- 您現在的位置：買賣IC網 > PDF目錄361604 > UTCL6726 (友順科技股份有限公司) UNIVERSAL SPEECH CIRCUIT PDF資料下載
參數資料
| 型號： | UTCL6726 |
| 廠商： | 友順科技股份有限公司 |
| 英文描述： | UNIVERSAL SPEECH CIRCUIT |
| 中文描述： | 通用語音電路 |
| 文件頁數： | 8/12頁 |
| 文件大小： | 196K |
| 代理商： | UTCL6726 |
UTC L6726 LINEAR INTEGRATED CIRCUIT
UTC
UNISONIC TECHNOLOGIES CO., LTD.
8
QW-R108-015,A
resistors R4 and R5 must not be less than 35 k
because of DC-current to ground. Below is some simple variations
of this network. (See figure 7).
DC-characteristics (R6):
Sets the DC-characteristic and take care of some of the supplied power. The resistor have also function with the
protection of the circuit, the transmitter, the gain regulation and side tone. Common values are 47
to 100
.
Side tone level, receiving gain and frequency response.(R7,R8,R9,R10,R11,C5):
The network sets the side tone balance. The network in the application is one of many possibilities. R10 and R11
balance together the signals that go two different ways from the transmitter output stage one from pin1 and the other
from pin2. The balance network consist of R8, R9 and C5.
The example is not optimized to any specified line, it is only given to show the principle.
Fig8, 9 and 10 are examples of balance networks. Fig.10 is especially suited for lines with high current supply.
R12, R13, C6, (R10, R11):
The networks gives the gain and frequency response for the receiver.
Input impedance at pin 15 is about 38 k
with a typical variation of
±
20%.For different possibilities for the design
of the network, see the network for the transmitter (R4, R5, C3)
REC, R14:
R14 generates the output impedance to the magnetic earphone (fig.11). If a dynamic earphone is used it should
be placed between pin 17 and 18.See figure 16.
R15:
This resistor is used to set the driving capability of the receiver output amplifier. Common values are 0
to 50
.
Setting it for low driving capability results in function at lower line current. Breaking up pin 16 will give lower power
consumption and total mute of the receiver when muting the circuit. Disconnecting pin 15 will of cause also give total
receiver mute.
D1, D2, D3, D4, D5:
Rectifier bridge and over voltage protector. The zener voltage at D5 should be as low as possible. Common values
are between 12V~16V.
R
DC1
, R
DC2
:
Refer to figure 5.
The pre-set output voltage of 2.35V can easily, if needed, be changed to another value by applying one or two
resistor(R
DC1
,R
DC2
) in parallel with the internal resistors (each 15k
+/-20%).It is possible to get a rather high
voltage and current from the DC-supply as long as the high current and voltage is available from the line. The DC
voltage has to be filtered by a capacitor and this can, at high DC-voltage and low line current, interfere with the
signal on the line and cause distortion. You can minimize the interference, with a resistor in series with the filter
capacitor. The DC voltage will, of course, be more dependent of the DC-supply current. The DC-output pin has a
very low input leak current, to allow stand-by feeding of the dialer. It is also possible to use pin 9 to feed
microphones etc. that do not need stand-by feeding, without interfering with the stand-by feeding on pin 8. Note that
a high current consumption by the external device will alter the DC characteristics of the speech circuit
相關PDF資料 |
PDF描述 |
|---|---|
| UTCL8115 | FET BIAS CONTROLLER WITH POLARISATION SWITCH AND TONE DETECTION |
| UTCLAG665F | RADIO AND CASSETTE RECORDER CIRCUIT |
| UTCLAG668 | RADIO AND CASSETTE RECORDER CIRCUIT |
| UTCLD1117 | 5.0 AMP POSITIVE VOLTAGE REGULATOR |
| UTCLD1117A | 5.0 AMP POSITIVE VOLTAGE REGULATOR |
相關代理商/技術參數 |
參數描述 |
|---|---|
| UTCL8115 | 制造商:UTC-IC 制造商全稱:UTC-IC 功能描述:FET BIAS CONTROLLER WITH POLARISATION SWITCH AND TONE DETECTION |
| UTC-LAG665 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:The UTC LAG665F is a monolithic integrated circuit,designed for portable radio cassette. |
| UTCLAG665F | 制造商:UTC-IC 制造商全稱:UTC-IC 功能描述:RADIO AND CASSETTE RECORDER CIRCUIT |
| UTCLAG668 | 制造商:UTC-IC 制造商全稱:UTC-IC 功能描述:RADIO AND CASSETTE RECORDER CIRCUIT |
| UTC-LAG668 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:The UTC LAG668 is a monolithic integrated circuit, designed for portable radio cassette. |
發(fā)布緊急采購，3分鐘左右您將得到回復。