- 您現在的位置：買賣IC網 > PDF目錄383985 > USB20H04-JD (STANDARD MICROSYSTEMS CORP) 4-PORT USB2.0 HUB CONTROLLER PDF資料下載
參數資料
| 型號： | USB20H04-JD |
| 廠商： | STANDARD MICROSYSTEMS CORP |
| 元件分類： | 總線控制器 |
| 英文描述： | 4-PORT USB2.0 HUB CONTROLLER |
| 中文描述： | UNIVERSAL SERIAL BUS CONTROLLER, PQFP64 |
| 封裝： | 10 X 10 MM, 1.40 MM THICKNESS, TQFP-64 |
| 文件頁數： | 27/38頁 |
| 文件大小： | 919K |
| 代理商： | USB20H04-JD |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁當前第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁
4-Port USB2.0 Controller
Datasheet
SMSC USB20H04
Page 27
Revision 1.63 (10-14-04)
DATASHEET
Table 8.6 - Default Configuration Values
REGISTER
ADDRESS
REGISTER NAME
SELF-POWERED
DEFAULT (HEX)
BUS-POWERED
DEFAULT (HEX)
01h
02h
03h
04h
05h
06h
07h
08h
09h
0Ah
0Bh
0Ch
VID MSB
VID LSB
PID MSB
PID LSB
DID MSB
DID LSB
Config Data Byte 3
Config Data Byte 2
Config Data Byte 1
Max Power
Hub Controller Max Current
Power-on Time
04
24
**
00
00
00
58
00
05
00
00
80
04
24
**
00
00
00
98
08
05
64
64
80
** The default PID value is dependent on the silicon revision.
8.4
Reset
There are two different resets that the USB20H04 will experience. One is a hardware reset (via the
RESET_N pin) and the second a USB Reset.
8.4.1
External Hardware Reset
A valid hardware reset is initiated by the assertion of RESET_N for a minimum of 100ns after all power
supplies are within operating range.
Assertion of RESET_N (external pin) causes the following:
1. All downstream ports are disabled, and V
BUS
power to downstream devices is removed.
2. The PHYs are disabled, and the differential pairs will be in a high-impedance state
3. All transactions immediately terminate, and no states are saved.
4. All internal registers return to the default state (in most cases, 00(h)).
5. LED indicators are disabled
After RESET_N is negated, the USB20H04 is ready to be configured as an SMBus slave (if SMB_SEL_N
= 0) or it reads OEM specific data from the external EEPROM (if SMB_SEL_N = 1). Default values for
configuration data are loaded if the SELF ONLY default strapping option is selected, or if an EEPROM is
not present. The timing associated with these options is shown in the tables below.
相關PDF資料 |
PDF描述 |
|---|---|
| USB20H04-JT | 4-PORT USB2.0 HUB CONTROLLER |
| USB20H04 | 4-PORT USB2.0 HUB CONTROLLER |
| USB2223-03 | BUS POWERED USB 2.0 FLASH MEDIA CONTROLLER |
| USB2223-NE-03 | BUS POWERED USB 2.0 FLASH MEDIA CONTROLLER |
| USB2223-NU-03 | BUS POWERED USB 2.0 FLASH MEDIA CONTROLLER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| USB20H04-JT | 制造商:Rochester Electronics LLC 功能描述:- Tape and Reel |
| USB20H04-JT-E6 | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| USB20X2GY | 制造商:Hubbell Wiring Device-Kellems 功能描述:Hubbell USB20X2GY NEMA 5-15R AC Duplex Receptacle w/2USB Ports - Gray 20 amp 制造商:Hubbell Wiring Device-Kellems 功能描述:USB CHARGER RECEPTACLE, 20A, 125VAC, GREY; Connector Type:Electrical AC Receptacle, USB Charger; Series:-; Current Rating:20A; Connector Color:Grey; Connector Body Material:-; Voltage Rating VAC:125V |
| USB20X2I | 制造商:Hubbell Wiring Device-Kellems 功能描述:Hubbell USB20X2I NEMA 5-15R AC Duplex Receptacle w/2USB Ports - Ivory 20 amp 制造商:Hubbell Premise Wiring 功能描述:USB CHARGER RECEPTACLE 20A 1 制造商:Hubbell Wiring Device-Kellems 功能描述:USB CHARGER RECEPTACLE, 20A, 125VAC, IVO 制造商:Hubbell Wiring Device-Kellems 功能描述:USB CHARGER RECEPTACLE, 20A, 125VAC, IVORY; Connector Type:Electrical AC Receptacle, USB Charger; Series:-; Current Rating:20A; Connector Color:Ivory; Connector Body Material:-; Voltage Rating VAC:125V |
| USB20X2LA | 制造商:Hubbell Wiring Device-Kellems 功能描述:Hubbell USB20X2LA NEMA 5-15R AC Duplex Receptacle w/2USB Ports - Light Almond 20 |
發布緊急采購，3分鐘左右您將得到回復。