- 您現在的位置：買賣IC網 > PDF目錄373625 > TDA7563PDTR (意法半導體) MULTIFUNCTION QUAD POWER AMPLIFIER WITH BUILT-IN DIAGNOSTICS FEATURES PDF資料下載
參數資料
| 型號： | TDA7563PDTR |
| 廠商： | 意法半導體 |
| 英文描述： | MULTIFUNCTION QUAD POWER AMPLIFIER WITH BUILT-IN DIAGNOSTICS FEATURES |
| 中文描述： | 多功能四功率放大器，內置診斷特征 |
| 文件頁數： | 13/21頁 |
| 文件大小： | 213K |
| 代理商： | TDA7563PDTR |
13/21
TDA7563PD
Figure 27. Thermal Foldback Diagram
8
A correct turn on/off sequence respectful of the diagnostic timings and producing no audible noises could be as
follows (after battery connection):
TURN-ON: PIN2 > 7V --- 10ms --- (STAND-BY OUT + DIAG ENABLE) --- 500 ms (min) --- MUTING OUT
TURN-OFF: MUTING IN --- 20 ms --- (DIAG DISABLE + STAND-BY IN) --- 10ms --- PIN2 = 0
Car Radio Installation: PIN2 > 7V --- 10ms DIAG ENABLE (write) --- 200 ms --- I
2
C read (repeat until All faults
disappear).
OFFSET TEST: Device in Play (no signal) -- OFFSET ENABLE - 30ms - I
2
C reading (repeat I
2
C reading until
high-offset message disappears).
I
2
C PROGRAMMING/READING SEQUENCES
9
Data transmission from microprocessor to the TDA7563PD and viceversa takes place through the 2 wires
I
2
C BUS interface, consisting of the two lines SDA and SCL (pull-up resistors to positive supply voltage
must be connected).
I
2
C BUS INTERFACE
9.1 Data Validity
As shown by fig. 28, the data on the SDA line must be stable during the high period of the clock. The HIGH and
LOW state of the data line can only change when the clock signal on the SCL line is LOW.
9.2 Start and Stop Conditions
As shown by fig. 29 a start condition is a HIGH to LOW transition of the SDA line while SCL is HIGH. The stop
condition is a LOW to HIGH transition of the SDA line while SCL is HIGH.
9.3 Byte Format
Every byte transferred to the SDA line must contain 8 bits. Each byte must be followed by an acknowledge bit.
The MSB is transferred first.
Tj (°C)
TH. SH.
START
TH. SH.
END
Vout
TH. WARN.
ON
Tj (°C)
Vout
Tj ( °C)
> T
SD
(with same input
signal)
< T
SD
CD out
相關PDF資料 |
PDF描述 |
|---|---|
| TDA7563 | MULTIFUNCTION QUAD POWER AMPLIFIER WITH BUILT-IN DIAGNOSTICS FEATURES |
| TDA7564 | MULTIFUNCTION QUAD POWER AMPLIFIER WITH BUILT-IN DIAGNOSTICS FEATURES |
| TDA7565 | QUAD POWER AMPLIFIER WITH BUILT-IN VOLTAGE CONVERTER |
| TDA7566 | MULTIFUNCTION QUAD POWER AMPLIFIER WITH BUILT-IN DIAGNOSTICS FEATURES |
| TDA7575PD | MULTIFUNCTION DUAL BRIDGE POWER AMPLIFIER WITH INTEGRATED DIGITAL DIAGNOSTICS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TDA7564 | 功能描述:音頻放大器 Quad Power Amplifier RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TDA7564B | 功能描述:音頻放大器 4 x 50W Multi Quad Power Amplifer D RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TDA7564BH | 功能描述:音頻放大器 4 x 50W Multi Quad Power Amplifer D RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TDA7564BPD | 功能描述:音頻放大器 4 x 50W Multi Quad Power Amplifer D RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TDA7564BPDTR | 功能描述:音頻放大器 4 x 50W Multi Quad Power Amplifer D RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。