- 您現在的位置：買賣IC網 > PDF目錄98272 > TPA3002D2PHP (TEXAS INSTRUMENTS INC) 2 CHANNEL(S), VOLUME CONTROL CIRCUIT, PQFP48 PDF資料下載
參數資料
| 型號： | TPA3002D2PHP |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 音頻控制 |
| 英文描述： | 2 CHANNEL(S), VOLUME CONTROL CIRCUIT, PQFP48 |
| 封裝： | GREEN, PLASTIC, HTQFP-48 |
| 文件頁數： | 19/40頁 |
| 文件大?。?/td> | 735K |
| 代理商： | TPA3002D2PHP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁當前第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁
TPA3002D2
SLOS402C DECEMBER 2002 REVISED JANUARY 2004
www.ti.com
26
The bootstrap capacitors connected between the BSxx pins and corresponding output function as a floating
power supply for the high-side N-channel power MOSFET gate drive circuitry. During each high-side switching
cycle, the bootstrap capacitors attempt to hold the gate-to-source voltage high enough to keep the high-side
MOSFETs turned on. However, there is a leakage path and the voltage on the bootstrap capacitors slowly
decrease while the high-side is conducting.
By driving the outputs into heavy clipping with a sine wave of less than 50 Hz, the bootstrap voltage can
decrease below the minimum Vgs required to keep the high-side output MOSFET turned on. When this occurs,
the output transistor becomes a source-follower and the output drops from VCC to approximately Vclamp (voltage
on pins 25 and 36).
For the majority of applications, driving a square wave at low frequencies is not a design consideration and the
recommended bootstrap capacitor value of 10 nF is acceptable. However, if this is a concern, increasing the
bootstrap capacitors holds the gate voltage for a longer period of time and the drop in the output voltage does
not occur. A value of 220 nF is recommended with a 51
resistor placed in series between the outputs and
bootstrap pins. The 51
series resistor is necessary to limit the current charging and discharging the bootstrap
capacitors.
VCLAMP Capacitors
To ensure that the maximum gate-to-source voltage for the NMOS output transistors is not exceeded, two
internal regulators clamp the gate voltage. Two 1-
F capacitors must be connected from VCLAMPL (pin 25)
and VCLAMPR (pin 36) to ground and must be rated for at least 25 V. The voltages at the VCLAMP terminals
vary with VCC and may not be used for powering any other circuitry.
Internal Regulated 5-V Supply (AVDD)
The AVDD terminal (pin 29) is the output of an internally-generated 5-V supply, used for the oscillator,
preamplifier, and volume control circuitry. It requires a 0.1-
F to 1-F capacitor, placed very close to the pin,
to ground to keep the regulator stable. The regulator may be used to power an external headphone amplifier
or other circuitry, up to a current limit specified in the specification table. When powering external circuitry, like
the TPA6110A2 headphone amplifier, an additional 10
F or larger capacitor should be added to the AVDD
terminal.
AVDD POWER-UP RESPONSE
AVCC
(pin 33)
Ch1
(AVDD)
Ch2
(AVCC)
AVDD
(pin 29)
PowerUp
Ch1 2 V/div
Ch2 5 V/div
M 10.0
s
Figure 37. Power-Up Response
Differential Input
The differential input stage of the amplifier cancels any noise that appears on both input lines of the channel.
To use the TPA3002D2 EVM with a differential source, connect the positive lead of the audio source to the INP
input and the negative lead from the audio source to the INN input. To use the TPA3002D2 with a single-ended
source, ac ground the INP input through a capacitor equal in value to the input capacitor on INN and apply the
audio source to the INN input. In a single-ended input application, the INP input should be ac-grounded at the
audio source instead of at the device input for best noise performance.
相關PDF資料 |
PDF描述 |
|---|---|
| TPA3002D2PHPRG4 | 2 CHANNEL(S), VOLUME CONTROL CIRCUIT, PQFP48 |
| TPA3002D2PHPG4 | 2 CHANNEL(S), VOLUME CONTROL CIRCUIT, PQFP48 |
| TPA3003D2PFBR | 2 CHANNEL(S), VOLUME CONTROL CIRCUIT, PQFP48 |
| TPA3003D2PFB | 2 CHANNEL(S), VOLUME CONTROL CIRCUIT, PQFP48 |
| TPA3003D2PFBRG4 | 2 CHANNEL(S), VOLUME CONTROL CIRCUIT, PQFP48 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPA3002D2PHPG4 | 功能描述:音頻放大器 Stereo Med Pwr Filter-Free Class-D RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TPA3002D2PHPR | 功能描述:音頻放大器 Stereo Med Pwr Filter-Free Class-D RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TPA3002D2PHPRG4 | 功能描述:音頻放大器 Stereo Med Pwr Filter-Free Class-D RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TPA3003D2 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:3-Q STEREO CLASS-D AUDIO POWER AMPLIFIER WITH DC VOLUME CONTROL |
| TPA3003D2_06 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:3-Q STEREO CLASS-D AUDIO POWER AMPLIFIER WITH DC VOLUME CONTROL |
發布緊急采購，3分鐘左右您將得到回復。