- 您現在的位置：買賣IC網 > PDF目錄98229 > THS7360IPWR (TEXAS INSTRUMENTS INC) VIDEO AMPLIFIER, PDSO20 PDF資料下載
參數資料
| 型號： | THS7360IPWR |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 音頻／視頻放大 |
| 英文描述： | VIDEO AMPLIFIER, PDSO20 |
| 封裝： | GREEN, PLASTIC, TSSOP-20 |
| 文件頁數： | 22/43頁 |
| 文件大小： | 962K |
| 代理商： | THS7360IPWR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁當前第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁
www.ti.com
SLOS674 – JUNE 2010
filter channels. One way to help ensure this condition
In the same way as the dc output mode of operation
is satisfied is to make sure the 75-
source resistor is
discussed previously, each line should have a 75-
placed within 0.5-inches to each THS7360 output pin.
source
termination
resistor
in
series
with
the
If a large ac-coupling capacitor is used, the capacitor
ac-coupling capacitor. This 75-
resistor should be
should be placed after this resistor.
placed next to the THS7360 output to minimize
capacitive loading effects. If two lines are to be
There are many reasons dc-coupling is desirable,
driven, it is best to have each line use its own
including reduced costs, PCB area, and no line tilt. A
capacitor and resistor rather than sharing these
common question is whether or not there are any
components.
This
configuration
helps
ensure
drawbacks to using dc-coupling. There are some
line-to-line dc isolation and eliminates the potential
potential issues that must be examined, such as the
problems as described previously. Using a single,
dc current bias as discussed above. Another potential
1000-mF capacitor for two lines is permissible, but
risk is whether this configuration meets industry
there is a chance for interference between the two
standards.
EIA/CEA-770
stipulates
that
the
receivers.
back-porch shall be 0 V ± 1 V as measured at the
receiver. With a double-terminated load system, this
Lastly, because of the edge rates and frequencies of
requirement implies a 0-V ± 2-V level at the video
operation, it is recommended (but not required) to
amplifier output. The THS7360 can easily meet this
place a 0.1-mF to 0.01-mF capacitor in parallel with
requirement without issue. However, in Japan, the
the large 220-mF to 1000-mF capacitor. These large
EIAJ CP-1203 specification stipulates a 0-V ± 0.1-V
value capacitors are most commonly aluminum
level with no signal. This requirement can be met with
electrolytic. It is well-known that these capacitors
the THS7360 in shutdown mode, but while active it
have significantly large equivalent series resistance
cannot
meet
this
specification
without
output
(ESR), and the impedance at high frequencies is
ac-coupling.
AC-coupling
the
output
essentially
rather large as a result of the associated inductances
ensures that the video signal works with any system
involved with the leads and construction. The small
and any specification. For many modern systems,
0.1-mF
to
0.01-mF
capacitors
help
pass
these
however, dc-coupling can satisfy most needs.
high-frequency signals (greater than 1 MHz) with
much lower impedance than the large capacitors.
OUTPUT MODE OF OPERATION:
Although it is common to use the same capacitor
AC-COUPLED
values for all the video lines, the frequency bandwidth
of the chroma signal in a S-Video system is not
A very common method of coupling the video signal
required to go as low (or as high of a frequency) as
to the line is with a large capacitor. This capacitor is
the luma channels. Thus, the capacitor values of the
typically between 220 mF and 1000 mF, although
chroma line(s) can be smaller, such as 0.1 mF.
470 mF is very typical. The value of this capacitor
must be large enough to minimize the line tilt (droop)
Figure 48 shows a typical configuration where the
and/or
field
tilt
associated
with
ac-coupling
as
input is ac-coupled and the output is also ac-coupled.
described previously in this document. AC-coupling is
AC-coupled inputs are generally required when
performed for several reasons, but the most common
current-sink DACs are used or the input is connected
is to ensure full interoperability with the receiving
to an unknown source, such as when the THS7360 is
video system. This approach ensures that regardless
used as an input device.
of the reference dc voltage used on the transmitting
side,
the
receiving
side
re-establishes
the
dc
reference voltage to its own requirements.
Copyright 2010, Texas Instruments Incorporated
29
Product Folder Link(s): THS7360
相關PDF資料 |
PDF描述 |
|---|---|
| THS7360IPW | VIDEO AMPLIFIER, PDSO20 |
| THS7364IPWR | 6 CHANNEL, VIDEO AMPLIFIER, PDSO20 |
| THS7364IPW | 6 CHANNEL, VIDEO AMPLIFIER, PDSO20 |
| THS7365IPWR | 6 CHANNEL, VIDEO AMPLIFIER, PDSO20 |
| THS7365IPW | 6 CHANNEL, VIDEO AMPLIFIER, PDSO20 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| THS7364 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:6-Channel Video Amplifier with 3 SD and 3 Full-HD Filters with 6-dB Gain |
| THS7364_10 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:6-Channel Video Amplifier with 3 SD and 3 Full-HD Filters with 6-dB Gain |
| THS7364EVM | 功能描述:放大器 IC 開發工具 THS7364 Eval Mod RoHS:否 制造商:International Rectifier 產品:Demonstration Boards 類型:Power Amplifiers 工具用于評估:IR4302 工作電源電壓:13 V to 23 V |
| THS7364IPW | 功能描述:視頻放大器 6-Ch Video Amp RoHS:否 制造商:ON Semiconductor 通道數量:4 電源類型: 工作電源電壓:3.3 V, 5 V 電源電流: 最小工作溫度: 最大工作溫度: 封裝 / 箱體:TSSOP-14 封裝:Reel |
| THS7364IPWR | 功能描述:視頻放大器 6-Ch Video Amp RoHS:否 制造商:ON Semiconductor 通道數量:4 電源類型: 工作電源電壓:3.3 V, 5 V 電源電流: 最小工作溫度: 最大工作溫度: 封裝 / 箱體:TSSOP-14 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。