參數資料
型號： TNY275PG
廠商： POWER INTEGRATIONS INC
元件分類： 穩壓器
英文描述： 0.294 A SWITCHING REGULATOR, PDIP7
封裝： ROHS COMPLIANT, PLASTIC, MS-001AB, DIP-8/7
文件頁數： 22/24頁
文件大小： 1024K
代理商： TNY275PG
Rev. I 01/09
7
TNY274-280
www.powerint.com
Power Up/Down
The TinySwitch-III requires only a 0.1 μF capacitor on the
BYPASS/MULTI-FUNCTION pin to operate with standard
current limit. Because of its small size, the time to charge this
capacitor is kept to an absolute minimum, typically 0.6 ms. The
time to charge will vary in proportion to the BYPASS/MULTI-
FUNCTION pin capacitor value when selecting different current
limits. Due to the high bandwidth of the ON/OFF feedback,
there is no overshoot at the power supply output. When an
external resistor (4 MΩ) is connected from the positive DC input
to the EN/UV pin, the power MOSFET switching will be delayed
during power up until the DC line voltage exceeds the threshold
(100 V). Figures 10 and 11 show the power up timing waveform
in applications with and without an external resistor (4 MΩ)
connected to the EN/UV pin.
Under startup and overload conditions, when the conduction
time is less than 400 ns, the device reduces the switching
frequency to maintain control of the peak drain current.
During power down, when an external resistor is used, the
power MOSFET will switch for 64 ms after the output loses
regulation. The power MOSFET will then remain off without any
glitches since the undervoltage function prohibits restart when
the line voltage is low.
Figure 12 illustrates a typical power down timing waveform.
Figure 13 illustrates a very slow power down timing waveform
as in standby applications. The external resistor (4 MΩ) is
connected to the EN/UV pin in this case to prevent unwanted
restarts.
No bias winding is needed to provide power to the chip
because it draws the power directly from the DRAIN pin (see
Functional Description). This has two main benets. First, for a
nominal application, this eliminates the cost of a bias winding
and associated components. Secondly, for battery charger
applications, the current-voltage characteristic often allows the
output voltage to fall close to zero volts while still delivering
power. TinySwitch-III accomplishes this without a forward bias
winding and its many associated components. For applications
that require very low no-load power consumption (50 mW), a
resistor from a bias winding to the BYPASS/MULTI-FUNCTION
pin can provide the power to the chip. The minimum
recommended current supplied is 1 mA. The BYPASS/MULTI-
FUNCTION pin in this case will be clamped at 6.4 V. This
method will eliminate the power draw from the DRAIN pin,
thereby reducing the no-load power consumption and
improving full-load efciency.
Current Limit Operation
Each switching cycle is terminated when the DRAIN current
reaches the current limit of the device. Current limit operation
provides good line ripple rejection and relatively constant power
delivery independent of input voltage.
BYPASS/MULTI-FUNCTION Pin Capacitor
The BYPASS/MULTI-FUNCTION pin can use a ceramic
capacitor as small as 0.1 μF for decoupling the internal power
supply of the device. A larger capacitor size can be used to
adjust the current limit. For TNY275-280, a 1 μF BP/M pin
capacitor will select a lower current limit equal to the standard
current limit of the next smaller device and a 10 μF BP/M pin
capacitor will select a higher current limit equal to the standard
current limit of the next larger device. The higher current limit
level of the TNY280 is set to 850 mA typical. The TNY274
MOSFET does not have the capability for increased current limit
so this feature is not available in this device.
相關PDF資料
PDF描述
TPS61026DRCTG4 2.1 A SWITCHING REGULATOR, 720 kHz SWITCHING FREQ-MAX, PDSO10
TC151B5012EOA713 0.25 A SWITCHING REGULATOR, 50 kHz SWITCHING FREQ-MAX, PDSO8
TC151B5714EOA723 0.25 A SWITCHING REGULATOR, 50 kHz SWITCHING FREQ-MAX, PDSO8
TC151B5219EOA723 0.25 A SWITCHING REGULATOR, 50 kHz SWITCHING FREQ-MAX, PDSO8
TC151B2025EOA713 0.25 A SWITCHING REGULATOR, 50 kHz SWITCHING FREQ-MAX, PDSO8
相關代理商/技術參數
參數描述
TNY275PN 功能描述:交流/直流開關轉換器 11.5W 85-265 VAC 15W/230 VAC RoHS:否 制造商:STMicroelectronics 輸出電壓:800 V 輸入/電源電壓（最大值）:23.5 V 輸入/電源電壓（最小值）:11.5 V 開關頻率:115 kHz 電源電流:1.6 mA 工作溫度范圍:- 40 C to + 150 C 安裝風格:SMD/SMT 封裝 / 箱體:SSO-10 封裝:Reel
TNY275PN-TL 制造商:POWERINT 制造商全稱:Power Integrations, Inc. 功能描述:Energy Efficient, Off-Line Switcher with Enhanced Flexibility and Extended Power Range
TNY275PTL 制造商:POWERINT 制造商全稱:Power Integrations, Inc. 功能描述:Energy Efficient, Off-Line Switcher with Enhanced Flexibility and Extended Power Range
TNY276G 制造商:POWERINT 制造商全稱:Power Integrations, Inc. 功能描述:Energy Efficient, Off-Line Switcher with Enhanced Flexibility and Extended Power Range
TNY276GN 功能描述:交流/直流開關轉換器 15W 85-265 VAC 19W/230 VAC RoHS:否 制造商:STMicroelectronics 輸出電壓:800 V 輸入/電源電壓（最大值）:23.5 V 輸入/電源電壓（最小值）:11.5 V 開關頻率:115 kHz 電源電流:1.6 mA 工作溫度范圍:- 40 C to + 150 C 安裝風格:SMD/SMT 封裝 / 箱體:SSO-10 封裝:Reel
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*