參數資料
型號: TPA3100D2RGZR-P
廠商: TEXAS INSTRUMENTS INC
元件分類: 音頻/視頻放大
英文描述: 21.8 W, 2 CHANNEL, AUDIO AMPLIFIER, PQCC48
封裝: 7 X 7 MM, GREEN, PLASTIC, QFN-48
文件頁數: 10/39頁
文件大?。?/td> 1298K
代理商: TPA3100D2RGZR-P
www.ti.com
0V
-12V
+12V
Current
OUTP
OUTN
Differential
Voltage
Across
Load
0V
-12V
+12V
Current
OUTP
OUTN
Differential
Voltage
Across
Load
Output=0V
Output>0V
Efficiency: LC Filter Required With the Traditional Class-D Modulation Scheme
When to Use an Output Filter for EMI Suppression
SLOS469E – OCTOBER 2005 – REVISED MAY 2007
APPLICATION INFORMATION (continued)
Figure 26. The TPA3100D2 Output Voltage and Current Waveforms Into an Inductive Load
The main reason that the traditional class-D amplifier needs an output filter is that the switching waveform
results in maximum current flow. This causes more loss in the load, which causes lower efficiency. The ripple
current is large for the traditional modulation scheme, because the ripple current is proportional to voltage
multiplied by the time at that voltage. The differential voltage swing is 2 x VCC, and the time at each voltage is
half the period for the traditional modulation scheme. An ideal LC filter is needed to store the ripple current from
each half cycle for the next half cycle, while any resistance causes power dissipation. The speaker is both
resistive and reactive, whereas an LC filter is almost purely reactive.
The TPA3100D2 modulation scheme has little loss in the load without a filter because the pulses are short and
the change in voltage is VCC instead of 2 x VCC. As the output power increases, the pulses widen, making the
ripple current larger. Ripple current could be filtered with an LC filter for increased efficiency, but for most
applications the filter is not needed.
An LC filter with a cutoff frequency less than the class-D switching frequency allows the switching current to flow
through the filter instead of the load. The filter has less resistance but higher impedance at the switching
frequency than the speaker, which results in less power dissipation, therefore increasing efficiency.
Design the TPA3100D2 without the filter if the traces from amplifier to speaker are short (< 10 cm). Powered
speakers, where the speaker is in the same enclosure as the amplifier, is a typical application for class-D without
a filter.
18
相關PDF資料
PDF描述
TPA3100D2RGZR 21.8 W, 2 CHANNEL, AUDIO AMPLIFIER, PQCC48
TPA3100D2RGZT 21.8 W, 2 CHANNEL, AUDIO AMPLIFIER, PQCC48
TPA3100D2PHPR 21.8 W, 2 CHANNEL, AUDIO AMPLIFIER, PQFP48
TPA3100D2RGZRG4 21.8 W, 2 CHANNEL, AUDIO AMPLIFIER, PQCC48
TPA3100D2RGZTG4 21.8 W, 2 CHANNEL, AUDIO AMPLIFIER, PQCC48
相關代理商/技術參數
參數描述
TPA3100D2RGZT 功能描述:音頻放大器 20 W Stereo Class-D Audio Amp RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel
TPA3100D2RGZT 制造商:Texas Instruments 功能描述:IC AMP AUDIO PWR 21.8W D 48VQFN
TPA3100D2RGZTG4 功能描述:音頻放大器 20 W Stereo Class-D Audio Amp RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel
TPA3101D2 制造商:TI 制造商全稱:Texas Instruments 功能描述:10-W STEREO CLASS-D AUDIO POWER AMPLIFIER
TPA3101D2_07 制造商:TI 制造商全稱:Texas Instruments 功能描述:10-W STEREO CLASS-D AUDIO POWER AMPLIFIER