- 您現在的位置：買賣IC網 > PDF目錄371185 > TH8055 Single Wire CAN Transceiver PDF資料下載
參數資料
| 型號： | TH8055 |
| 元件分類： | CAN |
| 英文描述： | Single Wire CAN Transceiver |
| 中文描述： | 單線CAN收發器 |
| 文件頁數： | 3/15頁 |
| 文件大?。?/td> | 266K |
| 代理商： | TH8055 |
第1頁第2頁當前第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁
T H8055
Single Wire CAN Transceiver
390108055
Rev. 1.1a
Page 3 of 15
Jan 2002
Func tional Desc ription
T xD Input Pin
- Logic command to transmit on the single wire CAN bus as follows:
TxD Polarity
TxD = logic 1 (or floating) on this pin produce an
undriven or recessive bus state (low bus
voltage)
TxD = logic 0 on this pin produce either a bus
normal or a bus high voltage dominant state
depending on the transceiver mode state (high
bus voltage)
If the TxD pin is driven to a logic low state while the
sleep mode (Mode0=0 and Mode1=0) is activated,
the transceiver not drive the CANH pin to the
dominant state.
Mode 0 and Mode 1 pins
- are used to select transceiver operating modes:
The transceiver provides a weak internal pull down
current on each of these pins which causes the
transceiver to default to sleep mode when they are
not driven. The mode input signals are standard
CMOS logic level.
M0
The transceiver provides an internal pull up current
on the TxD pin which will cause the transmitter to
default to the bus recessive state when TxD is not
driven.
TxD input signals are standard CMOS logic levels.
Timeout Feature
In case of a faulty blocked dominant TxD input
signal the CANH output is switched off automatically
after the specified TxD timeout reaction time to
prevent a dominant bus.
The transmission is continued by next TxD L to H
transition without delay.
M1
Mode
L
L
Sleep mode
H
L
High speed mode
L
H
Wake up
H
H
Normal mode
Sleep Mode
Transceiver is in low power state, waiting for wake
up via high voltage signal or by mode pins change to
any state other than 0,0. In this state, the CANH pin
is not in the dominant state regardless of the state of
the TxD pin.
High Speed Mode
This mode allows high speed download with bitrates
up to 100Kbit/s. The output waveshaping circuit is
disabled in this mode. Bus transmitter drive circuits
for those nodes which are required to communicate
in high speed mode are able to drive reduced bus
resistance
in
this
mode
(see
Table
Static
Characteristics). High speed communications shall
utilize the normal mode signal voltage levels as
specified in Static Characteristics.
Wake Up Mode
This bus includes a selective node awake capability,
which allows normal communication to take place
among some nodes while leaving the other nodes in
an undisturbed sleep state. This is accomplished by
controlling the signal voltages such that all nodes
must wake up when they receive a higher voltage
message signal waveform. The communication
system communicates to the nodes information as to
which nodes are to stay operational (awake) and
which nodes are to put themselves into a non
communicating
low
power
Communication at the lower, normal voltage levels
shall not disturb the sleeping nodes.
Normal mode
Transmission bit rate in normal communication is 33
Kbits/s. In normal transmission mode the TH8055
supports controlled waveform rise and overshoot
times. Waveform trailing edge control is required to
assure that high frequency components are
minimized at the beginning of the downward voltage
slope. The remaining fall time occurs after the bus
is inactive with drivers off and is determined by the
RC time constant of the total bus load.
“sleep”
state.
相關PDF資料 |
PDF描述 |
|---|---|
| THS3112 | LOW-NOISE, HIGH-SPEED CURRENT FEEDBACK AMPLIFIERS |
| THS3115 | LOW-NOISE, HIGH-SPEED CURRENT FEEDBACK AMPLIFIERS |
| THV-50 | Two-Way Power Dividers 2 - 200 MHz and 20 - 400 MHz |
| THV-50BNC | Two-Way Power Dividers 2 - 200 MHz and 20 - 400 MHz |
| THV-50N | Two-Way Power Dividers 2 - 200 MHz and 20 - 400 MHz |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TH8055JDC | 功能描述:IC TXRX SINGLE WIRE CAN 8-SOIC RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:1,140 系列:AU 類型:收發器 驅動器/接收器數:1/1 規程:CAN 電源電壓:5.3 V ~ 27 V 安裝類型:表面貼裝 封裝/外殼:14-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:14-SO 包裝:管件 其它名稱:935267940512AU5790D14AU5790D14-ND |
| TH8056 | 制造商:MELEXIS 制造商全稱:Melexis Microelectronic Systems 功能描述:Enhanced Single Wire CAN Transceiver |
| TH8056KDCA | 制造商:MELEXIS 制造商全稱:Melexis Microelectronic Systems 功能描述:Enhanced Single Wire CAN Transceiver |
| TH8056KDCA8 | 制造商:MELEXIS 制造商全稱:Melexis Microelectronic Systems 功能描述:Enhanced Single Wire CAN Transceiver |
| TH8056KDC-AAA-008-RE | 功能描述:TXRX SINGLE WIRE CAN 8SOIC RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:98 系列:* |
發布緊急采購，3分鐘左右您將得到回復。