- 您現在的位置：買賣IC網 > PDF目錄231082 > TPS60130PWPG4 (TEXAS INSTRUMENTS INC) 0.3 A SWITCHED CAPACITOR REGULATOR, 450 kHz SWITCHING FREQ-MAX, PDSO20 PDF資料下載
參數資料
| 型號： | TPS60130PWPG4 |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | 0.3 A SWITCHED CAPACITOR REGULATOR, 450 kHz SWITCHING FREQ-MAX, PDSO20 |
| 封裝： | GREEN, PLASTIC, HTSSOP-20 |
| 文件頁數： | 23/27頁 |
| 文件大?。?/td> | 0K |
| 代理商： | TPS60130PWPG4 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁當前第23頁第24頁第25頁第26頁第27頁
TPS60130, TPS60131, TPS60132, TPS60133
REGULATED 5V, 300 mA HIGH EFFICIENCY CHARGE PUMP
DC/DC CONVERTERS
SLVS258A NOVEMBER 1999 REVISED DECEMBER 1999
5
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
adaptive mode switching (continued)
The voltage on the flying capacitors is measured and compared with the supply voltage VI. If the voltage across
the flying capacitors is smaller than half of the supply voltage, then the charge pump switches into the
1.5x conversion-mode. The charge pump switches back from a 1.5x conversion-mode to a voltage doubler
mode if the load current in 1.5x conversion-mode can no more be delivered.
With this control mode the device runs in doubler -mode at low VI and in 1.5x conversion-mode at high VI to
optimize the efficiency. The most desirable transfer mode is automatically selected depending on both VI and
IL. This means that at light loads the device selects the 1.5x conversion-mode already at smaller supply voltages
than at heavy loads.
The TPS60130 output voltage is regulated using the ACTIVE-CYCLE-regulation. An active cycle controlled
charge pump utilizes two methods to control the output voltage. At high load currents it varies the on-resistances
of the internal switches and keeps the ratio ON/OFF time (=frequency) constant. That means the charge pump
runs at a fixed frequency. It also keeps the output voltage ripple as low as in linear-mode. At light loads the
internal resistance and also the amount of energy transferred per pulse is fixed and the charge pump regulates
the voltage by means of a variable ratio of ON-to-OFF time. In this operating point it runs like a skip mode
controlled charge pump with a very high internal resistance, which also enables a low ripple in this operation
mode. Since the charge pump does effectively switch at lower frequencies at light loads, it achieves a low
quiescent current.
pulse-skip mode
In pulse-skip mode the error amplifier disables switching of the power stages when it detects an output higher
than 5 V. The oscillator halts and the IC then skips switching cycles until the output voltage drops below 5 V.
The error amplifier reactivates the oscillator and starts switching the power stages again. The pulse-skip
regulation mode minimizes operating current because it does not switch continuously and deactivates all
functions except bandgap reference, error amplifier, and low-battery/power-good comparator when the output
is higher than 5 V. When switching is disabled from the error amplifier, the load is also isolated from the input.
In pulse-skip mode, a special current control circuitry, limits the peak current. This assures moderate output
voltage ripple and also prevents the device from drawing excessive current spikes out of the battery.
start-up procedure
During start-up, i.e. when ENABLE is set from logic low to logic high, the output capacitor is charged up, with
a limited current, until the output voltage VO reaches 0.8 × VI. When the start-up comparator detects this voltage
limit, the IC begins switching. This start-up charging of the output capacitor assures a short start-up time and
eliminates the need of a Schottky diode between IN and OUT. The IC starts with a maximum load, which is
defined by a 16-
or 33- resistor, respectively.
shutdown
Driving ENABLE low places the device in shutdown mode. This disables all switches, the oscillator, and control
logic. The device typically draws 0.05
A (1 A max) of supply current in this mode. Leakage current drawn from
the output is as low as 1
A max. The device exits shutdown once ENABLE is set to a high level. The typical
no-load shutdown exit time is 10
s. When the device is in shutdown, the load is isolated from the input.
undervoltage lockout
The TPS6013x devices have an undervoltage lockout feature that deactivates the device and places it in
shutdown mode when the input voltage falls below 1.6 V.
low-battery detector (TPS60130 and TPS60132)
The internal low-battery comparator trips at 1.21 V
±5% when the voltage on pin LBI ramps down. The battery
voltage at which the comparator initiates a low battery warning at the LBO output can easily be programmed
with a resistive divider as shown in Figure 3. The sum of resistors R1 and R2 is recommended to be in the 100-k
to 1-M
range.
相關PDF資料 |
PDF描述 |
|---|---|
| TPS60205DGSRG4 | SWITCHED CAPACITOR REGULATOR, 400 kHz SWITCHING FREQ-MAX, PDSO10 |
| TPS2047BDG4 | 3-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO16 |
| TPS65072TRSLRQ1 | POWER SUPPLY SUPPORT CKT, PQCC48 |
| TC151B4217EOA723 | 0.25 A SWITCHING REGULATOR, 50 kHz SWITCHING FREQ-MAX, PDSO8 |
| TC151B2419EOA713 | 0.25 A SWITCHING REGULATOR, 50 kHz SWITCHING FREQ-MAX, PDSO8 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS60130PWPR | 功能描述:電荷泵 Reg 5V Hi-Eff Charge Pump DC/DC Converter RoHS:否 制造商:Maxim Integrated 功能:Inverting, Step Up 輸出電壓:- 1.5 V to - 5.5 V, 3 V to 11 V 輸出電流:100 mA 電源電流:1 mA 最大工作溫度:+ 70 C 封裝 / 箱體:SOIC-8 Narrow 封裝:Tube |
| TPS60130PWPRG4 | 功能描述:電荷泵 Reg 5V Hi-Eff Charge Pump DC/DC Converter RoHS:否 制造商:Maxim Integrated 功能:Inverting, Step Up 輸出電壓:- 1.5 V to - 5.5 V, 3 V to 11 V 輸出電流:100 mA 電源電流:1 mA 最大工作溫度:+ 70 C 封裝 / 箱體:SOIC-8 Narrow 封裝:Tube |
| TPS60131 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:REGULATED 5-V, 300 mA HIGH EFFICIENCY CHARGE PUMP DC/DC CONVERTERS |
| TPS60131PWP | 功能描述:電荷泵 Reg 5V Hi-Eff Charge Pump DC/DC Converter RoHS:否 制造商:Maxim Integrated 功能:Inverting, Step Up 輸出電壓:- 1.5 V to - 5.5 V, 3 V to 11 V 輸出電流:100 mA 電源電流:1 mA 最大工作溫度:+ 70 C 封裝 / 箱體:SOIC-8 Narrow 封裝:Tube |
| TPS60131PWPG4 | 功能描述:電荷泵 Reg 5V Hi-Eff Charge Pump DC/DC Converter RoHS:否 制造商:Maxim Integrated 功能:Inverting, Step Up 輸出電壓:- 1.5 V to - 5.5 V, 3 V to 11 V 輸出電流:100 mA 電源電流:1 mA 最大工作溫度:+ 70 C 封裝 / 箱體:SOIC-8 Narrow 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。