參數資料
型號: TLV571IPWG4
廠商: TEXAS INSTRUMENTS INC
元件分類: ADC
英文描述: 1-CH 8-BIT SUCCESSIVE APPROXIMATION ADC, PARALLEL ACCESS, PDSO24
封裝: GREEN, PLASTIC, TSSOP-24
文件頁數: 6/28頁
文件大?。?/td> 479K
代理商: TLV571IPWG4
TLV571
2.7 V TO 5.5 V, 1-CHANNEL, 8-BIT,
PARALLEL ANALOG-TO-DIGITAL CONVERTER
SLAS239A – SEPTEMBER 1999 – REVISED FEBRUARY 2000
14
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
grounding and decoupling considerations
General practices should apply to the PCB design to limit high frequency transients and noise that are fed back
into the supply and reference lines. This requires that the supply and reference pins be sufficiently bypassed.
In most cases 0.1-
F ceramic chip capacitors are adequate to keep the impedance low over a wide frequency
range. Since their effectiveness depends largely on the proximity to the individual supply pin, they should be
placed as close to the supply pins as possible.
To reduce high frequency and noise coupling, it is highly recommended that digital and analog grounds be
shorted immediately outside the package. This can be accomplished by running a low impedance line between
DGND and AGND under the package.
TLV571
100 nF
DGND
DVDD
AVDD
AGND
REFP
REFM
100 nF
VREFP
VREFM
AVDD
DVDD
Figure 9. Placement for Decoupling Capacitors
power supply ground layout
Printed-circuit boards that use separate analog and digital ground planes offer the best system performance.
Wire-wrap boards do not perform well and should not be used. The two ground planes should be connected
together at the low-impedance power-supply source. The best ground connection may be achieved by
connecting the ADC AGND terminal to the system analog ground plane making sure that analog ground
currents are well managed.
Rs
VS
VC
15 pF
Driving Source
TLV571
Ci
VI
VI = Input Voltage at AIN
VS = External Driving Source Voltage
Rs = Source Resistance
Ri(ADC)= Input Resistance of ADC
Ci = Input Capacitance
VC= Capacitance Charging Voltage
Driving source requirements:
Noise and distortion for the source must be equivalent to the resolution of the converter.
Rs must be real at the input frequency.
Ri(ADC)
AIN
Figure 10. Equivalent Input Circuit Including the Driving Source
相關PDF資料
PDF描述
TLV571IPW 1-CH 8-BIT SUCCESSIVE APPROXIMATION ADC, PARALLEL ACCESS, PDSO24
TLV5734PAG 3-CH 8-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PQFP64
TLV5734PAGG4 3-CH 8-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PQFP64
TLV61224DCKT BATTERY CHARGE CONTROLLER, PDSO6
TLV62065DSGT 2 A SWITCHING REGULATOR, 3400 kHz SWITCHING FREQ-MAX, PDSO8
相關代理商/技術參數
參數描述
TLV571PW 制造商:TI 制造商全稱:Texas Instruments 功能描述:2.7 V TO 5.5 V, 1-CHANNEL, 8-BIT, PARALLEL ANALOG-TO-DIGITAL CONVERTER
TLV5734 制造商:TI 制造商全稱:Texas Instruments 功能描述:TRIPLE 8 BIT 30 MSPS ADC WITH HIGH -PRECISION CLAMP FOR YUV/RGB VIDEO
TLV5734PAG 功能描述:視頻模擬/數字化轉換器集成電路 8B 30MSPS ADC Triple Ch Digital Clamp RoHS:否 制造商:Texas Instruments 輸入信號類型:Differential 轉換器數量:1 ADC 輸入端數量:4 轉換速率:3 Gbps 分辨率:8 bit 結構: 輸入電壓:3.3 V 接口類型:SPI 信噪比: 電壓參考: 電源電壓-最大:3.45 V 電源電壓-最小:3.15 V 最大功率耗散: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:TCSP-48 封裝:Reel
TLV5734PAGG4 功能描述:視頻模擬/數字化轉換器集成電路 8B 30 MSPS ADC 3Ch RoHS:否 制造商:Texas Instruments 輸入信號類型:Differential 轉換器數量:1 ADC 輸入端數量:4 轉換速率:3 Gbps 分辨率:8 bit 結構: 輸入電壓:3.3 V 接口類型:SPI 信噪比: 電壓參考: 電源電壓-最大:3.45 V 電源電壓-最小:3.15 V 最大功率耗散: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:TCSP-48 封裝:Reel
TLV6001IDBVR 功能描述:IC OP AMP RR 1MHZ SOT23-5 制造商:texas instruments 系列:- 包裝:剪切帶(CT) 零件狀態:在售 放大器類型:通用 電路數:1 輸出類型:滿擺幅 壓擺率:0.5 V/μs 增益帶寬積:1MHz 電流 - 輸入偏置:1pA 電壓 - 輸入失調:750μV 電流 - 電源:75μA 電壓 - 電源,單/雙(±):1.8 V ~ 5.5 V,±0.9 V ~ 2.75 V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:SC-74A,SOT-753 供應商器件封裝:SOT-23-5 標準包裝:1