- 您現在的位置：買賣IC網 > PDF目錄383940 > TDA5360 (NXP Semiconductors N.V.) Pre-Amplifier for Hard Disk Drive with MR-Read / Inductive Write Heads PDF資料下載
參數資料
| 型號： | TDA5360 |
| 廠商： | NXP Semiconductors N.V. |
| 英文描述： | Pre-Amplifier for Hard Disk Drive with MR-Read / Inductive Write Heads |
| 中文描述： | 預硬盤放大器磁共振讀/寫磁頭感應 |
| 文件頁數： | 12/34頁 |
| 文件大?。?/td> | 198K |
| 代理商： | TDA5360 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁當前第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁
1998 July 30
Philips Semiconductors
Objective Specification, Revision 2.2
Pre-Amplifier for Hard Disk Drive with
MR-Read / Inductive Write Heads
TDA5360
12
10 BIASING OF THE MR ELEMENT
This preamplifier has been designed for SAL and GMR elements. Programming bit GMR in Reg. 01 select either a SAL
range (LOW) or a GMR range (HIGH).
By programming bit PORI in Reg. 01, the user can program either a constant current bias (LOW) or a constant power
bias (HIGH) for the MR element. The value of the current/power is programmed on 5 bits via Reg. 02.
If bit PORI in Reg. 01 is HIGH, a constant power bias is maintained accross the MR element.
The power is defined as :
Pw = RMR * IMR
In power bias mode, two power ranges are possible :
2
, where Pw is constant over temperature and process.
For SAL heads
1.5mW to 9.25 mW
in steps of 0.25mW
For GMR heads
375uW to 2.3 mW
in steps of 0.0625mW
Note :
whatever Power programmation is used, the I
MR
current flowing into the MR element will be within the min-
max range given below.
If bit PORI in Reg.01 is LOW, then the biasing scheme shall revert to constant current instead of constant power.
IMR is then constant over temperature and process.
In current bias mode, two current ranges are possible :
For SAL heads :
4 to 10.2 mA in steps of 0.2 mA
For GMR heads :
3 to 6.1 mA in steps of 0.1 mA
Note :
In GMR mode, I
MR
current is guaranted up to 5.1mA
6.1mA can be reached under certain supplies/Rmr conditions.
10.1
MR Head Resistance and Temperature Measurement
By programming RANGE0,RANGE1 bits in Reg. 08, the user can select either a Rmr measurement or a Temperature
measurement (junction temperature).
Setting DIGON bit HIGH launch a digitazation
The settling time of the digitization operation is less than
TBD
μ
s.
A 5 bit code is then available in Reg. 08, as long as DIGON stays HIGH,
Setting DIGON bit LOW, reset the 5 bit code.
In case of Rmr measurement, the user have access to two Rmr range by programming RANGE0 and RANGE1 bits.
In case of Temperature too high condition (T > 140
o
C), during a Temperature measurement, a Fault is triggered on FLT
line and a error code is available in Reg. 07.
相關PDF資料 |
PDF描述 |
|---|---|
| TDA5360UH | Pre-Amplifier for Hard Disk Drive with MR-Read / Inductive Write Heads |
| TDA5360UK | Pre-Amplifier for Hard Disk Drive with MR-Read / Inductive Write Heads |
| TDA5630 | 9 V VHF, hyperband and UHF mixer/oscillator for TV and VCR 3-band tuners |
| TDA5630BT | 9 V VHF and UHF mixer/oscillator for TV and VCR cable tuners |
| TDA5630M | 9 V VHF, hyperband and UHF mixer/oscillator for TV and VCR 3-band tuners |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TDA5360UH | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Pre-Amplifier for Hard Disk Drive with MR-Read / Inductive Write Heads |
| TDA5360UK | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Pre-Amplifier for Hard Disk Drive with MR-Read / Inductive Write Heads |
| TDA5510-2 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Video IF IC with VTR Connection |
| TDA5630 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:9 V VHF, hyperband and UHF mixer/oscillator for TV and VCR 3-band tuners |
| TDA5630BT | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:9 V VHF and UHF mixer/oscillator for TV and VCR cable tuners |
發布緊急采購，3分鐘左右您將得到回復。