參數資料
型號： TDA7500ATR
廠商： STMICROELECTRONICS
元件分類： 消費家電
英文描述： SPECIALTY CONSUMER CIRCUIT, PQFP100
封裝： ROHS COMPLIANT, TQFP-100
文件頁數： 24/41頁
文件大?。?/td> 431K
代理商： TDA7500ATR
TDA7500A
30/40
s
I2C and SPI interface
s
XCHG Interface for DSP to DSP communication
s
External Memory Interface (DRAM/SRAM) for time-delay and traffic information
s
Double Debug Port
DATA AND PROGRAM MEMORY
Both DSP0 and DSP1 have Data and Program memories attached to them. Each of the memories are described
below and it is implied that there are two of each type, one set connected to DSP0 and the other to DSP1. The
only exception is the case of the P-RAM where DSP1 has a 2048 x 24-Bit PRAM and DSP0 has a 5.5K x 24-
Bit PRAM.
1024 x 24-Bit X-RAM (XRAM)
This is a 1024 x 24-Bit Single Port SRAM used for storing coefficients. The 16-Bit XRAM address, XABx(15:0)
is generated by the Address Generation Unit of the DSP core. The 24-Bit XRAM Data, XDBx(23:0), may be writ-
ten to and read from the Data ALU of the DSP core. The XDBx Bus is also connected to the Internal Bus Switch
so that it can be routed to and from all peripheral blocks.
1024 x 24 Bit Y-RAM (YRAM)
This is a 512 x 24-Bit Single Port SRAM used for storing coefficients. The 16-Bit address, YABx(15:0) is gener-
ated by the Address Generation Unit of the DSP core. The 24-Bit Data, YDBx(23:0), is written to and read from
the Data ALU of the DSP core. The YDBx Bus is also connected to the Internal Bus Switch so that it can be
routed to and from other blocks.
2048 x 24-Bit Program RAM (PRAM 5.5K x 24-bit for DSP0)
This is a 2048 x 24-Bit Single Port SRAM used for storing and executing program code. The 16-Bit PRAM Ad-
dress, PABx(15:0) is generated by the Program Address Generator of the DSP core for Instruction Fetching,
and by the AGU in the case of the Move Program Memory (MOVEM) Instruction. The 24-Bit PRAM Data (Pro-
gram Code), PDBx(23:0), can only be written to using the MOVEM instruction. During instruction fetching the
PDBx Bus is routed to the Program Decode Controller of the DSP core for instruction decoding.
512 x 24-Bit Bootstrap ROM (PROM 256 x 24 Bit for DSP1)
This is a 512 x 24-Bit factory programmed Boot ROM used for storing the program sequence and for initializing
the DSP. Essentially this consists of reading the data via I2C, SPI or EMI interface and store it in PRAM, XRAM,
YRAM, and/or external DRAM.
相關PDF資料
PDF描述
TDA7500 SPECIALTY CONSUMER CIRCUIT, PQFP100
TDA7502013TR SPECIALTY CONSUMER CIRCUIT, PQFP44
TDA7502E013TR SPECIALTY CONSUMER CIRCUIT, PQFP44
TDA7503 SPECIALTY CONSUMER CIRCUIT, PQFP100
TDA7511 AM/FM, AUDIO SINGLE CHIP RECEIVER, PQFP64
相關代理商/技術參數
參數描述
TDA7501 功能描述:音頻 DSP Digit Car Radio Sig RoHS:否 制造商:Texas Instruments 工作電源電壓: 電源電流: 工作溫度范圍: 安裝風格: 封裝 / 箱體: 封裝:Tube
TDA7501_07 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Line driver for digital car radio Signal processor (DSPLD)
TDA7501TR 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Line driver for digital car radio Signal processor (DSPLD)
TDA7502 功能描述:數字信號處理器和控制器 - DSP, DSC In-Car Remote Amp RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT
TDA7502_06 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:In-car remote amplifier DSP
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*