- 您現在的位置：買賣IC網 > PDF目錄376435 > UPD75P238GJ-5BG (NEC Corp.) RECTIFIER BRIDGE 1A 1000V 50A-ifsm 1.1V-vf 10uA-ir DFM 50/TUBE PDF資料下載
參數資料
| 型號： | UPD75P238GJ-5BG |
| 廠商： | NEC Corp. |
| 英文描述： | RECTIFIER BRIDGE 1A 1000V 50A-ifsm 1.1V-vf 10uA-ir DFM 50/TUBE |
| 中文描述： | 4位單片機 |
| 文件頁數： | 39/40頁 |
| 文件大小： | 320K |
| 代理商： | UPD75P238GJ-5BG |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁當前第39頁第40頁
39
μ
PD75P048
NOTES FOR CMOS DEVICES
1
PRECAUTION AGAINST ESD FOR SEMICONDUCTORS
Note: Strong electric field, when exposed to a MOS device, can cause destruction of
the gate oxide and ultimately degrade the device operation. Steps must be
taken to stop generation of static electricity as much as possible, and quickly
dissipate it once, when it has occurred. Environmental control must be
adequate. When it is dry, humidifier should be used. It is recommended to
avoid using insulators that easily build static electricity. Semiconductor
devices must be stored and transported in an anti-static container, static
shielding bag or conductive material. All test and measurement tools including
work bench and floor should be grounded. The operator should be grounded
using wrist strap. Semiconductor devices must not be touched with bare
hands. Similar precautions need to be taken for PW boards with semiconductor
devices on it.
2
HANDLING OF UNUSED INPUT PINS FOR CMOS
Note: No connection for CMOS device inputs can be cause of malfunction. If no
connection is provided to the input pins, it is possible that an internal input
level may be generated due to noise, etc., hence causing malfunction. CMOS
devices behave differently than Bipolar or NMOS devices. Input levels of CMOS
devices must be fixed high or low by using a pull-up or pull-down circuitry. Each
unused pin should be connected to V
DD
or GND with a resistor, if it is considered
to have a possibility of being an output pin. All handling related to the unused
pins must be judged device by device and related specifications governing the
devices.
3
STATUS BEFORE INITIALIZATION OF MOS DEVICES
Note: Power-on does not necessarily define initial status of MOS device. Production
process of MOS does not define the initial operation status of the device.
Immediately after the power source is turned ON, the devices with reset
function have not yet been initialized. Hence, power-on does not guarantee
out-pin levels, I/O settings or contents of registers. Device is not initialized
until the reset signal is received. Reset operation must be executed immedi-
ately after power-on for devices having reset function.
相關PDF資料 |
PDF描述 |
|---|---|
| UPD75P0016GB-3BS-MTX | RECTIFIER BRIDGE 1.5A 100V 50A-ifsm 1V-vf 5uA-ir WOG 1K/BULK |
| UPD75P0116GB-3BS-MTX | RECTIFIER BRIDGE 1.5A 200V 50A-ifsm 1V-vf 5uA-ir WOG 1K/BULK |
| UPD75P66G-511 | 4-Bit, Single-Chip, One-Time Programmable (OTP) CMOS Microcomputer With Comparator |
| UPD75P56CS-001 | 4-Bit, Single-Chip, One-Time Programmable (OTP) CMOS Microcomputer With Comparator |
| UPD75P66CS-001 | 4-Bit, Single-Chip, One-Time Programmable (OTP) CMOS Microcomputer With Comparator |
相關代理商/技術參數 |
參數描述 |
|---|---|
| UPD75P3018AGC-8BT-A | 制造商:Renesas Electronics Corporation 功能描述:MCU 4BIT 75XL CISC 32KB EPROM 2.5V/3.3V/5V 80PQFP - Trays 制造商:Renesas Electronics 功能描述:75XL 6MHz Cut Tape 制造商:Renesas 功能描述:MCU 4-bit 75XL CISC 32KB EPROM 2.5V/3.3V/5V 80-Pin PQFP |
| UPD75P3018AGK-BE9 | 制造商:Renesas Electronics Corporation 功能描述: |
| UPD75P3036GC-3B9-A | 制造商:Renesas Electronics Corporation 功能描述: |
| UPD75P308GF-3B9 | 制造商:Renesas Electronics Corporation 功能描述:MCU 4-Bit 75XL CISC 8064Byte PROM 5V 80-Pin PQFP |
| UPD75P308GF-3BA | 制造商:Renesas Electronics Corporation 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。