參數資料
型號： X46402V8E-3.1
元件分類： CPU監測
英文描述： RTC Module With CPU Supervisor
中文描述： 時鐘模塊CPU監控
文件頁數： 15/23頁
文件大?。?/td> 102K
代理商： X46402V8E-3.1
X46402
Preliminary Information
15
Note on Read/Write Operations
Password Protected
(None of the array to
all of the array)
Non- Password Protected
(All of the array to
none of the array)
0000h
1FFFh
P
R
N
R
Notes:
Using a “password read” or a “password write” to a non-password protected area is acceptable, because the pass-
word is received and accepted prior to an address transmission. It is assumed that access to non-password pro-
tected areas is uncontrolled, so either method should work.
Using a “no-password read” or a “no-password write” on a password protected area would not work. Trying to
access a password protected area without the password match causes the device to return a NACK after the
address.
A password sequential read that starts in the password protected area can continue into and through the non-pass-
word protected area. It will not “wrap” back to address ’0’.
A no-password sequential read can only start in the non-password protected area and cannot “wrap” back into the
protected area.
CHANGE PASSWORD COMMAND
When changing a password, the Change Password com-
mand is sent to the device. The old password follows.
When the old password is accepted (as indicated by the
ACK Polling Command sequence), the new password is
sent to the device twice, following two bytes of zero. A
stop bit initiates the store of the new password. To be suc-
cessful in the password change operation the first and
second transmission of the new password must match
and there must be exactly 16 password bytes. If this is not
the case, the operation is aborted and the password
remains unchanged.
PASSWORDS
The sequence in Figure 17 shows how to change (pro-
gram) the passwords. The programming of passwords is
done twice prior to the nonvolatile write cycle in order to
verify that the new password is consistent. After the eight
bytes are entered in the second pass, a comparison takes
place. A mismatch will cause the part to ignore the
change command and enter into the standby mode.
There are two ways to determine whether the operation
was completed successfully. The Data ACK polling
method can determine if a password has been loaded
correctly, however the data ACK command must be
issued less than 2ms after the stop bit. After this time, it
cannot be determined if the password has been loaded
correctly, without trying the new password. To determine if
the new password has been loaded correctly the data
ACK polling command is issued immediately following the
stop bit. If it returns an ACK, then the two passes of the
new password entry do not match. If it returns a “no ACK”
then the passwords match and a high voltage cycle is in
progress. The high voltage cycle is complete when a sub-
sequent data ACK command returns an “ACK”.
相關PDF資料
PDF描述
X46402V8E-3.1A RTC Module With CPU Supervisor
X4643 CPU Supervisor with 64K EEPROM
X4645 CPU Supervisor with 64K EEPROM
X4645S8 CPU Supervisor with 64K EEPROM
X4645S8-2.7 CPU Supervisor with 64K EEPROM
相關代理商/技術參數
參數描述
X4643 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:CPU Supervidor with 64K EEPROM
X4643S8 功能描述:IC CPU SUPRV 64K EE RST LO 8SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 監控器 系列:- 標準包裝:1 系列:- 類型:簡單復位/加電復位 監視電壓數目:1 輸出:開路漏極或開路集電極 復位:低有效 復位超時:標準傳輸延遲為 60 µs 電壓 - 閥值:3V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SC-74A，SOT-753 供應商設備封裝:SOT-23-5 包裝:Digi-Reel® 其它名稱:LM8364BALMF30DKR
X4643S8-2.7 功能描述:IC CPU SUPRV 64K EE RST LO 8SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 監控器 系列:- 標準包裝:1 系列:- 類型:簡單復位/加電復位 監視電壓數目:1 輸出:開路漏極或開路集電極 復位:低有效 復位超時:標準傳輸延遲為 60 µs 電壓 - 閥值:3V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SC-74A，SOT-753 供應商設備封裝:SOT-23-5 包裝:Digi-Reel® 其它名稱:LM8364BALMF30DKR
X4643S8-2.7A 功能描述:IC SUPERVISOR CPU 64K EE 8-SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 監控器 系列:- 標準包裝:100 系列:- 類型:簡單復位/加電復位 監視電壓數目:1 輸出:- 復位:低有效 復位超時:最小為 100 ms 電壓 - 閥值:4.38V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:8-TSSOP 包裝:管件
X4643S8-2.7AT1 功能描述:IC SUPERVISOR CPU 64K EE 8-SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 監控器 系列:- 標準包裝:100 系列:- 類型:簡單復位/加電復位 監視電壓數目:1 輸出:- 復位:低有效 復位超時:最小為 100 ms 電壓 - 閥值:4.38V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:8-TSSOP 包裝:管件
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*