- 您現在的位置：買賣IC網 > PDF目錄373736 > TSH511CFT (意法半導體) HiFi stereo/mono infrared receiver Stereo sub-carrier demodulator PDF資料下載
參數資料
| 型號： | TSH511CFT |
| 廠商： | 意法半導體 |
| 英文描述： | HiFi stereo/mono infrared receiver Stereo sub-carrier demodulator |
| 中文描述： | 高保真立體聲/單聲道立體聲紅外線接收副載波解調器 |
| 文件頁數： | 16/18頁 |
| 文件大?。?/td> | 1172K |
| 代理商： | TSH511CFT |
TSH511
16/18
The comparator and the C
MUTE
capacitor gener-
ate the fade-in and fade-out control ramps for the
audio buffers. The Squelch has been designed
with particular attention to avoid audio pop-noise.
Figure 6 :
Squelch schematic
The squelch section is driven by the receiver RX1
but controls both audio buffers.
Audio Buffer sections
The audio signal from a FM demodulator enters
into the 6dB/octave low-pass filter for de-empha-
sis. 50μs and 75μs are standard de-emphasis val-
ues.
After the de-emphasis network, the potentiometer
controls the volume.
The Rail-to-Rail output stage of each Audio Buffer
is able to drive 20 mW into 16
at 2.3V supply
voltage. In this condition, the distortion is typically
0.3% before saturation.
The Audio Buffers can also drive the other usual
impedances used in audio: 32
, 600
and 10k
(see the corresponding distorsion curves).
The high input impedances of the Audio Buffers
reduce the coupling capacitors to less than 0.1 μF
allowing space and cost saving.
Standby section
Depending on the states of the logic inputs SBY1
and SBY2, RX2 and the Audio Buffer2 can be
disabled separately. The TSH511 receiver can
adapt to different applications by using SBY1 &
SBY2 standby pins:
In the standard stereo mode, the configuration is:
SBY1 = SBY2 = ’Low’
In mono mode with one load(example: a single
loadspeaker), RX2 and Audio Buffer 2 are
disabled, the configuration is SBY1 = SBY2 =
’High’.
In mono mode with a stereo load (example: a
stereo headphone), the configuration is SBY1 =
’high’, SBY2 = ’Low’.
A pin connected to Vcc is at ’High’ state, and if
connected to GND is at ’Low’ state.
SBY1
pin 32
SBY2
pin 31
RX1 &
audio
buffer1
RX2
audio
buffer 2
typical
use
Low
Low
ON
ON
ON
stereo
Low
High
High
Low
ON
OFF
ON
mono on
the two
outputs
High
High
ON
OFF
OFF
mono on
one out-
put
相關PDF資料 |
PDF描述 |
|---|---|
| TSH512 | HiFi stereo/mono infrared transmitter Stereo sub-carrier generator |
| TSH512C | HiFi stereo/mono infrared transmitter Stereo sub-carrier generator |
| TSH512CF | HiFi stereo/mono infrared transmitter Stereo sub-carrier generator |
| TSH512CFT | HiFi stereo/mono infrared transmitter Stereo sub-carrier generator |
| TSH691ID | LOW COST 40MHz - 1GHz AMPLIFIER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TSH511CYFT | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Hi-fi stereo/mono infrared receiver and stereo sub-carrier demodulator |
| TSH512 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Hi-fi stereo/mono infrared transmitter and stereo sub-carrier generator |
| TSH512_09 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Hi-fi stereo/mono infrared transmitter and stereo sub-carrier generator |
| TSH512C | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:HiFi stereo/mono infrared transmitter Stereo sub-carrier generator |
| TSH512CF | 功能描述:音頻 DSP Dual FM Transmitter RoHS:否 制造商:Texas Instruments 工作電源電壓: 電源電流: 工作溫度范圍: 安裝風格: 封裝 / 箱體: 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。