- 您現在的位置：買賣IC網 > PDF目錄383948 > TISP61511D-S (BOURNS INC) DUAL FORWARD-CONDUCTING P-GATE THYRISTORS PROGRAMMABLE OVERVOLTAGE PROTECTORS PDF資料下載
參數資料
| 型號： | TISP61511D-S |
| 廠商： | BOURNS INC |
| 元件分類： | 保護電路 |
| 英文描述： | DUAL FORWARD-CONDUCTING P-GATE THYRISTORS PROGRAMMABLE OVERVOLTAGE PROTECTORS |
| 中文描述： | TELECOM, SURGE PROTECTION CIRCUIT, PDSO8 |
| 封裝： | ROHS COMPLIANT, SOP-8 |
| 文件頁數： | 7/9頁 |
| 文件大?。?/td> | 360K |
| 代理商： | TISP61511D-S |
JULY 1995 — REVISED MARCH 2006
Specifications are subject to change without notice.
Customers should verify actual device performance in their specific applications.
TISP61511D Gated Protectors
APPLICATIONS INFORMATION
Electrical Characteristics
The electrical characteristics of a thyristor overvoltage protector are strongly dependent on junction temperature, T
J
. Hence a characteristic
value will depend on the junction temperature at the instant of measurement. The values given in this data sheet were measured on commercial
testers, which generally minimize the temperature rise caused by testing.
Application Circuit
Figure 3 shows a typical TISP61511D SLIC card protection circuit. The incoming line wires, R and T, connect to the relay matrix via the series
overcurrent protection. Fusible resistors, fuses and positive temperature coefficient (PTC) resistors can be used for overcurrent protection.
Resistors will reduce the prospective current from the surge generator for both the TISP61511D and the ring/test protector. The TISP7xxxF3
protector has the same protection voltage for any terminal pair. This protector is used when the ring generator configuration may be ground or
battery-backed. For dedicated ground-backed ringing generators, the TISP3xxxF3 gives better protection as its inter-wire protection voltage is
twice the wire to ground value.
Relay contacts 3a and 3b connect the line wires to the SLIC via the TISP61511D protector. The protector gate reference voltage comes from the
SLIC negative supply (V
BAT
). A 220 nF gate capacitor sources the high gate current pulses caused by fast rising impulses.
Impulse Conditions
Most lightning tests, used for equipment verification, specify a unidirectional sawtooth waveform which has an exponential rise and an
exponential decay. Wave shapes are classified in terms of Peak Amplitude (voltage or current), rise time and a decay time to 50 % of the
maximum amplitude. The notation used for the wave shape is amplitude, rise time/decay time A 38 A, 5/310
μ
s wave shape would have a
peak current value of 38 A, a rise time of 5
μ
s and a decay time of 310
μ
s.
There are three categories of surge generator type; single wave shape, combination wave shape and circuit defined. Single wave shape
generators have essentially the same waveshape for the open circuit voltage and short circuit current (e.g. 10/1000
μ
s open circuit voltage
and short circuit current). Combination generators have two wave shapes, one for the open circuit voltage and the other for the short circuit
current (e.g. 1.2/50
μ
s open circuit voltage and 8/20
μ
s short circuit current). Circuit specified generators usually equate to a combination
generator, although typically only the open circuit voltage waveshape is referenced (e.g. a 10/700
μ
s open circuit voltage generator typically
produces a 5/310
μ
s short circuit current). If the combination or circuit defined generators operate into a finite resistance the wave shape
produced is intermediate between the open circuit and short circuit values.
Figure 3. Typical Application Circuit
TEST
RELAY
RING
RELAY
SLIC
RELAY
TEST
EQUIP-
MENT
RING
GENERATOR
S1a
S1b
R1a
R1b
RING
WIRE
TIP
WIRE
Th1
Th2
Th3
Th4
Th5
SLIC
SLIC
PROTECTOR
RING/TEST
PROTECTION
OVER-
CURRENT
PROTECTION
S2a
S2b
TISP
61511D
TISP
3xxxF3
OR
7xxxF3
S3a
S3b
V
BAT
220 nF
AI6XAA
相關PDF資料 |
PDF描述 |
|---|---|
| TISP6151X | DUAL FORWARD-CONDUCTING P-GATE THYRISTORS PROGRAMMABLE OVERVOLTAGE PROTECTORS |
| TISP61521 | DUAL FORWARD-CONDUCTING P-GATE THYRISTORS PROGRAMMABLE OVERVOLTAGE PROTECTORS |
| TISP61521D | DUAL FORWARD-CONDUCTING P-GATE THYRISTORS PROGRAMMABLE OVERVOLTAGE PROTECTORS |
| TISP61521DR | DUAL FORWARD-CONDUCTING P-GATE THYRISTORS PROGRAMMABLE OVERVOLTAGE PROTECTORS |
| TISP61521DR-S | DUAL FORWARD-CONDUCTING P-GATE THYRISTORS PROGRAMMABLE OVERVOLTAGE PROTECTORS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TISP61512P | 功能描述:SCR RoHS:否 制造商:STMicroelectronics 最大轉折電流 IBO:480 A 額定重復關閉狀態電壓 VDRM:600 V 關閉狀態漏泄電流（在 VDRM IDRM 下）:5 uA 開啟狀態 RMS 電流 (It RMS): 正向電壓下降:1.6 V 柵觸發電壓 (Vgt):1.3 V 最大柵極峰值反向電壓:5 V 柵觸發電流 (Igt):35 mA 保持電流（Ih 最大值）:75 mA 安裝風格:Through Hole 封裝 / 箱體:TO-220 封裝:Tube |
| TISP61512PS | 制造商:Bourns Inc 功能描述: |
| TISP61512P-S | 功能描述:SCR RoHS:否 制造商:STMicroelectronics 最大轉折電流 IBO:480 A 額定重復關閉狀態電壓 VDRM:600 V 關閉狀態漏泄電流（在 VDRM IDRM 下）:5 uA 開啟狀態 RMS 電流 (It RMS): 正向電壓下降:1.6 V 柵觸發電壓 (Vgt):1.3 V 最大柵極峰值反向電壓:5 V 柵觸發電流 (Igt):35 mA 保持電流（Ih 最大值）:75 mA 安裝風格:Through Hole 封裝 / 箱體:TO-220 封裝:Tube |
| TISP6151X | 制造商:BOURNS 制造商全稱:Bourns Electronic Solutions 功能描述:DUAL FORWARD-CONDUCTING P-GATE THYRISTORS PROGRAMMABLE OVERVOLTAGE PROTECTORS |
| TISP61521 | 制造商:BOURNS 制造商全稱:Bourns Electronic Solutions 功能描述:DUAL FORWARD-CONDUCTING P-GATE THYRISTORS PROGRAMMABLE OVERVOLTAGE PROTECTORS |
發布緊急采購，3分鐘左右您將得到回復。