- 您現在的位置：買賣IC網 > PDF目錄373736 > TSH511C (意法半導體) HiFi stereo/mono infrared receiver Stereo sub-carrier demodulator PDF資料下載
參數資料
| 型號： | TSH511C |
| 廠商： | 意法半導體 |
| 英文描述： | HiFi stereo/mono infrared receiver Stereo sub-carrier demodulator |
| 中文描述： | 高保真立體聲/單聲道立體聲紅外線接收副載波解調器 |
| 文件頁數： | 15/18頁 |
| 文件大?。?/td> | 1172K |
| 代理商： | TSH511C |
TSH511
15/18
The LNA output is directly connected to
LNA-OUT1 and LNA-OUT2 pins in parallel (pin 8
and 4 respectively). As the LNA minimum imped-
ance load is 1 k
, the load impedance on each pin
LNA-OUT1 or LNA-OUT2 must be 2 k
minimum.
The series 50
resistor and the 100 nF capacitor
decouple the LNA supply voltage (pin 5), improv-
ing noise performance.
AMP and LIM sections: Amplifier and Limitor
The first filter output is connected to the intermedi-
ate amplifier AMP. The gain of AMP is typically 20
dB. The second filter is connected between the
output of AMP and the input of the limitor LIM. The
60 dB limitor LIM provides a constant amplitude
signal to the FM demodulator. It reduces the AM
parasitic effects into the FM demodulator.
Figure 4 :
AMP and LIM schematic
FM demodulator section
The FM demodulator is a classical quadrature de-
modulator based on a multiplier. The quadrature is
performed with the tank circuit Llo inductor and
Clo capacitor. The tank circuit is tuned on the re-
ceiving frequency.
The Rlo resistor is connected in parallel with Llo
and Clo to reduce the Q factor of the tank circuit. It
allows to adjustment of the demodulation charac-
teristic. For a given transmitting deviation, a lower
value of Rlo gives a lower demodulated amplitude
and reduces the distortion.
The AC amplitude on pin 18 must not exceed 300
mV
RMS
to prevent clipping by the internal ESD di-
odes of the circuit.
The low output impedance of the demodulator
(MIX-OUT pins) drives the external volume control
and the de-emphasis filter.
Figure 5 :
FM demodulator schematic
SQUELCH section
To avoid audio ’FM noise’ at the speakers when
no carrier is received, the TSH511 has a built-in
Squelch circuit. The Squelch detects the wide-
band ’FM noise’ on the demodulated output and
fades-out the audio of both audio buffers.
The audio is filtered from the ’FM noise’ using the
high-pass RC filter. The cut-off frequency is typi-
cally 100kHz. The squelch level depends on the
value of the R
MUTE
resistor in serie with the input
pin of the noise amplifier MUTE-IN (pin 23). The
detected noise is integrated with the Cpeak ca-
pacitor connected to MUTE-INT pin. The DC volt-
age on this pin follows the amplitude of the noise.
相關PDF資料 |
PDF描述 |
|---|---|
| TSH511CF | HiFi stereo/mono infrared receiver Stereo sub-carrier demodulator |
| TSH511CFT | HiFi stereo/mono infrared receiver Stereo sub-carrier demodulator |
| TSH512 | HiFi stereo/mono infrared transmitter Stereo sub-carrier generator |
| TSH512C | HiFi stereo/mono infrared transmitter Stereo sub-carrier generator |
| TSH512CF | HiFi stereo/mono infrared transmitter Stereo sub-carrier generator |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TSH511CF | 功能描述:射頻接收器 Op Amp w/Standby RoHS:否 制造商:Skyworks Solutions, Inc. 類型:GPS Receiver 封裝 / 箱體:QFN-24 工作頻率:4.092 MHz 工作電源電壓:3.3 V 封裝:Reel |
| TSH511CFT | 功能描述:音頻發(fā)送器、接收器、收發(fā)器 Hi Fi stereo mono infrared transmitter RoHS:否 制造商:Cirrus Logic 工作電源電壓:3.3 V, 5 V 電源電流:11.8 mA 通道數量:1 最大工作溫度:+ 70 C 接口類型:I2C, SPI 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-28 封裝: |
| TSH511CYFT | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Hi-fi stereo/mono infrared receiver and stereo sub-carrier demodulator |
| TSH512 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Hi-fi stereo/mono infrared transmitter and stereo sub-carrier generator |
| TSH512_09 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Hi-fi stereo/mono infrared transmitter and stereo sub-carrier generator |
發(fā)布緊急采購，3分鐘左右您將得到回復。