參數資料
型號： TUA6026-S
廠商： INFINEON TECHNOLOGIES AG
元件分類： 調諧器
英文描述： 2-BAND, VIDEO TUNER, PDSO28
封裝： 1 MM HEIGHT, PLASTIC, TSSOP-28
文件頁數： 3/30頁
文件大?。?/td> 381K
代理商： TUA6026-S
TUA 6026
Semiconductor Group
11
1998-09-01
The software-switched ports P0, P1, and P2 are general-purpose open-collector
outputs. The test bit T1 = 1, switches the test signals
f
ref (4 MHz / 64) and Cy (divided
input signal) to P0 and P1 respectively. P0, P1 are bidirectional.
The lock detector resets the lock flag FL when the width of the charge pump current
pulses is greater than the period of the crystal oscillator (i.e. 250 ns). Hence, when
FL = 1, the maximum deviation of the input frequency from the programmed frequency
is given by
f = ±I
P (KVCO / fQ) (C1 + C2) / (C1C2)
where
I
P is the charge pump current, KVCO the VCO gain, fQ the crystal oscillator
frequency and
C
1, C2 the capacitances in the loop filter (see ”Application Circuits” on
page 26). As the charge pump pulses at 62.5 kHz (=
f
ref), it takes a maximum of 16 s
for FL to be reset after the loop has lost lock state.
Once FL has been reset, it is set only if the charge pump pulse width is less than 250 ns
for eight consecutive
f
ref periods. Therefore it takes between 128 and 144 s for FL to be
set after the loop regains lock.
2.3
I2C-Bus Interface
Data is exchanged between the processor and the PLL via the
I
2C Bus. The clock is
generated by the processor (input SCL), while pin SDA functions as an input or output
depending on the direction of the data (open collector, external pull-up resistor). Both
inputs have hysteresis and a low-pass characteristic, which enhance the noise immunity
of the
I
2C Bus.
The data from the processor pass through an
I
2C-Bus controller. Depending on their
function the data are subsequently stored in registers. If the bus is free, both lines will be
in the marking state (SDA, SCL are HIGH). Each telegram begins with the start condition
and ends with the stop condition. Start condition: SDA goes LOW, while SCL remains
HIGH. Stop condition: SDA goes HIGH while SCL remains HIGH. All further information
transfer takes place during SCL = LOW, and the data is forwarded to the control logic on
the positive clock edge.
The table ”Bit Allocation” (see ”Bit Allocation Read/Write” on page 12) should be referred
to the following description. All telegrams are transmitted byte-by-byte, followed by a
ninth clock pulse, during which the control logic returns the SDA line to LOW
(acknowledge condition). The first byte is comprised of seven address bits. These are
used by the processor to select the PLL from several peripheral components (chip
select). The LSB bit (R/W) determines whether data are written into (R/W = 0) or read
from (R/W = 1) the PLL.
In the data portion of the telegram during a WRITE operation, the MSB bit of the first or
third data byte determines whether a divider ratio or control information is to follow. In
相關PDF資料
PDF描述
TUA6028XS 2-BAND, VIDEO TUNER, PDSO28
TUA6028-S 2-BAND, VIDEO TUNER, PDSO28
TUA6028-K 2-BAND, VIDEO TUNER, PDSO28
TUA6028XS 2-BAND, VIDEO TUNER, PDSO28
TUA6028-S 2-BAND, VIDEO TUNER, PDSO28
相關代理商/技術參數
參數描述
TUA6030 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:3-Band TV Tuner IC
TUA6032 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:3-Band TV Tuner IC
TUA6034 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:3-Band Digital TV / Set-Top-Box Tuner IC TAIFUN
TUA6034_06 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:3-Band Digital TV / Set-Top-Box Tuner IC TAIFUN
TUA6034DEMOBOARD 制造商:Infineon Technologies AG 功能描述:
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*