參數資料
型號: TDA8559
廠商: NXP Semiconductors N.V.
元件分類: 音頻放大器
英文描述: Low-voltage stereo headphone amplifier
中文描述: 低電壓立體聲耳機放大器
文件頁數: 5/32頁
文件大?。?/td> 264K
代理商: TDA8559
1997 Jun 27
5
Philips Semiconductors
Product specification
Low-voltage stereo headphone amplifier
TDA8559
Output amplifiers
The output amplifiers have a transresistance of 50 k
, a
bandwidth of approximately 750 kHz and a maximum
output current of 100 mA. The mid-tap output voltage
equals the voltage applied at the non-inverting pin of the
output amplifier. This pin is connected to the output of the
0.5V
P
buffer. This reduces the distortion when the load is
connected between an output amplifier and the buffer
(because feedback is applied over the load).
Buffer
The buffer delivers 0.5V
P
to the output with a maximum
output (sink and source) current of 200 mA (peak).
Dynamic quiescent controller
The Dynamic Quiescent Current controller (DQC) gives
the advantage of low quiescent current and low distortion.
When there are high frequencies in the output signal, the
DQC will increase the quiescent current of the two output
amplifiers and the buffer. This will reduce the cross-over
distortion that normally occurs at high frequencies and low
quiescent current. The DQC gives output currents that are
linear with the amplitude and the frequency of the output
signals. These currents control the quiescent current.
Stabilizer
The TDA8559 has a voltage supply range from
1.9 to 30 V. This range is divided over two supply voltage
pins. Pin 16 is 1.9 to 18 V (breakdown voltage of the
process); this pin is preferred for supply voltages less than
18 V. Pin 15 is used for applications where V
P
is
approximately 6 to 30 V. The stabilizer output is internally
connected to the supply voltage pin 16. In the range from
6 to 18 V, the voltage drop to pin 16 is 1 V. In the range
from 18 to 30 V the stabilizer output voltage (to pin 16) is
approximately 17 V.
Input logic
The MUTE pin (pin 7) selects the mute mode of the V/I
converters. LOW (TTL/CMOS) level is mute. A voltage
between 0.5 V (low level) and 1.5 V (high level) causes a
soft mute to operate (no plops). When pin 7 is floating or
greater than 1.5 V it is in the operating condition.
The input mode pin must be connected to V
P
when the
supply voltage is greater than 6 V. The input mode logic
raises the tail current of the V/I converters and enables the
two buffers to bias the inputs of the V/I converters.
Reference
This circuit supplies all currents needed in this device. With
the standby mode pin 1 (TTL/CMOS), it is possible to
switch to the standby mode and reduce the total quiescent
current to below 10
μ
A.
相關PDF資料
PDF描述
TDA8561 2 x 24 W BTL or 4 x 12 W single-ended car radio power amplifier
TDA8563Q 2 x 40 W/2 ohm stereo BTL car radio power amplifier with diagnostic facility
TDA8564Q 2 x 24 W BTL or 4 x 12 W single-ended car radio power amplifier
TDA8567 4 x 25 W BTL quad car radio power amplifier
TDA8568Q 4x25 W BTL quad car radio power amplifier(4x25 W BTL雙路車載電臺功率放大器)
相關代理商/技術參數
參數描述
TDA8559T 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Low-voltage stereo headphone amplifier
TDA8559T/N1 制造商:NXP Semiconductors 功能描述:AMP STEREO HEADPHONE SMD SO-16
TDA8559T/N1,512 功能描述:音頻放大器 HEADPHONE AMP LV RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel
TDA8559T/N1,518 功能描述:音頻放大器 LOW VOLTAGE STEREO HEADPHN AMP RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel
TDA8559TD 功能描述:音頻放大器 HEADPHONE AMP LV RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel