<" />
參數資料
型號: TPA0233DGQG4
廠商: Texas Instruments
文件頁數: 9/26頁
文件大小: 0K
描述: IC AMP AUDIO PWR 2W MONO 10MSOP
標準包裝: 80
類型: AB 類
輸出類型: 1-通道(單聲道),帶立體聲耳機
在某負載時最大輸出功率 x 通道數量: 2W x 1 @ 4 歐姆; 92mW x 2 @ 32 歐姆
電源電壓: 2.5 V ~ 5.5 V
特點: 消除爆音;關閉
安裝類型: 表面貼裝
供應商設備封裝: 10-MSOP-PowerPad
封裝/外殼: 10-TFSOP,10-MSOP(0.118",3.00mm 寬)裸露焊盤
包裝: 管件
配用: 296-10813-ND - EVAL MOD AUDIO AMP FOR TPA0233
TPA0233
2W MONO AUDIO POWER AMPLIFIER
WITH HEADPHONE DRIVE
SLOS278D JANUARY 2000 REVISED NOVEMBER 2002
17
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
APPLICATION INFORMATION
BTL amplifier efficiency (continued)
(10)
PL = Power devilered to load
PSUP = Power drawn from power supply
VLRMS = RMS voltage on BTL load
RL = Load resistance
h
BTL +
p 2P
L RL
4V
DD
therefore,
VP = Peak voltage on BTL load
IDDavg = Average current drawn from the power supply
VDD = Power supply voltage
ηBTL = Efficiency of a BTL amplifier
Table 2 employs equation 10 to calculate efficiencies for four different output power levels. Note that the
efficiency of the amplifier is quite low for lower power levels and rises sharply as power to the load is increased,
resulting in a nearly flat internal power dissipation over the normal operating range. Note that the internal
dissipation at full output power is less than in the half power range. Calculating the efficiency for a specific
system is the key to proper power supply design. For a stereo 1-W audio system with 8-
loads and a 5-V supply,
the maximum draw on the power supply is almost 3.25 W.
Table 2. Efficiency vs Output Power in 5-V, 8-
BTL Systems
Output Power
(W)
Efficiency
(%)
Peak Voltage
(V)
Internal Dissipation
(W)
0.25
31.4
2.00
0.55
0.50
44.4
2.83
0.62
1.00
62.8
4.00
0.59
1.25
70.2
4.47
0.53
High peak voltages cause the THD to increase.
A final point to remember about Class-AB amplifiers (either SE or BTL) is how to manipulate the terms in the
efficiency equation to utmost advantage when possible. Note that in equation 10, VDD is in the denominator.
This indicates that as VDD goes down, efficiency goes up.
crest factor and thermal considerations
Class-AB power amplifiers dissipate a significant amount of heat in the package under normal operating
conditions. A typical music CD requires 12 dB to 15 dB of dynamic range, or headroom above the average power
output, to pass the loudest portions of the signal without distortion. In other words, music typically has a crest
factor between 12 dB and 15 dB. When determining the optimal ambient operating temperature, the internal
dissipated power at the average output power level must be used. The TPA0233 data sheet shows that when
the TPA0233 is operating from a 5-V supply into a 4-
speaker, 4-W peaks are available. Converting watts to
dB:
P
dB +
10 Log
P
W
P
ref
+ 10Log 4W
1W
+ 6dB
(11)
Subtracting the headroom restriction to obtain the average listening level without distortion yields
6 dB 15 dB = 9 dB (15-dB crest factor)
6 dB 12 dB = 6 dB (12-dB crest factor)
6 dB 9 dB = 3 dB (9-dB crest factor)
6 dB 6 dB = 0 dB (6-dB crest factor)
6 dB 3 dB = 3 dB (3-dB crest factor)
相關PDF資料
PDF描述
VI-JN2-MX CONVERTER MOD DC/DC 15V 75W
ADS7864Y/250G4 IC 12BIT 500KHZ 6CH ADC 48-TQFP
VI-JN1-MX CONVERTER MOD DC/DC 12V 75W
VI-2NX-IU CONVERTER MOD DC/DC 5.2V 200W
GRM43RR72A124KA01L CAP CER 0.12UF 100V 10% X7R 1812
相關代理商/技術參數
參數描述
TPA0233DGQR 功能描述:音頻放大器 Mono Class-AB w/Ster Hdphn Drv Summed Inp RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel
TPA0233DGQRG4 功能描述:音頻放大器 Mono Class-AB w/Ster Hdphn Drv Summed Inp RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel
TPA0233EVM 功能描述:音頻 IC 開發工具 TPA0233 Eval Mod RoHS:否 制造商:Texas Instruments 產品:Evaluation Kits 類型:Audio Amplifiers 工具用于評估:TAS5614L 工作電源電壓:12 V to 38 V
TPA0233G 制造商:ON Semiconductor 功能描述:THY T0220 SPECIAL SCR
TPA0234G 功能描述:SCR THY C77 SPECIAL SCR RoHS:否 制造商:STMicroelectronics 最大轉折電流 IBO:480 A 額定重復關閉狀態電壓 VDRM:600 V 關閉狀態漏泄電流(在 VDRM IDRM 下):5 uA 開啟狀態 RMS 電流 (It RMS): 正向電壓下降:1.6 V 柵觸發電壓 (Vgt):1.3 V 最大柵極峰值反向電壓:5 V 柵觸發電流 (Igt):35 mA 保持電流(Ih 最大值):75 mA 安裝風格:Through Hole 封裝 / 箱體:TO-220 封裝:Tube