- 您現在的位置：買賣IC網 > PDF目錄373622 > TDA7427D (意法半導體) AM-FM RADIO FREQUENCY SYNTHESIZER AND IF COUNTER PDF資料下載
參數資料
| 型號： | TDA7427D |
| 廠商： | 意法半導體 |
| 元件分類： | 通用總線功能 |
| 英文描述： | AM-FM RADIO FREQUENCY SYNTHESIZER AND IF COUNTER |
| 中文描述： | 上午- FM收音機頻率合成器和中頻計數器 |
| 文件頁數： | 11/21頁 |
| 文件大?。?/td> | 144K |
| 代理商： | TDA7427D |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁
I
2
C BUS INTERFACE DESCRIPTION
The TDA7427 supports the I
2
C bus protocol. This
protocol defines any device that sends data into
the bus as a transmitter and the receiving device
as the receiver. The device that controls the
transfer is the master and the device being con-
trolled is the slave. The master always initiates
data transferand provides the clock to transmit or
receive operations.
Data Transition
Data transition on the SDA line must only occur
when the clock SCL is low. SDA transitions while
SCL is high will be interpreted as START or
STOP condition.
Start Condition
A start condition is defined by a HIGH to LOW
transition of the SDA line while SCL is at a stable
HIGH level. This START condition must precede
any commandand initiate a data transfer onto the
bus. The TDA7427 continuously monitors the
SDA and SCLlines for a valid START and will not
response to any command if this condition has
not been met.
Stop Condition
A STOP condition is defined by a LOW to HIGH
transitionof theSDA whilethe SCLline isat a stable
HIGH level.This conditionterminatethecommunica-
tionbetweenthedevicesandforcesthebusinterface
of theTDA7427intotheinitialcondition.
Acknowledge
Indicatesa successfuldata transfer.The transmit-
ter will release the bus after sending 8 bit of data.
During the 9th clock cycle the receiverwill pull the
SDA line to LOW level to indicate it has receive
the eight bits of data correctly.
Data transfer
During data transfer the TDA7427 samples the
SDA line on the leading edge of the SCL clock.
Therefore, for proper device operation the SDA
line must be stable during the SCL LOW to HIGH
transition.
DeviceAddressing
To start the communicationbetween two devices,
the bus master must initiate a start instruction se-
quence,followed by an eight bit wordcorrespond-
ing to the addressof the device it is addressing.
The most significant 6 bits of the slave address
are the device type identifier.
The TDA7427 frequency synthesizer device type
is fixed as ”110001”
The next significant bit is used to address a par-
ticular device of the previous defined type con-
nected to the bus. The state of the hardwired A0
pin defines the state of this address bit. So up to
two devicescould be connectedon the same bus.
The last bit of the instruction defines the type of
operationto be performed:
- When setto ”1”,a readoperation is selected
-
Whensetto ”0”, a write operationis selected
The chip selection is accomplished by setting the
bit of the chip addressto the correspondingstatus
of the A0 input.
All TDA7427 connected to the bus will compare
their own hardwired address with the slave ad-
10
μ
F
100nF
100nF
VDD2
15
VDD1
19
+10V
+5V
AM-FM
IF
IF_FM
11
IF_AM
10
10nF
10nF
TDA7427
13
12
7
14
INLOCK/DOUT1
SSTOP
DOUT3
HFREF
8
9
VDD1
SCL
SDA
CONTROLLER
5
6
OSCIN
OSCOUT
100nF
4
VREF
4MHz
3
6.8nF
100K
68nF
27K
6.8nF
1nF
1
2
15K
AM VCO
FM VCO
16
20
17
10nF
1nF
U
tun
AM_IN
FM_IN
LPOUT
LP_FM
LP_HC
LP_AM
D95AU379B
10nF
10
μ
F
3.9K
100nF
820
3.3nF
FM:50KHz
AM:1KHz
Figure 6. Applicationwith two loop filters
TDA7427
11/21
相關PDF資料 |
PDF描述 |
|---|---|
| TDA7429L | 3 BAND EQUALIZER AUDIO PROCESSOR WITH SUBWOOFER CONTROL |
| TDA7429S | DIGITALLY CONTROLLED AUDIO PROCESSOR WITH SURROUND SOUND MATRIX |
| TDA7429T | DIGITALLY CONTROLLED AUDIO PROCESSOR WITH SURROUND SOUND MATRIX |
| TDA7429 | Digitally Controlled Audio Processor with Surround Sound Matrix(數控音頻處理器) |
| TDA7430 | DIGITALLY CONTROLLED AUDIO PROCESSOR WITH SURROUND SOUND MATRIX AND VOICE CANCELLER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TDA7429 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:DIGITALLY CONTROLLED AUDIO PROCESSOR WITH SURROUND SOUND MATRIX |
| TDA7429L | 功能描述:音頻 DSP 3-Band Equalizer RoHS:否 制造商:Texas Instruments 工作電源電壓: 電源電流: 工作溫度范圍: 安裝風格: 封裝 / 箱體: 封裝:Tube |
| TDA7429S | 功能描述:音頻 DSP 3-Band Equalizer RoHS:否 制造商:Texas Instruments 工作電源電壓: 電源電流: 工作溫度范圍: 安裝風格: 封裝 / 箱體: 封裝:Tube |
| TDA7429T | 功能描述:音頻 DSP 3-Band Equalizer RoHS:否 制造商:Texas Instruments 工作電源電壓: 電源電流: 工作溫度范圍: 安裝風格: 封裝 / 箱體: 封裝:Tube |
| TDA7429T13TR | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:DIGITALLY CONTROLLED AUDIO PROCESSOR WITH SURROUND SOUND MATRIX |
發布緊急采購，3分鐘左右您將得到回復。