參數資料
型號: TDA9806
廠商: NXP SEMICONDUCTORS
元件分類: 接收器
英文描述: Multistandard VIF-PLL and FM-PLL demodulator
中文描述: FM, VIDEO DISCRIMINATOR, PDIP32
封裝: 0.400 INCH, SHRINK, PLASTIC, SOT-232-1, DIP-32
文件頁數: 15/24頁
文件大小: 193K
代理商: TDA9806
1995 Sep 05
15
Philips Semiconductors
Preliminary specification
Multistandard VIF-PLL and
FM-PLL demodulator
TDA9806
Notes
1.
2.
Values of video and sound parameters are decreased at V
P
= 4.5 V.
This parameter is not tested during production and is only given as application information for designing the
television receiver.
Loop bandwidth BL = 60 kHz (natural frequency f
n
= 15 kHz; damping factor d = 2; calculated with sync level within
gain control range). Resonance circuit of VCO: Q
0
> 50; C
ext
= 8.2 pF
±
0.25 pF; C
int
8.5 pF (loop voltage
approximately 2.7 V).
Temperature coefficient of external LC-circuit is equal to zero.
V
i IF
= 10 mV (RMS);
f = 1 MHz (VCO frequency offset related to picture carrier frequency); white picture
video modulation.
V
i IF
signal for nominal video signal.
Offset current measured between pin 7 and half of supply voltage (V
P
= 2.5 V) under the following conditions: no
input signal at VIF input (pins 1 and 2) and VIF amplifier gain at minimum (V
28
= V
P
).
Measurements taken with SAW filter G1962 (sound shelf: 20 dB); loop bandwidth BL = 60 kHz:
a) modulation VSB; sound carrier
off
; f
video
> 0.5 MHz.
b) sound carrier
on
; f
video
= 10 kHz to 10 MHz.
The 7 dB buffer gain accounts for 1 dB loss in the sound trap. Buffer output signal is typical 2 V (p-p), in event of
CVBS video amplifier output typical 1 V (p-p). If no sound trap is applied a 330
resistor must be connected from
output to input (from pin 21 to pin 22).
10. The leakage current of the AGC capacitor should not exceed 1
μ
A at B/G standard. Larger currents will increase
the tilt.
11. S/N is the ratio of black-to-white amplitude to the black level noise voltage (RMS value, pin 10). B = 5 MHz weighted
in accordance with “CCIR 567”
3.
4.
5.
6.
7.
8.
9.
12. The intermodulation figures are defined:
V
at 4.4 MHz
V
0
at 1.1 MHz
V
at 4.4 MHz
V
0
at 3.3 MHz
;
α
1.1
value at 1.1 MHz referenced to black/white signal;
;
α
3.3
value at 3.3 MHz referenced to colour carrier.
13. Response speed valid for a VIF input level range of 200
μ
V up to 70 mV.
AF performance for FM operation (B/G standard);
notes 20, 21 and 22; see Table 1
S/N (W)
weighted signal-to-noise ratio
PC/SC ratio at pins 1 and 2;
27 kHz (54% FM
deviation); “CCIR 468-4”
black picture
white picture
6 kHz sine wave (black to
white modulation)
sound carrier
subharmonics;
f = 2.75 MHz
±
3 kHz
27
dB
45
45
40
51
51
46
dB
dB
dB
35
40
dB
SYMBOL
PARAMETER
CONDITIONS
MIN.
TYP.
MAX.
UNIT
α
1.1
20
-------------------------------------
3.6dB
+
log
=
α
3.3
20
-------------------------------------
log
=
相關PDF資料
PDF描述
TDA9808 Single standard VIF-PLL with QSS-IF and FM-PLL demodulator
TDA9808T Single standard VIF-PLL with QSS-IF and FM-PLL demodulator
TDA9809 Single standard multimedia IF-PLL and FM radio demodulator
TDA9809M Single standard multimedia IF-PLL and FM radio demodulator
TDA9810 Multistandard VIF-PLL with QSS-IF and AM demodulator
相關代理商/技術參數
參數描述
TDA9808 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Single standard VIF-PLL with QSS-IF and FM-PLL demodulator
TDA9808T 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Single standard VIF-PLL with QSS-IF and FM-PLL demodulator
TDA9809 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Single standard multimedia IF-PLL and FM radio demodulator
TDA9809M 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Single standard multimedia IF-PLL and FM radio demodulator
TDA9809M/V1,112 功能描述:射頻無線雜項 MULTIMEDIA IF PLL RoHS:否 制造商:Texas Instruments 工作頻率:112 kHz to 205 kHz 電源電壓-最大:3.6 V 電源電壓-最小:3 V 電源電流:8 mA 最大功率耗散: 工作溫度范圍:- 40 C to + 110 C 封裝 / 箱體:VQFN-48 封裝:Reel