7005-0.9 5/7/97 T4/C0/D1
Xicor, Inc. 1994, 1995, 1996 Patents Pending
1
Characteristics subject to change without notice
4K
X25F047
512 x 8 Bit
SPI SerialFlash with Block Lock
TM
Protection
FEATURES
1MHz Clock Rate
SPI Modes (0,0 & 1,1)
512 x 8 Bits
—16 Byte Small Sector Program Mode
Low Power CMOS
—<1
μ
A Standby Current
—<3mA Active Current during Program
—<400
μ
A Active Current during Read
1.8V to 3.6V or 5V “Univolt” Read and Program
Power Supply Versions
Block Lock Protection
—Block Lock Protect 0, any 1/4, 1st 1/2, First or
Last Sector of SerialFlash Array
Built-in Inadvertent Program Protection
—Power-Up/Power-Down Protection Circuitry
—Program Enable Latch
—Program Protect Pin
Self-Timed Program Cycle
—5ms Program Cycle Time (Typical)
High Reliability
—Endurance: 100,000 Cycles/Byte
—Data Retention: 100 Years
—ESD: 2000V on all pins
8-Lead SOIC Package
8-Lead MSOP Package
8-Lead TSSOP Package
8-Pin Mini-DIP Package
DESCRIPTION
The X25F047 is a CMOS 4K-bit SerialFlash, internally
organized as 512 x 8. The X25F047 features a Serial
Peripheral Interface (SPI) and software protocol
allowing operation on a simple four-wire bus. The bus
signals are a clock input (SCK) plus separate data in (SI)
and data out (SO) lines. Access to the device is
controlled through a chip select (CS) input, allowing any
number of devices to share the same bus.
There are eight options for programmable, nonvolatile,
Block Lock Protection available to the end user. These
options are implemented via special instructions
programmed to the part. The X25F047 also features a
PP pin that can be used for hardwire protection of the
part, disabling all programming attempts, as well as a
Program Enable Latch that must be set before a program
operation can be initiated.
The X25F047 utilizes Xicor’s proprietary Direct Write
cell, providing a minimum endurance of 100,000 cycles
per sector and a minimum data retention of 100 years.
TM
FUNCTIONAL DIAGRAM
COMMAND
DECODE
AND
CONTROL
LOGIC
PROGRAM CONTROL LOGIC
DATA REGISTER
Y DECODE LOGIC
X
DECODE
LOGIC
HIGH VOLTAGE
CONTROL
SERIALFLASH
ARRAY
(512 x 8)
SO
SI
SCK
CS
PP
8
16
32
7005 FRM 01.3