參數資料
型號: TPS5103IDBR
英文描述: SMPS Controller
中文描述: 開關電源控制器
文件頁數: 19/31頁
文件大?。?/td> 1083K
代理商: TPS5103IDBR
TPS5102
DUAL, HIGH-EFFICIENCY CONTROLLER FOR NOTEBOOK PC POWER
SLVS239 - SEPTEMBER 1999
19
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
APPLICATION INFORMATION
loop-gain compensation (continued)
_
+
R4
C3
C2
R2
R3
Vref
To PWM
VO
Assuming C2 << C3, the equation is:
Comp
(1
sC3R4)
sC2R4)
sC3R2(1
There is one pole, one zero and one integrator:
Zero
1
2 C3R4
Pole
1
2 C2R4
Integrator
1
2 fC3R2
The loop-gain concept is used to design a stable and fast feedback control. The loop-gain equation is derived
by the control-to-output transfer function times the compensation:
Loop–gain
Vod
Comp
The amplitude and the phase of this equation can be drawn with software such as MathCad. In turn, the stability
can be easily designed by adjusting the compensation parameters. The sample bode plot is shown below to
explain the phase margin, gain margin, and the crossover frequency.
The gain is drawn as 20 log (loop-gain), and the phase is in degrees. To explain them clearer, 180 degrees is
added to the phase, so that the gain and phase share the same zero.
The crossover frequency is the point at which the gain curve touches zero. The higher this frequency, the faster
the transient response, since the transient recovery time is 1/(crossover frequency). The phase is the phase
margin. The phase margin should be at least 60 degrees to cover all changes such as temperature. The gain
margin is the gap between the gain curve and the zero when the phase curve touches zero. This margin should
be at least 20 dB to guarantee stability over all conditions.
Powered by ICminer.com Electronic-Library Service CopyRight 2003
相關PDF資料
PDF描述
TPS5210DWR Voltage-Mode SMPS Controller
TPS5210PWPR Voltage-Mode SMPS Controller
TPS5211PWPR Analog IC
TPS524 PHOTOVOLTAIC CELL FOR THERMOPILE DETECTION
TPS5300DAP Analog IC
相關代理商/技術參數
參數描述
TPS5103IDBRG4 功能描述:DC/DC 開關控制器 Synch Buck Cntrlr RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
TPS5110 制造商:TI 制造商全稱:Texas Instruments 功能描述:3-A SINK/ SOURCE DDR TERMINATION REGULATOR
TPS51100 制造商:TI 制造商全稱:Texas Instruments 功能描述:3-A SINK/SOURCE DDR TERMINATION REGULATOR
TPS51100_07 制造商:TI 制造商全稱:Texas Instruments 功能描述:3-A SINK/SOURCE DDR TERMINATION REGULATOR
TPS51100DGQ 功能描述:低壓差穩壓器 - LDO 3A Source/Sink DDR Terminator Regulator RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓(最大值):307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20