- 您現在的位置：買賣IC網 > PDF目錄272834 > TPS2390DGKG4 (TEXAS INSTRUMENTS INC) 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8 PDF資料下載
參數資料
| 型號： | TPS2390DGKG4 |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 電源管理 |
| 英文描述： | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8 |
| 封裝： | GREEN, PLASTIC, MSOP-8 |
| 文件頁數： | 5/20頁 |
| 文件大?。?/td> | 497K |
| 代理商： | TPS2390DGKG4 |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁
TPS2390
TPS2391
SLUS471D JUNE 2002 REVISED JANUARY 2008
13
www.ti.com
APPLICATION INFORMATION
When setting the sense resistor value, it is important to consider two factors, the minimum current that may be
imposed by the TPS2390 or TPS2391, and the maximum load under normal operation of the module. For the
first factor, the specification minimum clamp value is used, as seen in equation (1). This method accounts for
the tolerance in the sourced current limit below the typical level expected (40 mV/RSENSE). (The clamp
measurement includes LCA input offset voltage; therefore, this offset does not have to be factored into the
current limit again.) Second, if the load current varies over a range of values under normal operating conditions,
then the maximum load level must be allowed for by the value of RSENSE. One example of this is when the load
is a switching converter, or brick, which draws higher input current, for a given power output, when the
distribution bus is at the low end of its operating range, with decreasing draw at higher supply voltages. To avoid
current-limit operation under normal loading, some margin should be designed in between this maximum
anticipated load and the minimum current limit level, or IMAX > ILOAD(max), for equation (1).
For example, using a 20-m
sense resistor for a nominal 1-A load application provides a minimum of 650 mA
of overhead for load variance/margin. Typical bulk capacitor charging current during turn-on is 2 A
(40 mV/20 m
).
setting the inrush slew rate
The TPS2390 and TPS2391 devices enable user-programming of the maximum current slew rate during load
start-up events. A capacitor tied to the IRAMP pin (C2 in the typical application diagram) controls the di/dt rate.
Once the sense resistor value has been established, a value for ramp capacitor CIRAMP, in microfarads, can be
determined from equation (2).
C
IRAMP +
11
100
R
SENSE
di
dt MAX
where:
R
SENSE is in ohms, and
(di/dt)
MAX is the desired maximum slew rate, in amps/second.
For example, if the desired slew rate for the typical application shown is 1500 mA/ms, the calculated value for
CIRAMP is about 3700 pF. Selecting the next larger standard value of 3900 pF (as shown in the diagram) provides
some margin for capacitor and sense resistor tolerances.
As described earlier in this section, the TPS2390 and TPS2391 initiate ramp capacitor charging, and
consequently, load current di/dt at a reduced rate. This reduced rate applies until the voltage on the IRAMP pin
is about 0.5 V. The maximum di/dt rate, as set by equation (2), is effective once the device has switched to the
10-
A charging source.
(2)
相關PDF資料 |
PDF描述 |
|---|---|
| TPS65560RGTTG4 | 1.78 A BATTERY CHARGE CONTROLLER, PQCC16 |
| TPS62260DRVT | 1.2 A SWITCHING REGULATOR, 2500 kHz SWITCHING FREQ-MAX, PDSO6 |
| TPS2052BDRB | 2-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8 |
| TC646EUA | BRUSHLESS DC MOTOR CONTROLLER, PDSO8 |
| TLE6210C | 1-CHANNEL POWER SUPPLY MANAGEMENT CKT, UUC19 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS2390DGKR | 功能描述:熱插拔功率分布 Simple-48V Hot Swap Controller RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube |
| TPS2390DGKRG4 | 功能描述:熱插拔功率分布 Simple-48V Hot Swap Controller RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube |
| TPS2390EVM | 功能描述:電源管理IC開發工具 Simple -48V Hot Swap Contr EVM RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V |
| TPS2391DGK | 功能描述:熱插拔功率分布 Simple-48V Hot Swap Controller RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube |
| TPS2391DGKG4 | 功能描述:熱插拔功率分布 Simple-48V Hot Swap Controller RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。