參數資料
型號: TMS320C6711N100
廠商: Texas Instruments, Inc.
元件分類: 數字信號處理
英文描述: FIXED-POINT DIGITAL SIGNAL PROCESSORS
中文描述: 定點數字信號處理器
文件頁數: 94/123頁
文件大?。?/td> 1205K
代理商: TMS320C6711N100
www.ti.com
6.8.2
GPIO - Input Timing
#!
Sampling Window
('%('
&$"
(! &
)!
(A)
GPxQSELn = 1,1 (6 samples)
Sampling Period determined
by GPxCTRL[QUALPRD]
(B)
(D)
t
w(IQSW)
t
w(SP)
TMS320F2808, TMS320F2806
TMS320F2801, UCD9501
Digital Signal Processors
SPRS230F–OCTOBER 2003–REVISED SEPTEMBER 2005
A.
This glitch will be ignored by the input qualifier. The QUALPRD bit field specifies the qualification sampling period. It
can vary from 00 to 0xFF. If QUALPRD = 00, then the sampling period is 1 SYSCLKOUT cycle. For any other value
"n", the qualification sampling period in 2n SYSCLKOUT cycles (i.e., at every 2n SYSCLKOUT cycles, the GPIO pin
will be sampled)..
The qualification period selected via the GPxCTRL register applies to groups of 8 GPIO pins.
The qualification block can take either three or six samples. The GPxQSELn Register selects which sample mode is
used.
In the example shown, for the qualifier to detect the change, the input should be stable for 10 SYSCLKOUT cycles or
greater. In other words, the inputs should be stable for (5 x QUALPRD x 2) SYSCLKOUT cycles. This would ensure 5
sampling periods for detection to occur. Since external signals are driven asynchronously, an 13-SYSCLKOUT-wide
pulse ensures reliable recognition.
B.
C.
D.
Figure 6-9. Sampling Mode
Table 6-13. General-Purpose Input Timing Requirements
MIN
MAX
UNIT
cycles
cycles
cycles
cycles
cycles
QUALPRD = 0
QUALPRD
0
1t
c(SCO)
t
w(SP)
Sampling period
2t
c(SCO)
* QUALPRD
t
w(SP)
* (n
(1)
- 1)
t
w(IQSW)
Input qualifier sampling window
Synchronous mode
With input qualifier
2t
c(SCO)
t
w(GPI)(2)
Pulse duration, GPIO low/high
t
w(IQSW)
+ t
w(SP)
+ 1t
c(SCO)
(1)
(2)
"n" represents the number of qualification samples as defined by GPxQSELn register.
For t
w(GPI)
, pulse width is measured from V
IL
to V
IL
for an active low signal and V
IH
to V
IH
for an active high signal.
6.8.3
Sampling Window Width for Input Signals
The following section summarizes the sampling window width for input signals for various input qualifier
configurations.
Sampling frequency denotes how often a signal is sampled with respect to SYSCLKOUT.
Sampling frequency = SYSCLKOUT/(2 * QUALPRD), if QUALPRD
0
Sampling frequency = SYSCLKOUT, if QUALPRD = 0
Sampling period = SYSCLKOUT cycle x 2 x QUALPRD, if QUALPRD
0
In the above equations, SYSCLKOUT cycle indicates the time period of SYSCLKOUT.
94
Electrical Specifications
相關PDF資料
PDF描述
TMS320C6711JDA167 FIXED-POINT DIGITAL SIGNAL PROCESSORS
TMS320C6711JDA150 FIXED-POINT DIGITAL SIGNAL PROCESSORS
TMS320C6711JDA120 FIXED-POINT DIGITAL SIGNAL PROCESSORS
TMS320C6711JDA100 FIXED-POINT DIGITAL SIGNAL PROCESSORS
TMS320C6711GLS120 FIXED-POINT DIGITAL SIGNAL PROCESSORS
相關代理商/技術參數
參數描述
TMS320C6712CGDP150 制造商:Texas Instruments 功能描述:
TMS320C6712DGDP150 功能描述:數字信號處理器和控制器 - DSP, DSC Floating-Pt Dig Sig Proc RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT
TMS320C6712DZDP150 功能描述:數字信號處理器和控制器 - DSP, DSC Floating-Pt Dig Sig Proc RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT
TMS320C6712GFN100 功能描述:IC FLOATING POINT DSP 256-BGA RoHS:是 類別:集成電路 (IC) >> 嵌入式 - DSP(數字式信號處理器) 系列:TMS320C67x 標準包裝:2 系列:StarCore 類型:SC140 內核 接口:DSI,以太網,RS-232 時鐘速率:400MHz 非易失內存:外部 芯片上RAM:1.436MB 電壓 - 輸入/輸出:3.30V 電壓 - 核心:1.20V 工作溫度:-40°C ~ 105°C 安裝類型:表面貼裝 封裝/外殼:431-BFBGA,F(xiàn)CBGA 供應商設備封裝:431-FCPBGA(20x20) 包裝:托盤
TMS320C6713BGDP225 功能描述:數字信號處理器和控制器 - DSP, DSC Floating-Pt Dig Sig Processors RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT