- 您現在的位置：買賣IC網 > PDF目錄365984 > TSOP1740SK1 OPTOELECTRONIC CONTROLLER PDF資料下載
參數資料
| 型號： | TSOP1740SK1 |
| 英文描述： | OPTOELECTRONIC CONTROLLER |
| 中文描述： | 光電控制器 |
| 文件頁數： | 3/7頁 |
| 文件大?。?/td> | 84K |
| 代理商： | TSOP1740SK1 |
TSOP17..SK1
Vishay Telefunken
3 (7)
Rev. 6, 07-Mar-00
www.vishay.com
Document Number 82041
Suitable Data Format
The circuit of the TSOP17..SK1 is designed in that
way that unexpected output pulses due to noise or
disturbance signals are avoided. A bandpassfilter, an
integrator stage and an automatic gain control are
used to suppress such disturbances.
The distinguishing mark between data signal and
disturbance signal are carrier frequency, burst length
and duty cycle.
The data signal should fullfill the following condition:
Carrier frequency should be close to center
frequency of the bandpass (e.g. 38kHz).
Burst length should be 10 cycles/burst or longer.
After each burst which is between 10 cycles and 70
cycles a gap time of at least 14 cycles is neccessary.
For each burst which is longer than 1.8ms a
corresponding gap time is necessary at some time in
the data stream. This gap time should have at least
same length as the burst.
Up to 1400 short bursts per second can be received
continuously.
Some examples for suitable data format are:
NEC Code, Toshiba Micom Format, Sharp Code, RC5
Code, RC6 Code, R–2000 Code, Sony Format
(SIRCS).
When a disturbance signal is applied to the
TSOP17..SK1 it can still receive the data signal.
However the sensitivity is reduced to that level that no
unexpected pulses will occure.
Some examples for such disturbance signals which
are suppressed by the TSOP17..SK1 are:
DC light (e.g. from tungsten bulb or sunlight)
frequency
Continuous signal at 38kHz or at any other
ballast (an example of the signal modulation is in the
figure below).
Signals from fluorescent lamps with electronic
0
5
10
15
20
time [ms]
IR Signal from Fluorescent Lamp with low Modulation
相關PDF資料 |
PDF描述 |
|---|---|
| TSOP1756SK1 | OPTOELECTRONIC CONTROLLER |
| TSOP1830ON | OPTOELECTRONIC CONTROLLER |
| TSOP1830PM | TRANSISTOR-STAGE OUTPUT PHOTO IC |
| TSOP1830QJ | TRANSISTOR-STAGE OUTPUT PHOTO IC |
| TSOP1833ON | OPTOELECTRONIC CONTROLLER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TSOP1740TB1 | 制造商:VISHAY 制造商全稱:Vishay Siliconix 功能描述:Photo Modules for PCM Remote Control Systems |
| TSOP1740UU1 | 制造商:VISHAY 制造商全稱:Vishay Siliconix 功能描述:Photo Modules for PCM Remote Control Systems |
| TSOP1740WI1 | 制造商:VISHAY 制造商全稱:Vishay Siliconix 功能描述:Photo Modules for PCM Remote Control Systems |
| TSOP1740XG1 | 制造商:VISHAY 制造商全稱:Vishay Siliconix 功能描述:Photo Modules for PCM Remote Control Systems |
| TSOP1756 | 制造商:Vishay Intertechnologies 功能描述: 制造商:Vishay Semiconductors 功能描述:IR Emitting Diode |
發布緊急采購，3分鐘左右您將得到回復。