- 您現在的位置：買賣IC網 > PDF目錄373691 > TS1051 (Taiwan Semiconductor Co., Ltd.) Constant Voltage and Constant Current Controller For Battery Chargers and Adaptors PDF資料下載
參數資料
| 型號： | TS1051 |
| 廠商： | Taiwan Semiconductor Co., Ltd. |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | Constant Voltage and Constant Current Controller For Battery Chargers and Adaptors |
| 中文描述： | 恒壓恒為電池充電器和適配器電流控制器 |
| 文件頁數： | 4/9頁 |
| 文件大?。?/td> | 439K |
| 代理商： | TS1051 |
TS1051
Constant Voltage and Constant Current Controller
For Battery Chargers and Adaptors
Principle of Operation and Application Hints (continues)
4/9
Version: B07
Current Control
The current loop is controlled via the second trans-conductance operational amplifier, the sense resistor Rsense, and
the optocoupler. The control verifies as following
* Rsense x llim = Vsense
* Rsense = Vsense / llim
Ilim is the desired limited current, Vsense is the threshold voltage for the current control loop.
As an example, with llim = 1A, Vsense = -200mV, then Rsense = 200m
Ω
.
Note that the Rsense resistor should be chosen taking into account the maximum dissipation (Plim) through it during
full load operation.
* Plim = Vsense x llim
As an example, with llim=1A, and Vsense=200mV, Plim=200mW.
Therefore, for most adapter and battery charger applications, a quarter-watt, or half-watt resistor to make the current
sensing function is sufficient.
Vsense threshold is achieved internally by a resistor bridge tied to the Vref voltage reference. Its middle point is tied to
the positive input of the current control operational amplifier, and its foot is to be connected to lower potential point of
the senseresistor as shown on the following figure. The resistors of this bridge are matched to provide the best
precision possible. The current siking outpits of the two trans-conductance operational amplifiers are common (to the
outpit of the IC). This makes an Oring function which ensures that whenever the current or the voltage reaches too
high values, the optocoupler is activated.
The relation between the controlled current and the controlled output voltage can be described with a square
characteristic as shown in the following V/I output-power graph
Output Voltage vs. Output Current
相關PDF資料 |
PDF描述 |
|---|---|
| TS1051CSRL | Constant Voltage and Constant Current Controller For Battery Chargers and Adaptors |
| TS1051CX6RF | Constant Voltage and Constant Current Controller For Battery Chargers and Adaptors |
| TS1082CZ-3.3 | 128 x 128 pixel format, LED or EL Backlight available |
| TS1082 | 5.0 AMP POSITIVE VOLTAGE REGULATOR |
| TS1082CZ | 5.0 AMP POSITIVE VOLTAGE REGULATOR |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TS-105-1 | 制造商:Thomas & Betts 功能描述:1 1/2 STRAP,EMT,STL,1 HOLE SNAP,EA |
| TS105-1 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Thermosensors |
| TS1051_09 | 制造商:TSC 制造商全稱:Taiwan Semiconductor Company, Ltd 功能描述:Constant Voltage and Constant Current Controller For Battery Chargers and Adaptors |
| TS1051CSRL | 制造商:TSC 制造商全稱:Taiwan Semiconductor Company, Ltd 功能描述:Constant Voltage and Constant Current Controller For Battery Chargers and Adaptors |
| TS1051CX6 | 功能描述:電流和電力監控器、調節器 14 Volt 1.1mA ICC Constant Volt/Curr RoHS:否 制造商:STMicroelectronics 產品:Current Regulators 電源電壓-最大:48 V 電源電壓-最小:5.5 V 工作溫度范圍:- 40 C to + 150 C 安裝風格:SMD/SMT 封裝 / 箱體:HPSO-8 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。