- 您現在的位置：買賣IC網 > PDF目錄2118 > TPA3123D2PWPR (Texas Instruments)IC AMP AUDIO PWR 25W D 24TSSOP PDF資料下載
參數資料
| 型號： | TPA3123D2PWPR |
| 廠商： | Texas Instruments |
| 文件頁數： | 7/30頁 |
| 文件大小： | 0K |
| 描述： | IC AMP AUDIO PWR 25W D 24TSSOP |
| 標準包裝： | 1 |
| 類型： | D 類 |
| 輸出類型： | 2 通道（立體聲） |
| 在某負載時最大輸出功率 x 通道數量： | 25W x 2 @ 4 歐姆 |
| 電源電壓： | 10 V ~ 30 V |
| 特點： | 消除爆音，靜音，短路保護和熱保護，關機 |
| 安裝類型： | 表面貼裝 |
| 供應商設備封裝： | 24-HTSSOP |
| 封裝/外殼： | 24-TSSOP（0.173"，4.40mm）裸露焊盤 |
| 包裝： | 標準包裝 |
| 產品目錄頁面： | 877 (CN2011-ZH PDF) |
| 配用： | TPA3123D2EVM-ND - TPA3123D2EVM |
| 其它名稱： | 296-22008-6 |
第1頁第2頁第3頁第4頁第5頁第6頁當前第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁
LOUT /ROUT
L
filter
C
filter
LOUT
L
filter
C
filter
L
filter
C
filter
ROUT
www.ti.com
SLOS541C – JULY 2007 – REVISED AUGUST 2010
Output Filter and Frequency Response
For the best frequency response, a flat-passband output filter (second-order Butterworth) may be used. The
output filter components consist of the series inductor and capacitor to ground at the LOUT and ROUT pins.
There are several possible configurations depending on the speaker impedance, and whether the output
configuration is single ended (SE) or bridge-tied load (BTL). Table 4 lists the recommended values for the filter
components. It is important to use a high-quality capacitor in this application. A rating of at least X7R is required.
Table 4. Recommended Filter Output Components
Output Configuration
Speaker Impedance (
)
Filter Inductor (mH)
Filter Capacitor (nF)
4
22
680
Single Ended (SE)
8
47
390
4
10
1500
Bridge Tied Load (BTL)
8
22
680
Figure 25. BTL Filter Configuration
Figure 26. SE Filter Configuration
Power-Supply Decoupling, CS
The TPA3123D2 is a high-performance CMOS audio amplifier that requires adequate power-supply decoupling
to ensure that the output total harmonic distortion (THD) is as low as possible. Power-supply decoupling also
prevents oscillations for long lead lengths between the amplifier and the speaker. The optimum decoupling is
achieved by using two capacitors of different types that target different types of noise on the power-supply leads.
For higher-frequency transients, spikes, or digital hash on the line, a good low equivalent-series-resistance (ESR)
ceramic capacitor, typically 0.1 mF to 1 mF, placed as close as possible to the device VCC lead works best. For
filtering lower frequency noise signals, a larger aluminum electrolytic capacitor of 470 mF or greater placed near
the audio power amplifier is recommended. The 470-mF capacitor also serves as local storage capacitor for
supplying current during large signal transients on the amplifier outputs. The PVCC terminals provide the power
to the output transistors, so a 470-mF or larger capacitor should be placed on each PVCC terminal. A 10-mF
capacitor on the AVCC terminal is adequate. These capacitors must be properly derated for voltage and ripple
current rating to ensure reliability.
BSN and BSP Capacitors
The half H-bridge output stages use only NMOS transistors. Therefore, they require bootstrap capacitors for the
high side of each output to turn on correctly. A 220-nF ceramic capacitor, rated for at least 25 V, must be
connected from each output to its corresponding bootstrap input. Specifically, one 220-nF capacitor must be
connected from LOUT to BSL, and one 220-nF capacitor must be connected from ROUT to BSR.
The bootstrap capacitors connected between the BSx pins and their corresponding outputs function as a floating
power supply for the high-side N-channel power MOSFET gate-drive circuitry. During each high-side switching
cycle, the bootstrap capacitors hold the gate-to-source voltage high enough to keep the high-side MOSFETs
turned on.
Copyright 2007–2010, Texas Instruments Incorporated
15
Product Folder Link(s) :TPA3123D2
相關PDF資料 |
PDF描述 |
|---|---|
| TPA3130D2DAPR | IC AMP AUD PWR 15W STER 32HTSSOP |
| TPA6140A2YFFR | IC AMP AUDIO 25MW STER 16DSBGA |
| TRF3750IRGPG4 | IC PLL FREQ SYNTHESIZER 20-QFN |
| TRS202IDWR | IC DVR/RCVR RS232 ESD DL 16SOIC |
| TS117PTR | RELAY OPTO TELCOM 120MA 8 FLTPK |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPA3123D2PWPRG4 | 功能描述:音頻放大器 25W Stereo Class D Aud Pwr Amp RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TPA3124D2 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:15-W STEREO CLASS-D AUDIO POWER AMPLIFIER |
| TPA3124D2_1 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:15-W STEREO CLASS-D AUDIO POWER AMPLIFIER |
| TPA3124D2EVM | 功能描述:音頻 IC 開發工具 TPA3124D2EVM Eval Mod RoHS:否 制造商:Texas Instruments 產品:Evaluation Kits 類型:Audio Amplifiers 工具用于評估:TAS5614L 工作電源電壓:12 V to 38 V |
| TPA3124D2PWP | 功能描述:音頻放大器 15W Stereo Class-D Aud Pwr Amp RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。