- 您現在的位置：買賣IC網 > PDF目錄385925 > THS5671AIDWRG4 (Texas Instruments, Inc.) 14-BIT, 125 MSPS, CommsDAC DIGITAL-TO-ANALOG CONVERTER PDF資料下載
參數資料
| 型號： | THS5671AIDWRG4 |
| 廠商： | Texas Instruments, Inc. |
| 英文描述： | 14-BIT, 125 MSPS, CommsDAC DIGITAL-TO-ANALOG CONVERTER |
| 中文描述： | 14位，125 MSPS的，CommsDAC數字模擬轉換器 |
| 文件頁數： | 19/31頁 |
| 文件大?。?/td> | 822K |
| 代理商： | THS5671AIDWRG4 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁當前第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁
THS5671A
14-BIT 125 MSPS, CommsDAC
DIGITAL-TO-ANALOG CONVERTER
SLAS201A
–
DECEMBER 1999
–
REVISED SEPTEMBER 2002
19
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
APPLICATION INFORMATION
analog current outputs
Figure 32 shows a simplified schematic of the current source array output with corresponding switches.
Differential PMOS switches direct the current of each individual PMOS current source to either the positive
output node IOUT1 or its complementary negative output node IOUT2. The output impedance is determined
by the stack of the current sources and differential switches, and is typically >300 k
in parallel with an output
capacitance of 5 pF.
Output nodes IOUT1 and IOUT2 have a negative compliance voltage of
–
1 V, determined by the CMOS process.
Beyond this value, transistor breakdown may occur, resulting in reduced reliability of the THS5671A device. The
positive output compliance depends on the full-scale output current IOUT
FS
and positive supply voltage AV
DD
.
The positive output compliance equals 1.25 V for AV
DD
= 5 V and IOUT
FS
= 20 mA. Exceeding the positive
compliance voltage adversely affects distortion performance and integral nonlinearity. The optimum distortion
performance for a single-ended or differential output is achieved when the maximum full-scale signal at IOUT1
and IOUT2 does not exceed 0.5 V (e.g. when applying a 50
doubly terminated load for 20 mA full-scale output
current). Applications requiring the THS5671A output (i.e., OUT1 and/or OUT2) to extend its output compliance
should size R
LOAD
accordingly.
AVDD
Current Source Array
IOUT1
IOUT2
RLOAD
RLOAD
Current
Sources
Switches
Figure 32. Equivalent Analog Current Output
Figure 33(a) shows the typical differential output configuration with two external matched resistor loads. The
nominal resistor load of 50
will give a differential output swing of 2 V
PP
when applying a 20 mA full-scale output
current. The output impedance of the THS5671A depends slightly on the output voltage at nodes IOUT1 and
IOUT2. Consequently, for optimum dc integral nonlinearity, the configuration of Figure 33(b) should be chosen.
In this I
–
V configuration, terminal IOUT1 is kept at virtual ground by the inverting operational amplifier. The
complementary output should be connected to ground to provide a dc current path for the current sources
switched to IOUT2. Note that the INL/DNL specifications for the THS5671A are measured with IOUT1
maintained at virtual ground. The amplifier
’
s maximum output swing and the DAC
’
s full-scale output current
determine the value of the feedback resistor R
FB
. Capacitor C
FB
filters the steep edges of the THS5671A current
output, thereby reducing the operational amplifier slew-rate requirements. In this configuration, the op amp
should operate on a dual supply voltage due to its positive and negative output swing. Node IOUT1 should be
selected if a single-ended unipolar output is desirable.
相關PDF資料 |
PDF描述 |
|---|---|
| THS7001EVM | THS7001 Programmable-Gain Amplifier Evaluation Module(THS7001可編程增益放大器評估板) |
| THS7001PWP | 70-MHz PROGRAMMABLE-GAIN AMPLIFIERS |
| THS7002EVM | 70-MHz PROGRAMMABLE-GAIN AMPLIFIERS |
| THS7002PWP | 70-MHz PROGRAMMABLE-GAIN AMPLIFIERS |
| THS8133ATQFP | TRIPLE 10-BIT, 80 MSPS VIDEO D/A CONVERTER WITH TRI-LEVEL SYNC GENERATION |
相關代理商/技術參數 |
參數描述 |
|---|---|
| THS5671AIPW | 功能描述:數模轉換器- DAC 14-Bit 125 MSPS CommsDAC RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
| THS5671AIPW | 制造商:Texas Instruments 功能描述:IC 14-BIT 125 MSPS D/A 28-TSSOP |
| THS5671AIPWG4 | 功能描述:數模轉換器- DAC 14-Bit 125 MSPS CommsDAC RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
| THS5671AIPWR | 功能描述:數模轉換器- DAC 14-Bit 125 MSPS CommsDAC RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
| THS5671AIPWRG4 | 功能描述:數模轉換器- DAC 14-Bit 125 MSPS CommsDAC RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。