
Base current limiting resistor RB can be estimated using:
where: hFE is the current gain of the pass transistor
VIN is the input voltage (in volts)
VBE is the base-emitter voltage at the desired output
current (in volts)
IOUT is the output current (in Amps)
For example, assume a desired continuous output cur-
rent of 1.0A, an input voltage of 5V, and an FZT749 pass
transistor. The FZT749 has a typical hFE of 170, and a VBE
of 0.8V; both specified at a collector current of 1.0A. Substi-
tuting these values into the equation above results in an RB
value of 704
(closest standard value = 680).
Pull-Up Resistor and Output Capacitor (Figure 2)
A pull-up resistor (RBE, installed between the base and
emitter of the pass transistor) facilitates rapid turn-off of the
pass transistor in the event of a sudden decrease in load.
Recommended values for this resistor are between 20 K
and 47 K
. A Tantalum output capacitor of at least 10 F
must be used to guarantee stability. Higher values decrease
output noise and eliminate power-on overshoot, but extend
power-up times. Table 2a lists several capacitor choices.
Input Capacitor (Figure 2)
The addition of an input capacitor further reduces output
noise, and negates the effects of power supply input imped-
ance. A 10
F(min) Tantalum capacitor is recommended.
Shutdown Mode
The TC57 enters a low power shutdown mode when the
shutdown input (SHDN) is high. During shutdown, the regu-
lator is disabled, the output capacitor is discharged through
the load, and supply current to the TC57 decreases to less
than 1
A. Normal operation resumes when SHDN is brought
low. If the shutdown mode is not used, SHDN should be tied
to VIN.
RB =
hFE(VIN – VBE)
IOUT
Equation 1.
Equation 2.
Equation 3.
Figure 2. 3.3V, 1A Regulator Using 5V Supply Input
TC57
VOUT
GND
SHDN
VIN
EXT
CIN
10
F
(Tantalum)
FZT749
Q1
RB
680
COUT
10
F
(Tantalum)
VIN = 5V
RBE
33K
1
2
3
4
5
2
ON
OFF
VOUT = 3.3V
相關PDF資料 |
PDF描述 |
|---|---|
| TC574402ECTRT | SPECIALTY ANALOG CIRCUIT, PDSO5 |
| TL1431IDT | 1-OUTPUT TWO TERM VOLTAGE REFERENCE, 2.5 V, PDSO8 |
| TC54VC4701EMB723 | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PSSO3 |
| TC54VN3902EMB713 | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PSSO3 |
| TC54VC5501EZB | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PBCY3 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TC5747 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Single Chip CMOS Imager with Integrated Image Signal Processor and JPEG Codec |
| TC57512AD-15 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:65,536 WORDS x 8 BITS CMOS UV ERASABLE AND ELECTRICALLY PROGRAMMABLE READ ONLY MEMORY |
| TC57512AD-20 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:65,536 WORDS x 8 BITS CMOS UV ERASABLE AND ELECTRICALLY PROGRAMMABLE READ ONLY MEMORY |
| TC57A | 制造商:CDE 制造商全稱:Cornell Dubilier Electronics 功能描述:Axial Leaded Aluminum Electrolytic Capacitors |
| TC5-7-C100 | 功能描述:電纜固定件和配件 Tack Clip, Single, .21" (5.3mm) Bundle, RoHS:否 制造商:Heyco 類型:Cable Grips, Liquid Tight 材料:Nylon 顏色:Black 安裝方法:Cable 最大光束直徑:11.4 mm 抗拉強度: |
發布緊急采購，3分鐘左右您將得到回復。