- 您現在的位置：買賣IC網 > PDF目錄98273 > TPA3110D2PWPR (TEXAS INSTRUMENTS INC) 15 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO28 PDF資料下載
參數資料
| 型號： | TPA3110D2PWPR |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 音頻／視頻放大 |
| 英文描述： | 15 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO28 |
| 封裝： | GREEN, PLASTIC, HTSSOP-28 |
| 文件頁數： | 16/34頁 |
| 文件大小： | 976K |
| 代理商： | TPA3110D2PWPR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁當前第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁
FCCClassB
f-Frequency-Hz
830M
LimitLevel-dB
V/m
m
30M
20
230M
430M
630M
0
40
10
60
30
70
50
www.ti.com
SLOS528C – JULY 2009 – REVISED AUGUST 2010
Also, it is important that the ferrite bead is large enough to maintain its impedance at the peak currents expected
for the amplifier. Some ferrite bead manufacturers specify the bead impedance at a variety of current levels. In
this case it is possible to make sure the ferrite bead maintains an adequate amount of impedance at the peak
current the amplifier will see. If these specifications are not available, it is also possible to estimate the bead
current handling capability by measuring the resonant frequency of the filter output at low power and at maximum
power. A change of resonant frequency of less than fifty percent under this condition is desirable. Examples of
ferrite beads which have been tested and work well with the TPA3110D2 include 28L0138-80R-10 and
HI1812V101R-10 from Steward and the 742792510 from Wurth Electronics.
A high quality ceramic capacitor is also needed for the ferrite bead filter. A low ESR capacitor with good
temperature and voltage characteristics will work best.
Additional EMC improvements may be obtained by adding snubber networks from each of the class D outputs to
ground. Suggested values for a simple RC series snubber network would be 10
in series with a 330 pF
capacitor although design of the snubber network is specific to every application and must be designed taking
into account the parasitic reactance of the printed circuit board as well as the audio amp. Take care to evaluate
the stress on the component in the snubber network especially if the amp is running at high PVCC. Also, make
sure the layout of the snubber network is tight and returns directly to the PGND or the PowerPad beneath the
chip.
Figure 40. TPA3110D2 EMC spectrum with FCC Class B Limits
Efficiency: LC Filter Required With the Traditional Class-D Modulation Scheme
The main reason that the traditional class-D amplifier needs an output filter is that the switching waveform results
in maximum current flow. This causes more loss in the load, which causes lower efficiency. The ripple current is
large for the traditional modulation scheme, because the ripple current is proportional to voltage multiplied by the
time at that voltage. The differential voltage swing is 2 × VCC, and the time at each voltage is half the period for
the traditional modulation scheme. An ideal LC filter is needed to store the ripple current from each half cycle for
the next half cycle, while any resistance causes power dissipation. The speaker is both resistive and reactive,
whereas an LC filter is almost purely reactive.
The TPA3110D2 modulation scheme has little loss in the load without a filter because the pulses are short and
the change in voltage is VCC instead of 2 × VCC. As the output power increases, the pulses widen, making the
ripple current larger. Ripple current could be filtered with an LC filter for increased efficiency, but for most
applications the filter is not needed.
An LC filter with a cutoff frequency less than the class-D switching frequency allows the switching current to flow
through the filter instead of the load. The filter has less resistance but higher impedance at the switching
frequency than the speaker, which results in less power dissipation, therefore increasing efficiency.
Copyright 2009–2010, Texas Instruments Incorporated
23
Product Folder Link(s) :TPA3110D2
相關PDF資料 |
PDF描述 |
|---|---|
| TPA3110D2PWP | 15 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO28 |
| TPA3117D2RHBR | AUDIO AMPLIFIER, PQCC32 |
| TPA3117D2RHBT | AUDIO AMPLIFIER, PQCC32 |
| TPA3120D2PWPR | 20 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO24 |
| TPA3120D2PWP | 20 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO24 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPA3110D2QPWPRQ1 | 功能描述:音頻放大器 AC 15W Fltr-Free Class D Stereo Amp RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TPA3110LD2PWPR | 制造商:Texas Instruments 功能描述:class d subsystem |
| TPA3111D1 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:10-W FILTER-FREE MONO CLASS-D AUDIO POWER AMPLIFIER with SPEAKER GUARD? |
| TPA3111D1_101 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:10-W FILTER-FREE MONO CLASS-D AUDIO POWER AMPLIFIER with SPEAKER GUARDa?￠ |
| TPA3111D1EVM | 功能描述:音頻 IC 開發工具 TPA3111D1 Eval Mod RoHS:否 制造商:Texas Instruments 產品:Evaluation Kits 類型:Audio Amplifiers 工具用于評估:TAS5614L 工作電源電壓:12 V to 38 V |
發布緊急采購，3分鐘左右您將得到回復。