- 您現在的位置：買賣IC網 > PDF目錄98284 > TPS62410DRCTG4 (TEXAS INSTRUMENTS INC) 1.6 A DUAL SWITCHING CONTROLLER, 2500 kHz SWITCHING FREQ-MAX, PDSO10 PDF資料下載
參數資料
| 型號： | TPS62410DRCTG4 |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | 1.6 A DUAL SWITCHING CONTROLLER, 2500 kHz SWITCHING FREQ-MAX, PDSO10 |
| 封裝： | 3 X 3 MM, GREEN, PLASTIC, MLF-10 |
| 文件頁數： | 9/31頁 |
| 文件大?。?/td> | 1240K |
| 代理商： | TPS62410DRCTG4 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁當前第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁
www.ti.com
DEF_1 PIN FUNCTION
180
° OUT OF PHASE OPERATION
SHORT-CIRCUIT PROTECTION
THERMAL SHUTDOWN
EasyScale: One Pin Serial Interface for Dynamic Output Voltage Adjustment
General
Protocol
Addressable Registers
SLVS737 – FEBRUARY 2007
DETAILED DESCRIPTION (continued)
The DEF_1 pin is dedicated to converter 1 and works as an analog input for adjustable output voltage setting.
Connecting an external resistor network to this pin adjusts the default output voltage to any value starting from
0.6V to VIN.
In PWM Mode the converters operate with a 180
° turn-on phase shift of the PMOS (high side) transistors. It
prevents the high side switches of both converters to be turned on simultaneously, and therefore smooths the
input current. This feature reduces the surge current drawn from the supply.
Both outputs are short-circuit protected with maximum output current = ILIMF(P-MOS and N-MOS). Once the
PMOS switch reaches its current limit, it will be turned off and the NMOS turned on. The PMOS only turns on
again, once the current in the NMOS decreases below the NMOS current limit.
As soon as the junction temperature, TJ, exceeds typically 150°C the device goes into thermal shutdown. In this
mode, the P and N-Channel MOSFETs are turned-off. The device continues its operation when the junction
temperature falls below the thermal shutdown hysteresis again.
EasyScale is a simple but very flexible one pin interface to configure the output voltage of both DC/DC
converters. The interface is based on a master – slave structure, where the master is typically a
Controller or
Application processor. Figure 27 and Table 2 give an overview of the protocol. The protocol consists of a device
specific address byte and a data byte. The device specific address byte is fixed to 4E hex. The data byte
consists of five bit for information, two address bits and the RFA bit. RFA bit set to high indicates the Request
For Acknowledge condition. The Acknowledge condition is only applied if the protocol was received correctly.
The advantage of EasyScale compared to other one-pin interfaces is that its bit detection is, to a large extent,
independent from the bit transmission rate. It can automatically detect bit rates between 1.7kBit/sec and up to
160kBit/sec. Furthermore, the interface is shared with the Mode/Data Pin and requires therefore no additional
pin.
All bits are transmitted MSB first and LSB last. Figure 28 shows the protocol without acknowledge request (bit
RFA = 0), Figure 29 with acknowledge (bit RFA = 1) request.
Prior to both bytes, device address byte and data byte, a start condition needs to be applied. For this, the
Mode/Data pin needs to be pulled high for at least tStart before the bit transmission starts with the falling edge. In
case the Mode/Data line was already at high level (forced PWM Mode selection) no start condition need be
applied prior the device address byte.
The transmission of each byte needs to be closed with an End Of Stream condition for at least TEOS.
In TPS62410 two registers with a data content of 5 bits can be addressed to change the output voltage of both
converters. With 5 bit data content, 32 different values for each register are available. Table 1 shows the
addressable registers if DEF_1 pin acts as analog input with external resistors connected.
The available output voltages for converter 1 are shown in Table 3, for converter 2 in Table 4. To generate these
output voltages, a precise internal resistor divider network is used, which makes external resistors unnecessary
and results therefore in an higher output voltage accuracy and less board space.
17
相關PDF資料 |
PDF描述 |
|---|---|
| TPS62420DRCT | 1.61 A DUAL SWITCHING CONTROLLER, 2500 kHz SWITCHING FREQ-MAX, PDSO10 |
| TPS62420DRC | 1.61 A DUAL SWITCHING CONTROLLER, 2500 kHz SWITCHING FREQ-MAX, PDSO10 |
| TPS62421DRCR | 1.61 A DUAL SWITCHING CONTROLLER, 2500 kHz SWITCHING FREQ-MAX, PDSO10 |
| TPS62510DRCRG4 | 1.5 A SWITCHING REGULATOR, 1700 kHz SWITCHING FREQ-MAX, PDSO10 |
| TPS62510DRCT | 1.5 A SWITCHING REGULATOR, 1700 kHz SWITCHING FREQ-MAX, PDSO10 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS62410Q1-EVM | 功能描述:EVALUATION MODULE 制造商:texas instruments 系列:* 零件狀態:在售 標準包裝:1 |
| TPS62410QDRCRQ1 | 功能描述:直流/直流開關轉換器 2.25MHZ 2x800mA Dual Step-Down Converter RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
| TPS62420DRCR | 功能描述:直流/直流開關調節器 Dual Adj 600mA & 1000mA 2.25MHz RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| TPS62420DRCRG4 | 功能描述:直流/直流開關調節器 Dual Adj 600mA & 1000mA 2.25MHz RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| TPS62420DRCT | 功能描述:直流/直流開關調節器 Dual Adj 600mA & 1000mA 2.25MHz RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
發布緊急采購，3分鐘左右您將得到回復。