- 您現在的位置：買賣IC網 > PDF目錄368629 > TDA8360 (NXP SEMICONDUCTORS) Integrated PAL and PAL/NTSC TV processors(集成PAL和PAL/NTSC TV處理器) PDF資料下載
參數資料
| 型號： | TDA8360 |
| 廠商： | NXP SEMICONDUCTORS |
| 元件分類： | 消費家電 |
| 英文描述： | Integrated PAL and PAL/NTSC TV processors(集成PAL和PAL/NTSC TV處理器) |
| 中文描述： | SPECIALTY CONSUMER CIRCUIT, PDIP52 |
| 封裝： | SHRINK, PLASTIC, SOT-247AG, DIP-52 |
| 文件頁數： | 24/36頁 |
| 文件大?。?/td> | 200K |
| 代理商： | TDA8360 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁當前第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁
March 1994
24
Philips Semiconductors
Objective specification
Integrated PAL and PAL/NTSC TV
processors
TDA8360; TDA8361; TDA8362
11. Measured with a source impedance of 75
, where:
12. To obtain a good noise immunity of the AGC circuit the AGC detector is gated during the sync pulse. This gating is
switched off during the vertical retrace to avoid disturbances of the signal amplitude due to phase errors of the
incoming video signal which are caused by the head-switching of VCRs.
13. When the leakage current of the capacitor exceeds this value it will result in a reduced performance of the AGC
(amplitude variation during line or frame) but it will not result in a hang-up situation.
14. The AFC slope is directly related to the Q-factor of the demodulator tuned circuit. The given AFC steepness is
obtained with a Q-factor of 60. When a lower steepness is required this can be obtained by connecting an external
resistor to the AFC output (the output impedance is 50 k
). The AFC off-set is tested with a double sideband input
signal and with the reference tuned circuit tuned to minimum AGC voltage (optimum tuning for the demodulator).
15. For positive modulated signals the FM sound demodulator for the sound is not required. This is because the sound
signal is amplitude modulated. Therefore the TDA8362 can be switched to positive modulation via the de-emphasis
pin (pin 1). When switched to positive modulation the audio switch is set to ‘external’ so that the demodulated audio
signal can be supplied to the input. The option between AM sound and SCART audio signals is achieved by means
of an external switch.
16. The sound IF input is combined with the AF volume control. The IF signal is internally AC coupled to the limiter
amplifier. The volume control voltage must be supplied to this pin via a resistor.
17. V
I
= 100 mV RMS; FM: 1 kHz,
f =
±
50 kHz.
18. V
I
= 50 mV RMS, f = 4.5/5.5 MHz;
FM: 70 Hz
±
50 kHz deviation
AM: 1 kHz at 30% modulation.
19. V
I
= 100 mV RMS, 5.5 MHz; FM: 1 kHz,
±
17.5 kHz deviation; 15 kHz bandwidth; audio attenuator at
6 dB.
20. Audio attenuator at
20 dB; temperature range 10 to 50
°
C.
21. In the TDA8361 and TDA8362 the audio and CVBS switches are controlled via the chrominance input pin.
Table 1 lists the various possibilities.
When the DC voltage has a value between 3 and 5 V the switches are set to the S-VHS position. The chrominance
trap is then switched off and separate Y and chrominance signals have to be applied to the inputs (the audio switch
is set to external in this condition). The audio switch is also set to external when the IF amplifier is switched to positive
modulation (see also note 15).
22. Signal with negative-going sync. Amplitude includes sync pulse amplitude.
23. This parameter is measured at nominal settings of the various control voltages.
24. Burst amplitude; for a colour bar with 75% saturation the chrominance signal amplitude is 660 mV (p-p).
25. Nominal contrast is specified as maximum contrast
3 dB. Nominal saturation as maximum
12 dB. The nominal
brightness control voltage is 2.5 V.
26. When the data blanking input pulse exceeds a level of 4 V the RGB outputs are blanked. In this condition it is possible
to supply ‘On-Screen-Display’ signals to the outputs. This blanking overrules both the internal and external
RGB signals.
27. The
3 dB bandwidth of the circuit can be calculated by means of the following equation:
2Q
S/N = 20 log
V
(black-to-white)
V
m rms
)
B = 5 MHz
(
)
---------------------------------------------------------
f
3 dB
–
f
osc
1
-1
–
=
相關PDF資料 |
PDF描述 |
|---|---|
| TDA8417 | TV and VTR stereo/dual sound processor with integrated filters and IIC-bus control(帶IIC總線控制和集成濾波器的的 TV和VTR立體聲/雙聲道處理器) |
| TDA8425 | Hi-Fi stereo audio processor;IIC-bus(IIC總線 高保真立體聲音頻處理器) |
| TDA8559T | Low-voltage stereo headphone amplifier |
| TDA8559 | Low-voltage stereo headphone amplifier |
| TDA8561 | 2 x 24 W BTL or 4 x 12 W single-ended car radio power amplifier |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TDA8361 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Integrated PAL and PAL/NTSC TV processors |
| TDA8362 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Integrated PAL and PAL/NTSC TV processors |
| TDA8366 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:I2C-bus controlled PAL/NTSC TV processor |
| TDA8366H | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:I2C-bus controlled PAL/NTSC TV processor |
| TDA8370 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Synchronization processor for television receivers |
發布緊急采購，3分鐘左右您將得到回復。