參數資料
型號： VV6410C036
廠商： STMICROELECTRONICS
元件分類： 模擬信號調理
英文描述： SPECIALTY ANALOG CIRCUIT, CQCC36
封裝： LCC-36
文件頁數： 7/63頁
文件大?。?/td> 563K
代理商： VV6410C036
Version 3.4
15/63
STV0680B + VV6444/6410/6500
Detailed features
2.6
Anti-flicker exposure and gain control
2.6.1
General
The chipset operates automatic exposure and gain control for either 50Hz or 60Hz mains-driven
indoor lighting, using the same 12MHz crystal. This improves picture quality by selecting a set of
exposure values which minimise ‘flicker’ effects. Detection of the mains frequency is dependant on
the status of the GPIO3 pin, which can be achieved by population of a PCB link at a late stage in
production, once the country of destination is known, without the need to change the crystal
frequency.
The auto exposure and gain algorithm is always enabled during Snapshot’/self-timer/continuous
mode. When the shutter button is pressed in ‘Snapshot’ mode, the chipset captures an image if the
exposure and gain value has reached a suitable value for the current scene. If the light detected has
suddenly changed, the camera may emit an audible tone to indicate that more time is required to
reach the correct exposure target. In ‘Snapshot’ mode the chipset only captures the image data if
sufficient light is present in the image. In continuous capture mode, the chipset captures images
regardless of whether enough light is present.
The exposure control algorithm in STV0680B chooses exposure values which minimise “flicker”
effects from occurring under fluorescent lighting. STV0680B can only prevent flicker in lighting
powered by 50Hz or 60Hz electricity supply, but automatic detection of the flicker frequency is not
possible. Hence choosing the correct anti-flicker setting is important, in order to prevent dark stripes
form appearing across the image, and this selection must be done in hardware.
Figure 2 : Illustration of flicker problem
2.6.2
Flashgun exposure
Where STV0680B-003 and a flashgun module are included in the camera, and the flashgun enable
signal is HIGH, the exposure mode will operate in a different manner. The CMOS sensor
progressive scan readout requires that the sensor is set to maximum exposure so that all lines are
being exposed at a certain point in time.
The “window” within which the flashgun needs to fire in order to correctly expose all sensor lines is
of the order of a few 100sec (contact ST for more precise details), therefore the flashgun module
design should have reached maximum light output within this period after the falling edge of the
flash trigger output from STV0680B-003.
Possible flashgun implementations, regarding hardware interface, charge sensing, and flash
energy required are discussed in a separate application note AN1312 regarding flashgun
implementation, available from ST.
Flicker setting not correct
Flicker setting correct
相關PDF資料
PDF描述
VVZ70-16IO7 THYRISTOR MODULE|3-PH FULL-WAVE|HALF-CNTLD|CC|1.6KV V(RRM)|70A I(T)
VWA-0 Female Disconnect; Tab Width:0.250"
PBT-4B BRASS, TAB TERMINAL
PBT-4A 1.5 mm2, BRASS, PUSH-ON TERMINAL
VWO85-14IO1 THYRISTOR MODULE|AC SWITCH|TRIPLE|FULLY-CNTLD|1.4KV V(RRM)|27A I(T)
相關代理商/技術參數
參數描述
VV6411 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:DUAL-MODE DIGITAL CAMERA CO-PROCESSOR
VV6411C036 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:DUAL-MODE DIGITAL CAMERA CO-PROCESSOR
VV64200-000 制造商:Carling Technologies 功能描述:V-SERIES ROCKER SWITCH - Bulk
VV64400-000 制造商:Carling Technologies 功能描述:V-SERIES ROCKER SWITCH - Bulk
VV64413-000 制造商:Carling Technologies 功能描述:V-SERIES ROCKER SWITCH - Bulk
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*