參數資料
型號： TDA8588J
廠商： NXP SEMICONDUCTORS
元件分類： 消費家電
英文描述： I2C-bus controlled 4 x 50 Watt power amplifier and multiple voltage regulator
中文描述： SPECIALTY CONSUMER CIRCUIT, PZFM37
封裝： PLASTIC, SOT725-1, 37 PIN
文件頁數： 10/54頁
文件大?。?/td> 283K
代理商： TDA8588J
2004 Feb 24
10
Philips Semiconductors
Product specification
I
2
C-bus controlled 4
×
50 Watt power
amplifier and multiple voltage regulator
TDA8588J; TDA8588xJ
2.
After 250 ms the DC load is detected and the mute is
released. This is inaudible and can be implemented
each time the IC is powered on.
When the amplifier start-up cycle is completed (after
1.5 s), apply an AC signal to the input, and DC-load
bits D5 of each data byte should be read and stored by
the microcontroller.
After at least 3 periods of the input signal, the load
status can be checked by reading AC-detect bits D4 of
each data byte.
The AC-load peak current counter can be reset by
settingbit D1 of instruction byte IB1to logic 0and then
to logic 1. Note that this will also reset the DC-load
detection bits D5 in each data byte.
3.
4.
Low headroom protection
The normal DC output voltage of the amplifier is set to half
the supply voltage and is related to the voltage on
pin SVR. An external capacitor is connected to pin SVR to
suppress power supply ripple. If the supply voltage drops
(at vehicle engine start), the DC output voltage will follow
slowly due to the affect of the SVR capacitor.
The headroom voltage is the voltage required for correct
operation of the amplifier and is defined as the voltage
difference between the level of the DC output voltage
before the V
P
voltage drop and the level of V
P
after the
voltage drop (see Fig.4).
At a certain supply voltage drop, the headroom voltage will
be insufficient for correct operation of the amplifier. To
prevent unwanted audible noises at the output, the
headroom protection mode will be activated (see Fig.4).
This protection discharges the capacitors connected to
pins SVR and ACGND to increase the headroom voltage.
V
(V)
t (sec)
SVR voltage
vehicle engine start
headroom voltage
amplifier
DC output voltage
V
P
mdb515
14
8.4
7
Fig.4 Amplifier output during supply voltage.
相關PDF資料
PDF描述
TDA8722M I2C-bus programmable modulator for negative video modulation and FM sound
TDA8722 IIC-bus programmable modulator for negative video modulation and FM sound(負向視頻調制和調頻聲的IIC總線可編程調制器)
TDA8722T I2C-bus programmable modulator for negative video modulation and FM sound
TDA8725T Antenna signal processor
TDA8730 PLL FM demodulator for DBS signals
相關代理商/技術參數
參數描述
TDA8588J/N3 功能描述:音頻放大器 MULTI CHIP MODULE IPAS2.50 RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel
TDA8588J/N3,112 功能描述:音頻放大器 MULTI CHIP MODULE RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel
TDA8589AJ 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:I2C-bus controlled 4 45 Watt power amplifier and multiple voltage regulator
TDA8589AJ/N3 功能描述:音頻放大器 POWER AMPL + STABI RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel
TDA8589AJ/N3,112 功能描述:音頻放大器 POWER AMPL + STABI RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*