參數資料
型號: X93154UM8IZ-3T1
廠商: Intersil
文件頁數: 6/9頁
文件大?。?/td> 0K
描述: IC POT DGTL LP LN 50K OHM 8-MSOP
產品培訓模塊: Digitally Controlled Potentiometers
標準包裝: 1
系列: XDCP™
接片: 32
電阻(歐姆): 50k
電路數: 1
溫度系數: 標準值 ±35 ppm/°C
存儲器類型: 非易失
接口: 3 線串行(芯片選擇,遞增,增/減)
電源電壓: 2.7 V ~ 3.3 V
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 8-TSSOP,8-MSOP(0.118",3.00mm 寬)
供應商設備封裝: 8-MSOP
包裝: 標準包裝
其它名稱: X93154UM8IZ-3T1DKR
6
FN8180.3
February 19, 2008
Instructions and Programming
The INC, U/D and CS inputs control the movement of the
wiper along the resistor array. With CS set LOW, the device
is selected and enabled to respond to the U/D and INC
inputs. HIGH to LOW transitions on INC will increment or
decrement (depending on the state of the U/D input) a 5-bit
counter. The output of this counter is decoded to select one
of thirty two wiper positions along the resistive array.
The value of the counter is stored in nonvolatile memory
whenever CS transitions HIGH while the INC input is also
HIGH. In order to avoid an accidental store during power-up,
CS must go HIGH with VCC during initial power-up. When
performing multiple write operations, VCC must not decrease
by more than 150mV from its initial value. When left open,
the CS pin is internally pulled up to VCC by an internal 30k
resistor.
The system may select the X93154, move the wiper and
deselect the device without having to store the latest wiper
position in nonvolatile memory. After the wiper movement is
performed as previously described and once the new
position is reached, the system must keep INC LOW while
taking CS HIGH. The new wiper position will be maintained
until changed by the system or until a power-up/down cycle
recalled the previously stored data. In order to recall the
stored position of the wiper on power-up, the CS pin must be
held HIGH.
This procedure allows the system to always power-up to a
preset value stored in nonvolatile memory; then during
system operation minor adjustments could be made. The
adjustments might be based on user preference, system
parameter changes due to temperature drift, or other system
trim requirements.
The state of U/D may be changed while CS remains LOW.
This allows the host system to enable the device and then
move the wiper up and down until the proper trim is attained.
Symbol Table
Applications Information
Electronic digitally controlled (XDCP) potentiometers provide
three powerful application advantages:
1. The variability and reliability of a solid-state potentiometer
2. The flexibility of computer-based digital controls
3. The retentivity of nonvolatile memory used for the storage
of multiple potentiometer settings or data
.
Mode Selection
CS
INC
U/D
MODE
L
H
Wiper Up
L
Wiper Down
H
X
Store Wiper Position
H
X
Standby Current
L
X
No Store, Return to Standby
L
H
Wiper Up (not recommended)
L
Wiper Down (not recommended)
WAVEFORM
INPUTS
OUTPUTS
Must be
steady
Will be
steady
May change
from Low to
High
Will change
from Low to
High
May change
from High to
Low
Will change
from High to
Low
Don’t Care:
Changes
Allowed
Changing:
State Not
Known
N/A
Center Line
is High
Impedance
VR
Two terminal variable resistor.
Variable current
I
X93154
相關PDF資料
PDF描述
VE-JNL-MZ CONVERTER MOD DC/DC 28V 25W
VE-26W-MY-F4 CONVERTER MOD DC/DC 5.5V 50W
VE-JNJ-MZ CONVERTER MOD DC/DC 36V 25W
MS27466T25B35SB CONN RCPT 128POS WALL MNT W/SCKT
VE-B5P-MW-B1 CONVERTER MOD DC/DC 13.8V 100W
相關代理商/技術參數
參數描述
X93154UU8IZ-3 功能描述:IC XDCP 32-TAP 50K 3-WIRE 8-MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數字電位器 系列:XDCP™ 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 接片:32 電阻(歐姆):50k 電路數:1 溫度系數:標準值 50 ppm/°C 存儲器類型:易失 接口:3 線串行(芯片選擇,遞增,增/減) 電源電壓:2.7 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 細型,TSOT-23-6 供應商設備封裝:TSOT-23-6 包裝:帶卷 (TR)
X93154UU8IZ-3T1 功能描述:IC POT DGTL LP LN 50K OHM 8-TDFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數字電位器 系列:XDCP™ 標準包裝:2,500 系列:XDCP™ 接片:256 電阻(歐姆):100k 電路數:1 溫度系數:標準值 ±300 ppm/°C 存儲器類型:非易失 接口:I²C(設備位址) 電源電壓:2.7 V ~ 5.5 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:14-TSSOP(0.173",4.40mm 寬) 供應商設備封裝:14-TSSOP 包裝:帶卷 (TR)
X93154UX8I-3 制造商:Intersil Corporation 功能描述:Low Noise,Low Power,32-TAPS DCP,3-Wire 制造商:Intersil Corporation 功能描述:Low Noise, Low Power, 32 Taps Digitally Controlled Potentiometer
X93155 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Digitally Controlled Potentiometer (XDCP)
X93155_08 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Digitally Controlled Potentiometer(XDCP?)