- 您現在的位置：買賣IC網 > PDF目錄383962 > TPA2013D1RGPT (Texas Instruments, Inc.) 2.7-W CONSTANT OUTPUT POWER CLASS-D AUDIO AMPLIFIER WITH INTEGRATED BOOST CONVERTER PDF資料下載
參數資料
| 型號： | TPA2013D1RGPT |
| 廠商： | Texas Instruments, Inc. |
| 英文描述： | 2.7-W CONSTANT OUTPUT POWER CLASS-D AUDIO AMPLIFIER WITH INTEGRATED BOOST CONVERTER |
| 中文描述： | 2.7鎢恒定輸出功率D類音頻放大器，具有集成升壓轉換器 |
| 文件頁數： | 13/28頁 |
| 文件大?。?/td> | 753K |
| 代理商： | TPA2013D1RGPT |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁當前第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
www.ti.com
APPLICATION INFORMATION
FULLY DIFFERENTIAL AMPLIFIER
The TPA2013D1 is a fully differential amplifier with differential inputs and outputs. The fully differential amplifier
consists of a differential amplifier with common-mode feedback. The differential amplifier ensures that the
amplifier outputs a differential voltage on the output that is equal to the differential input times the gain. The
common-mode feedback ensures that the common-mode voltage at the output is biased around V
CC
/2 regardless
of the common-mode voltage at the input. The fully differential TPA2013D1 can still be used with a single-ended
input; however, the TPA2013D1 should be used with differential inputs when in a noisy environment, like a
wireless handset, to ensure maximum noise rejection.
Advantages of Fully Differential Amplifiers
Input-coupling capacitors not required:
–
The fully differential amplifier allows the inputs to be biased at voltage other than mid-supply. The inputs of
the TPA2013D1 can be biased anywhere within the common mode input voltage range listed in the
Recommended Operating Conditions table. If the inputs are biased outside of that range, input-coupling
capacitors are required.
Midsupply bypass capacitor, C
(BYPASS)
, not required:
–
The fully differential amplifier does not require a bypass capacitor. Any shift in the midsupply affects both
positive and negative channels equally and cancels at the differential output.
Better RF-immunity:
–
GSM handsets save power by turning on and shutting off the RF transmitter at a rate of 217 Hz. The
transmitted signal is picked-up on input and output traces. The fully differential amplifier cancels the signal
better than the typical audio amplifier.
BOOST CONVERTER
The TPA2013D1 consists of a boost converter and a Class-D amplifier. The boost converter takes a low supply
voltage, V
DD
, and increases it to a higher output voltage, V
CC
. V
CC
is the power supply for the Class-D amplifier.
The two main passive components necessary for the boost converter are the boost inductor and the boost
capacitor. The boost inductor stores current, and the boost capacitor stores charge. As the Class-D amplifier
depletes the charge in the boost capacitor, the boost inductor charges it back up with the stored current. The
cycle of charge/discharge occurs at a frequency of f
boost
.
Boost Terms
TPA2013D1
SLOS520–AUGUST 2007
The TPA2013D1 allows a range of V
CC
voltages, including setting V
CC
lower than V
DD
.
The following is a list of terms and definitions used in the boost equations found later in this document.
C
L
f
boost
I
CC
I
L
R1 and R2
V
CC
Minimum boost capacitance required for a given ripple voltage on V
CC
.
Boost inductor
Switching frequency of the boost converter.
Current pulled by the Class-D amplifier from the boost converter.
Average current through the boost inductor.
Resistors used to set the boost voltage.
Boost voltage. Generated by the boost converter. Voltage supply for the Class-D
amplifier.
Supply voltage to the IC.
Ripple current through the inductor.
Ripple voltage on V
CC
due to capacitance.
V
DD
Δ
I
L
Δ
V
Copyright 2007, Texas Instruments Incorporated
Submit Documentation Feedback
13
Product Folder Link(s):
TPA2013D1
相關PDF資料 |
PDF描述 |
|---|---|
| TPA2013D1YZH | 2.7-W CONSTANT OUTPUT POWER CLASS-D AUDIO AMPLIFIER WITH INTEGRATED BOOST CONVERTER |
| TPA2013D1YZHT | 2.7-W CONSTANT OUTPUT POWER CLASS-D AUDIO AMPLIFIER WITH INTEGRATED BOOST CONVERTER |
| TPA3107D2_07 | 15-W STEREO CLASS-D AUDIO POWER AMPLIFIER |
| TPA3120D2_07 | 25-W STEREO CLASS-D AUDIO POWER AMPLIFIER |
| TPA5050_07 | STEREO DIGITAL AUDIO LIP-SYNC DELAY WITH I2C CONTROL |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPA2013D1YZH | 制造商:TI 制造商全稱:Texas Instruments 功能描述:2.7-W CONSTANT OUTPUT POWER CLASS-D AUDIO AMPLIFIER WITH INTEGRATED BOOST CONVERTER |
| TPA2013D1YZHR | 功能描述:音頻放大器 2.7W OUTPUT PWR MONO CLASS-D AUD AMP RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TPA2013D1YZHT | 制造商:Texas Instruments 功能描述:AUD AMP SPKR 1CH MONO 2.7W CLS-D 16DSBGA - Tape and Reel |
| TPA2014D1 | 制造商:TI 功能描述:1.5-W CONSTANT OUTPUT POWER CLASS-D AUDIO AMPLIFIER WITH INTEGRATED BOOST CONVERTER |
| TPA2014D1_0806 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:1.5-W CONSTANT OUTPUT POWER CLASS-D AUDIO AMPLIFIER WITH INTEGRATED BOOST CONVERTER |
發布緊急采購，3分鐘左右您將得到回復。