- 您現在的位置：買賣IC網 > PDF目錄371191 > X1288V14I-4.5A RTC Module With CPU Supervisor PDF資料下載
參數資料
| 型號： | X1288V14I-4.5A |
| 元件分類： | CPU監測 |
| 英文描述： | RTC Module With CPU Supervisor |
| 中文描述： | 時鐘模塊CPU監控 |
| 文件頁數： | 27/31頁 |
| 文件大?。?/td> | 560K |
| 代理商： | X1288V14I-4.5A |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁當前第27頁第28頁第29頁第30頁第31頁
27 of 31
REV 1.1.30 3/24/04
www.xicor.com
Preliminary Information
X1288
scope probe, there will be no useful information in that
waveform other than the fact that the circuit is oscillat-
ing. The X2 output is sensitive to capacitive impedance
so the voltage levels and the frequency will be affected
by the parasitic elements in the scope probe. Applying
a scope probe can possibly cause a faulty oscillator to
start up, hiding other issues (although in the Xicor
RTC’s, the internal circuitry assures startup when
using the proper crystal and layout).
The best way to analyze the RTC circuit is to power it
up and read the real time clock as time advances, or if
the chip has the PHZ output, look at the output of that
pin on an oscilloscope (after enabling it with the control
register, and using a pullup resistor for an open-drain
output). Alternatively, the X1226/1286/1288 devices
have an IRQ- output which can be checked by setting
an alarm for each minute. Using the pulse interrupt
mode setting, the once-per-minute interrupt functions
as an indication of proper oscillation.
Backup Battery Operation
Many types of batteries can be used with the Xicor
RTC products. 3.0V or 3.6V Lithium batteries are
appropriate, and sizes are available that can power a
Xicor RTC device for up to 10 years. Another option is
to use a supercapacitor for applications where Vcc may
disappear intermittently for short periods of time.
Depending on the value of supercapacitor used,
backup time can last from a few days to two weeks
(with >1F). A simple silicon or Schottky barrier diode
can be used in series with Vcc to charge the superca-
pacitor, which is connected to the Vback pin. Do not
use the diode to charge a battery (especially lithium
batteries!).
Figure 20. Supercapactor charging circuit
Since the battery switchover occurs at Vcc=Vback-
0.1V (see Figure 20), the battery voltage must always
be lower than the Vcc voltage during normal operation
or the battery will be drained. A second consideration
is the trip point setting for the system RESET- function,
known as Vtrip. Vtrip is set at the factory at levels for
systems with either Vcc = 5V or 3.3V operation, with
the following standard options:
V
TRIP
= 4.63V ± 3%
V
TRIP
= 4.38V ± 3%
V
TRIP
= 2.85V ± 3%
V
TRIP
= 2.65V ± 3%
The summary of conditions for backup battery opera-
tion is given in Table 9:
2.7-5.5V
Supercapacitor
V
SS
V
CC
V
back
Table 9. Battery Backup Operation
1. Example Application, Vcc=5V, Vback=3.0V
Condition
a. Normal Operation
b. Vcc on with no battery
c. Backup Mode
*since Vback>2.65V is higher than Vtrip, the battery is powering the entire device
Vcc
5.00
5.00
0–1.8
Vback
3.00
0
1.8-3.0
Vtrip
4.38
4.38
4.38
Iback
<<1μA
0
<2μA
Reset
H
H
L
Notes
Timekeeping
only
2. Example Application, Vcc=3.3V,Vback=3.0V
Condition
a. Normal Operation
b. Vcc on with no battery
c. Backup Mode
Vcc
3.30
3.30
0–1.8
Vback
3.00
0
1.8–3.0*
Vtrip
2.65
2.65
2.65
Iback
<<1μA
0
<2μA*
Reset
H
H
L
Timekeeping
only
Internal
Vcc=Vback
d. UNWANTED - Vcc ON, Vback
powering
2.65 - 3.30
> Vcc
2.65
up to 3mA
H
相關PDF資料 |
PDF描述 |
|---|---|
| X2004DM-25 | 40V Single N-Channel HEXFET Power MOSFET in a D-Pak package; Similar to IRFR4104 with Lead Free Packaging |
| X2004DMB | 25V Single N-Channel HEXFET Power MOSFET in a D-Pak package; A IRLR8715CPBF with Standard Packaging |
| X2004DMB-25 | 100V Single N-Channel HEXFET Power MOSFET in a SOT-223 package; A IRFL4310 with Standard Packaging |
| X2004EM | NVRAM (EEPROM Based) |
| X2004EM-25 | NVRAM (EEPROM Based) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| X1288V14IT1 | 功能描述:IC RTC/CAL/CPU SUP EE 14-TSSOP RoHS:否 類別:集成電路 (IC) >> 時鐘/計時 - 實時時鐘 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:- 類型:時鐘/日歷 特點:警報器，閏年，SRAM 存儲容量:- 時間格式:HH:MM:SS（12/24 小時） 數據格式:YY-MM-DD-dd 接口:SPI 電源電壓:2 V ~ 5.5 V 電壓 - 電源，電池:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-WDFN 裸露焊盤 供應商設備封裝:8-TDFN EP 包裝:管件 |
| X1288V14IZ | 制造商:Rochester Electronics LLC 功能描述: 制造商:Intersil Corporation 功能描述: |
| X1288V14IZ-2.7 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:2-Wire⑩ RTC Real Time Clock/Calendar/CPU Supervisor with EEPROM |
| X1288V14IZ-2.7A | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:2-Wire⑩ RTC Real Time Clock/Calendar/CPU Supervisor with EEPROM |
| X1288V14IZ-4.5A | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:2-Wire⑩ RTC Real Time Clock/Calendar/CPU Supervisor with EEPROM |
發布緊急采購，3分鐘左右您將得到回復。