參數資料
型號： TPS61073DDC
廠商： Texas Instruments, Inc.
英文描述： 90% EFFICIENT SYNCHRONOUS BOOST CONVERTER WITH 600-mA SWITCH
中文描述： 90％高效同步升壓轉換器和600毫安開關
文件頁數： 12/21頁
文件大?。?/td> 400K
代理商： TPS61073DDC
www.ti.com
DETAILED DESCRIPTION
CONTROLLER CIRCUIT
The controller circuit of the device is based on a fixed frequency multiple feedforward controller topology. Input
voltage, output voltage, and voltage drop on the NMOS switch are monitored and forwarded to the regulator. So,
changes in the operating conditions of the converter directly affect the duty cycle and must not take the indirect
and slow way through the control loop and the error amplifier. The control loop, determined by the error
amplifier, only has to handle small signal errors. The input for it is the feedback voltage on the FB pin. It is
compared with the internal reference voltage to generate an accurate and stable output voltage.
Synchronous Rectifier
Device Enable
Undervoltage Lockout
Soft Start and Short Circuit Protection
TPS61070, TPS61071
TPS61072, TPS61073
SLVS510A–JULY 2006–REVISED JANUARY 2007
The peak current of the NMOS switch is also sensed to limit the maximum current flowing through the switch
and the inductor. The typical peak-current limit is set to 600 mA. An internal temperature sensor prevents the
device from getting overheated in case of excessive power dissipation.
The device integrates an N-channel and a P-channel MOSFET transistor to realize a synchronous rectifier.
Because the commonly used discrete Schottky rectifier is replaced with a low R
DS(on)
PMOS switch, the power
conversion efficiency reaches values above 90%. A special circuit is applied to disconnect the load from the
input during shutdown of the converter. In conventional synchronous rectifier circuits, the backgate diode of the
high-side PMOS is forward biased in shutdown and allows current flowing from the battery to the output.
However, this device uses a special circuit which takes the cathode of the backgate diode of the high-side
PMOS and disconnects it from the source when the regulator is not enabled (EN = low).
The benefit of this feature for the system design engineer is that the battery is not depleted during shutdown of
the converter. No additional components must be added to the design to make sure that the battery is
disconnected from the output of the converter.
The device is put into operation when EN is set high. It is put into a shutdown mode when EN is set to GND. In
shutdown mode, the regulator stops switching, all internal control circuitry is switched off, and the load is isolated
from the input (as described in the
Synchronous Rectifier Section
). This also means that the output voltage can
drop below the input voltage during shutdown. During start-up of the converter, the duty cycle and the peak
current are limited in order to avoid high-peak currents drawn from the battery.
An undervoltage lockout function prevents the device from operating if the supply voltage on VBAT is lower than
approximately 0.8 V. When in operation and the battery is being discharged, the device automatically enters the
shutdown mode if the voltage on VBAT drops below approximately 0.8 V. This undervoltage lockout function is
implemented in order to prevent the malfunctioning of the converter.
When the device enables, the internal start-up cycle starts with the first step, the precharge phase. During
precharge, the rectifying switch is turned on until the output capacitor is charged to a value close to the input
voltage. The rectifying switch is current limited during this phase. The current limit increases with the output
voltage. This circuit also limits the output current under short-circuit conditions at the output.
Figure 22
shows
the typical precharge current vs output voltage for specific input voltages:
12
Submit Documentation Feedback
相關PDF資料
PDF描述
TPS6107X 90% EFFICIENT SYNCHRONOUS BOOST CONVERTER WITH 600-mA SWITCH
TPS61106EVM-216 For Dual Output, Single-Cell Boost Converter(用于雙輸出，單電池升壓轉換器)
TPS61100EVM-216 For Dual Output, Single-Cell Boost Converter(用于雙輸出，單電池升壓轉換器)
TPS61103EVM-216 For Dual Output, Single-Cell Boost Converter(用于雙輸出，單電池升壓轉換器)
TPS61107EVM-216 For Dual Output, Single-Cell Boost Converter(用于雙輸出，單電池升壓轉換器)
相關代理商/技術參數
參數描述
TPS61073DDCR 功能描述:直流/直流開關調節器 Adj 600mA Sw 90% Eff PFM/PWM RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5
TPS61073DDCR 制造商:Texas Instruments 功能描述:DC/DC Converter IC
TPS61073DDCRG4 功能描述:直流/直流開關調節器 Adj 600mA Sw 90% Eff PFM/PWM Boost RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5
TPS6107X 制造商:TI 制造商全稱:Texas Instruments 功能描述:90% EFFICIENT SYNCHRONOUS BOOST CONVERTER WITH 600-mA SWITCH
TPS61080 制造商:TI 制造商全稱:Texas Instruments 功能描述:HIGH VOLTAGE DC/DC BOOST CONVERTER WITH 0.5-A/1.3-A INTEGRATED SWITCH
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*