參數資料
型號: TLE6387GV60
廠商: INFINEON TECHNOLOGIES AG
元件分類: 穩壓器
英文描述: 1 A SWITCHING CONTROLLER, 430 kHz SWITCHING FREQ-MAX, PDSO14
封裝: PLASTIC, DSO-14
文件頁數: 6/24頁
文件大小: 264K
代理商: TLE6387GV60
TLE 6387 G
Target Datasheet Rev. 0.5
14
2001-08-27
results from its inevitable series resistance and the average load current
. In
order not to spoil the current mode signal this offset is slowly compensated using the
inherent inertia of the voltage loop. Please note, since the inputs of OTA
EA and OCACM
are internally connected, it is not possible to increase the output voltage by feeding back
only a fraction of the output voltage to pin 9 (FB). In fact , whenever the generated output
voltage differs from the voltage sensed at pin 9 (FB), a large DC offset is added to the
internal current mode signal, which cannot be compensated by OTA
CC and which
consequently will result in a clampled output voltage.
Protection Circuitry (only avaiable at version GV50)
To achieve a safe operation of the controller and its load connected, TLE 6387 G is
equipped with different protection circuitry. To warn loads supplied of temporary
undervoltages or overvoltages the output voltage is continuously supervised for
undervoltages or overvoltages. To prevent the undervoltage and overvoltage
comparators C
uv
and C
ov
from being triggered due to inevitable noise that is
superimposed on the voltage sensed at pin 9 (FB), both comparators are equipped with
a corresponding hysteresis as well as an input low pass filter. In case an undervoltage
or overvoltage has been detected, the reset signals at pin 6 (RST) and pin 7 (RST) are
set according to1. If the undervoltage or overvoltage has passed both signals are reset
after 21 ms. A corresponding timing diagram is given in 1 and 2.
In order to make sure the output voltage supervisor is working properly down to an output
voltage of 1 V regardless of the supply voltage at pin 2 (
V
S), its supply voltage is switched
between the internal voltage supply and the converters output voltage if necessary (cf.
“Internal Power Supply”).
To protect the converter and the driven power switch from destruction due to a short-
circuited output, the voltage drop across the power switch is checked cycle-by-cycle. If
this voltage drop exceeds 1.25 V, the driver is immediately shut off for the remaining part
of the respective cycle. As a result, the duty cycle is kept constant at a value as small as
possible.
In order to prevent the output voltage from high overvoltages, which may be caused by
a missing output capacitor or a broken connection between pin 9 (FB) and the output
capacitor, TLE 6387 G is equipped with a smart wirebreak protection, which shortly
checks the status of pin 9 (FB) whenever the controller is turned on.
V
FB
RST RST
Undervoltage
Z
L
Overvoltage
Z
L
Else
L
Z
Table 1 Reset Logic Truth Table
I
L
R
L
()
相關PDF資料
PDF描述
TLE6389-3GV50 2.3 A SWITCHING CONTROLLER, 420 kHz SWITCHING FREQ-MAX, PDSO14
TLE6389G50-1 SWITCHING CONTROLLER, 420 kHz SWITCHING FREQ-MAX, PDSO14
TLE6389GVT SWITCHING CONTROLLER, 420 kHz SWITCHING FREQ-MAX, PDSO14
TLE6711G 1-CHANNEL POWER SUPPLY MANAGEMENT CKT, PDSO14
TLE7209R STEPPER MOTOR CONTROLLER, PDSO20
相關代理商/技術參數
參數描述
TLE6389 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:Step - Down DC/DC Controller
TLE6389_07 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:Step-Down DC/DC Controller
TLE6389-2G V50 功能描述:DC/DC 開關控制器 Step-Dwn DC/DC CTRLR 5V RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
TLE63892GV 功能描述:DC/DC 開關控制器 DC/DC CONVERTER RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
TLE6389-2GV 功能描述:DC/DC 開關控制器 Step-Dwn DC/DC CTRLR RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK