- 您現在的位置：買賣IC網 > PDF目錄372541 > X9CC102P IC PDF資料下載
參數資料
| 型號： | X9CC102P |
| 英文描述： | IC |
| 中文描述： | 集成電路 |
| 文件頁數： | 3/9頁 |
| 文件大小： | 61K |
| 代理商： | X9CC102P |
X9C102/103/104/503
3
PRINCIPLES OF OPERATION
There are three sections of the X9Cxxx: the input control,
counter and decode section; the nonvolatile memory;
and the resistor array. The input control section operates
just like an up/down counter. The output of this counter is
decoded to turn on a single electronic switch connecting
a point on the resistor array to the wiper output. Under
the proper conditions the contents of the counter can be
stored in nonvolatile memory and retained for future use.
The resistor array is comprised of 99 individual resistors
connected in series. At either end of the array and
between each resistor is an electronic switch that
transfers the potential at that point to the wiper.
The wiper, when at either fixed terminal, acts like its
mechanical equivalent and does not move beyond the
last position. That is, the counter does not wrap around
when clocked to either extreme.
The electronic switches on the device operate in a “make
before break” mode when the wiper changes tap
positions. If the wiper is moved several positions, multiple
taps are connected to the wiper for t
change). The R
TOTAL
value for the device can temporarily
be reduced by a significant amount if the wiper is moved
several positions.
IW
(INC to V
W
When the device is powered-down, the last wiper
position stored will be maintained in the nonvolatile
memory. When power is restored, the contents of the
memory are recalled and the wiper is set to the value last
stored.
INTRUCTIONS AND PROGRAMMING
The INC, U/D and CS inputs control the movement of the
wiper along the resistor array. With CS set LOW the
device is selected and enabled to respond to the U/D and
INC inputs. HIGH to LOW transitions on INC will
increment or decrement (depending on the state of the
U/D input) a seven-bit counter. The output of this counter
is decoded to select one of one-hundred wiper positions
along the resistive array.
The value of the counter is stored in nonvolatile memory
whenever CS transistions HIGH while the INC input is
also HIGH.
The system may select the X9Cxxx, move the wiper, and
deselect the device without having to store the latest
wiper position in nonvolatile memory. After the wiper
movement is performed as described above and once
the new position is reached, the system must keep INC
LOW while taking CS HIGH. The new wiper position will
be maintained until changed by the system or until a
power-down/up cycle recalled the previously stored data.
This procedure allows the system to always power-up to
a preset value stored in nonvolatile memory; then during
system operation minor adjustments could be made. The
adjustments might be based on user preference: system
parameter changes due to temperature drift, etc...
The state of U/D may be changed while CS remains
LOW. This allows the host system to enable the device
and then move the wiper up and down until the proper
trim is attained.
MODE SELECTION
SYMBOL TABLE
CS
L
L
INC
U/D
H
L
X
X
X
Mode
Wiper Up
Wiper Down
Store Wiper Position
Standby Current
No Store, Return to Standby
H
X
L
H
WAVEFORM
INPUTS
OUTPUTS
Must be
steady
Will be
steady
May change
from Low to
High
May change
from High to
Low
Will change
from Low to
High
Will change
from High to
Low
Don’t Care:
Changes
Allowed
N/A
Changing:
State Not
Known
Center Line
is High
Impedance
相關PDF資料 |
PDF描述 |
|---|---|
| X9xx-EVM(中文) | Xicor DCP X9xx Evaluation Kit and LabVIEW Manual(XICOR DCP X9xx評估套件及LabVIEW使用手冊) |
| XA-S3 | XA 16-bit microcontroller 32 K/1 K OTP/ROM/ROMless, 8-channel 8-bit A/D, low voltage 2.7 V.5.5 V, I2C, 2 UARTs, 16 MB address range |
| XA-SCC | CMOS 16-bit communications microcontroller |
| XA1024 | Temperature Sensor(Frequencies Range Between 2 And 30 MHz)(溫度傳感器(頻率范圍: 2至 30 MHz)) |
| XA979 | Temperature Sensor(Frequencies Range Between 2 And 30 MHz)(溫度傳感器(頻率范圍: 2至 30 MHz)) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| X9CVCAMP01 | 制造商:3M Electronic Products Division 功能描述:KE727054782 TRASP CONSUMABLE SAMPLING RED X9CVCAMP01 |
| X9DAX-IF-B | 制造商:Supermicro Computer Inc 功能描述:X9DAX-IF MOTHERBOARD (BULK) - Bulk |
| X9DAX-IF-O | 制造商:Supermicro Computer Inc 功能描述:X9DAX-IF MOTHERBOARD (SINGLE) - Bulk |
| X9DBL-I-O | 制造商:Supermicro Computer Inc 功能描述:MOTHERBOARD X9DBL-I-SINGLE - Bulk |
| X9DRD-7JLN4F-B | 制造商:Supermicro Computer Inc 功能描述:MOTHERBOARD X9DRD-7JLN4F, BULK - Bulk |
發布緊急采購，3分鐘左右您將得到回復。