- 您現在的位置：買賣IC網 > PDF目錄359382 > VK05CFL (意法半導體) ELECTRONIC DRIVER FOR CFL APPLICATION PDF資料下載
參數資料
| 型號： | VK05CFL |
| 廠商： | 意法半導體 |
| 英文描述： | ELECTRONIC DRIVER FOR CFL APPLICATION |
| 中文描述： | 電子節能燈驅動的應用 |
| 文件頁數： | 7/14頁 |
| 文件大小： | 310K |
| 代理商： | VK05CFL |
7/14
VK05CFL
Secondary Filter Design
The design of RC network applied on the sec pin of both devices has to be done taking into account the
following considerations:
1) The sec filtered voltage must reach the device ON threshold at the end of the negative dV/dt and before
the end of the freewheeling diode conduction in order to avoid hard switching or switching ON delay.
2) The filtered voltage must be high enough (greater than 5V) at the end of T
on
in order to guarantee the
device supply voltage.
A good choice for time constant (
τ
=RC) is in the range:1.5
μ
s
÷
3.3
μ
s.
The resistor value has chosen in relation to the power dissipated on it during the start-up phase, the worst
condition is verified when the preheating is used.
Tube pre-heating
By using the VK05CFL, the tube pre-heating can be done with the classical solution with PTC (see
application schematic in figure 1) or with a more reliable low voltage network (see figure 5b). The pre-
heating low voltage network allows to obtain an optimum pre-heating avoiding the overstress on the PTC
thus improving the ballast reliability and the lamp life-time.
Figure 5a:
Pre-heating phase with PTC
APPLICATION BOARD
Please note that this demo can be used for Europe (230Vrms) market as well as for USA (110Vrms)
market.
In order to use the demoboard for Europe market the following modification must be done: electrolytic
capacitors C1 and C12 must be replaced with only one electrolytic capacitor Cx = 3,3
μ
F/400V connected
with the positive pin on the D1 catode and the negative pin on the D3 anode. Also different power range
CFL can be driven by using this demoboard; on the left side of the component list reported below you find
component values able to drive CFL in the power range 5W to 15W, the component values written in
brackets in the table on the right are referred to the power range 15W to 23W.
sec
VK05CFL
Low side
osc
VK05CFL
High side
+10
μ
39K
1.2n
I
osc
1M
+10
μ
39K
1.2n
I
osc
1M
sec
osc
I
lamp
Figure 5b:
Pre-heating low voltage network
相關PDF資料 |
PDF描述 |
|---|---|
| VK06TL | ELECTRONIC DRIVER FOR TL BALLASTS |
| VK06TL13TR | ELECTRONIC DRIVER FOR TL BALLASTS |
| VK06TLS | ELECTRONIC DRIVER FOR TL BALLASTS |
| VK501A | 8-BIT UNIVERSAL BUS TRANSCEIVER AND TWO 1-BIT BUS TRANSCEIVERS WITH SPLIT LVTTL PORT, FEEDBACK PATH, AND 3-STATE OUTPUTS |
| VKA100LS02 | 100 WATT SINGLE OUTPUT HALF BRICK DC/DC CONVERTER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| VK05CFL_03 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:ELECTRONIC DRIVER FOR CFL APPLICATION |
| VK05CFL13TR | 制造商:STMicroelectronics 功能描述: |
| VK05CFL-E | 功能描述:功率驅動器IC Electronic Driver CDF Application RoHS:否 制造商:Micrel 產品:MOSFET Gate Drivers 類型:Low Cost High or Low Side MOSFET Driver 上升時間: 下降時間: 電源電壓-最大:30 V 電源電壓-最小:2.75 V 電源電流: 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube |
| VK05CFLTR-E | 功能描述:功率驅動器IC ELECTRONIC DRIVER RoHS:否 制造商:Micrel 產品:MOSFET Gate Drivers 類型:Low Cost High or Low Side MOSFET Driver 上升時間: 下降時間: 電源電壓-最大:30 V 電源電壓-最小:2.75 V 電源電流: 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube |
| VK06TL | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:ELECTRONIC DRIVER FOR TL BALLASTS |
發布緊急采購，3分鐘左右您將得到回復。