參數資料
型號: THS1050CPHP
廠商: TEXAS INSTRUMENTS INC
元件分類: ADC
英文描述: 1-CH 10-BIT DELTA-SIGMA ADC, PARALLEL ACCESS, PQFP48
封裝: POWER, PLASTIC, TQFP-48
文件頁數: 8/21頁
文件大?。?/td> 424K
代理商: THS1050CPHP
THS1050
10-BIT 50 MSPS IF SAMPLING COMMUNICATIONS
ANALOG-TO-DIGITAL CONVERTER
SLAS278A – APRIL 2000 – REVISED MARCH 2001
16
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
APPLICATION INFORMATION
using the analog input
The THS1050 obtains optimum performance when the analog signal inputs are driven differentially. The circuit
below shows the optimum configuration, see Figure 22. The signal is fed to the primary of an RF transformer.
Since the input signal must be biased around the common mode voltage of the internal circuitry, the common
mode (VCM) reference from the THS1050 is connected to the center-tap of the secondary. To ensure a steady
low noise VCM reference, the best performance is obtained when the VCM output is connected to ground with
a 0.1-
F and 0.01-F low inductance capacitor.
R
VIN+
VCM
THS1050
0.01
F
0.1
F
Z0 = 50
1:1
VIN–
50
ac Signal Source
T1-1T
R0
50
Figure 22. Driving the THS1050 Analog Input With Impedance Matched Transmission Line
When it is necessary to buffer or apply a gain to the incoming analog signal, it is also possible to combine a
single-ended amplifier with an RF transformer as shown in Figure 23. For this application, a wide-band current
mode feedback amplifier such as the THS3001 is best. The noninverting input to the op-amps is terminated with
a resistor having an impedance equal to the characteristic impedance of the wave-guide or trace that sources
the IF input signal. The single ended output allows the use of standard passive filters between the amplifier
output and the primary. In this case, the SFDR of the op amp is not as critical as that of the A/D converter. While
harmonics generated from within the A/D converter fold back into the first Nyquist zone, harmonics generated
externally in the op amps can be filtered out with passive filters.
VIN+
VIN–
VCM
THS1050
0.1
F
0.01
F
_
+
BPF
10
1 k
1 k
RT
IF Input
THS3001
Impedance Ratio = 1:n
Figure 23. IF Input Buffered With THS3001 Op-Amp
相關PDF資料
PDF描述
THS1050IPHP 1-CH 10-BIT DELTA-SIGMA ADC, PARALLEL ACCESS, PQFP48
THS1050C 1-CH 10-BIT DELTA-SIGMA ADC, PARALLEL ACCESS, PQFP48
THS1050I 1-CH 10-BIT DELTA-SIGMA ADC, PARALLEL ACCESS, PQFP48
THS1060CPHP 1-CH 10-BIT DELTA-SIGMA ADC, PARALLEL ACCESS, PQFP48
THS1060IPHP 1-CH 10-BIT DELTA-SIGMA ADC, PARALLEL ACCESS, PQFP48
相關代理商/技術參數
參數描述
THS1050I 制造商:TI 制造商全稱:Texas Instruments 功能描述:10-BIT 50 MSPS IF SAMPLING COMMUNICATIONS ANALOG-TO-DIGITAL CONVERTER
THS1050IPHP 制造商:Rochester Electronics LLC 功能描述:- Bulk
THS1050PHP 制造商:TI 制造商全稱:Texas Instruments 功能描述:10-BIT 50 MSPS IF SAMPLING COMMUNICATIONS ANALOG-TO-DIGITAL CONVERTER
THS1050RJ 功能描述:線繞電阻器 - 底架安裝 50 Ohms 10W 50PPM RoHS:否 制造商:Vishay/Dale 電阻:7 Ohms 容差:1 % 功率額定值:100 W 溫度系數:50 PPM / C 系列:RH 工作溫度范圍:- 55 C to + 250 C 尺寸:46.02 mm Dia. x 46.02 mm W x 88.9 mm L x 44.45 mm H 封裝:Bulk 產品:Power Resistors Wirewound Aluminum Housed
THS10-516R-D 制造商:Thomas & Betts 功能描述:CATAMOUNT CABLE TIES