- 您現在的位置：買賣IC網 > PDF目錄17084 > XE8000EV108 (Semtech)EVAL BOARD FOR XE8806/XE8807 PDF資料下載
參數資料
| 型號： | XE8000EV108 |
| 廠商： | Semtech |
| 文件頁數： | 130/143頁 |
| 文件大小： | 0K |
| 描述： | EVAL BOARD FOR XE8806/XE8807 |
| 標準包裝： | 1 |
| 類型： | MCU |
| 適用于相關產品： | XE88LC06AMI026 |
| 所含物品： | 完全組裝的評估板 |
| 產品目錄頁面： | 585 (CN2011-ZH PDF) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁當前第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁
Semtech 2006
www.semtech.com
14-7
XE8806A/XE8807A
14.8.1
Input data filter and bit synchronization
14.8.1.1
NRZ code
When the NRZ codes are used, the bit synchronization clock should be extracted from the preamble since the
coding itself may not contain clock information. The input data filter has to be used (see description below in
section 14.8.1.2) to extract the bit synchronization clock. The bit RfifRxClock in register RegRfifCmd2 is to be
cleared to 0. If the input data stream contains long periods without transitions, the internally generated bit
synchronization clock could slip with respect to the bit rate resulting in transmission errors (see also specification in
chapter 14.11). Tests have shown a very robust behavior with the internal bit synchronizer though.
An external bit synchronization clock can be used. This clock has to be delivered on the pin RFIF1. The bit stream
on RFIF0 is then sampled on detection of the rising edge of the clock on the RFIF1 pin. This function has to be
enabled by setting bit RfifRxClock in register RegRfifCmd2 to 1. Selecting this function bypasses the input filter.
In practice, it was found that the synchronization was more reliable with the internal synchronization filter than with
the external bit clock.
14.8.1.2
Bi-phase and Miller code
The bi-phase and Miller code include clock information and no external bit synchronization clock is needed. The
input data filter is used to filter the noise on the input data. The filter samples the input data at 16 times the selected
baud rate and performs the following majority function on 8 successive samples:
if (number of ’1’ in the last 8 samples >= 6)
data = 1
if (number of ‘1’ in the last 8 samples <= 2)
data = 0
else data = former data
The filter has some hysteresis since the output does not change when the number of 1’s is between 2 and 6.
The input filter is always selected for the bi-phase and Miller coding independent from the value of the bit
RfifRxClock in register RegRfifCmd2.
14.8.2
Start Sequence Detection or message synchronization
A full message is mainly composed of three parts:
1) a preamble or start sequence
2) the data itself
3) an optional stop sequence.
A start sequence is necessary to indicate the start of a new message.
The interface supports the detection of several types of start sequences. The user can chose between these start
sequence detection modes using the bits RfifEnStart[1:0] in RegRfifCmd2 as shown in Table 14-13. The actual
implementation of the detection mode differs depending on the selected PCM coding and is described below.
A start sequence detection will set the bit RfifRxStartDet in the register RegRfifRxSta and generate an interrupt
on the Irq_Rfif_Rx line. The contents of the reception FIFO is reset. The data of the preceding message that were
not yet read at the occurrence of a new start sequence are lost. The first bit in the FIFO is the first valid bit decoded
after the detected start sequence.
The bit RfifRxStartDet has to be cleared by software by writing a 1 to the bit.
相關PDF資料 |
PDF描述 |
|---|---|
| 94SVP476X0020E7 | CAP ALUM 47UF 20V 20% SMD |
| EBC22DRTI-S13 | CONN EDGECARD 44POS .100 EXTEND |
| AT-S-26-8/8/B-14-R | MOD CORD STANDARD 8-8 BLACK 14' |
| LGU2E221MELZ | CAP ALUM 220UF 250V 20% SNAP |
| VE-BT1-EY | CONVERTER MOD DC/DC 12V 50W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| XE8000EV110 | 功能描述:EVAL BOARD FOR XE8802AMI035LF RoHS:否 類別:編程器，開發系統 >> 通用嵌入式開發板和套件（MCU、DSP、FPGA、CPLD等） 系列:- 產品培訓模塊:Blackfin® Processor Core Architecture Overview Blackfin® Device Drivers Blackfin® Optimizations for Performance and Power Consumption Blackfin® System Services 特色產品:Blackfin? BF50x Series Processors 標準包裝:1 系列:Blackfin® 類型:DSP 適用于相關產品:ADSP-BF548 所含物品:板，軟件，4x4 鍵盤，光學撥輪，QVGA 觸摸屏 LCD 和 40G 硬盤 配用:ADZS-BFBLUET-EZEXT-ND - EZ-EXTENDER DAUGHTERBOARDADZS-BFLLCD-EZEXT-ND - BOARD EXT LANDSCAP LCD INTERFACE 相關產品:ADSP-BF542BBCZ-4A-ND - IC DSP 16BIT 400MHZ 400CSBGAADSP-BF544MBBCZ-5M-ND - IC DSP 16BIT 533MHZ MDDR 400CBGAADSP-BF542MBBCZ-5M-ND - IC DSP 16BIT 533MHZ MDDR 400CBGAADSP-BF542KBCZ-6A-ND - IC DSP 16BIT 600MHZ 400CSBGAADSP-BF547MBBCZ-5M-ND - IC DSP 16BIT 533MHZ MDDR 400CBGAADSP-BF548BBCZ-5A-ND - IC DSP 16BIT 533MHZ 400CSBGAADSP-BF547BBCZ-5A-ND - IC DSP 16BIT 533MHZ 400CSBGAADSP-BF544BBCZ-5A-ND - IC DSP 16BIT 533MHZ 400CSBGAADSP-BF542BBCZ-5A-ND - IC DSP 16BIT 533MHZ 400CSBGA |
| XE8000EV120 | 功能描述:BOARD EVAL FOR SX8722I070TRLF RoHS:是 類別:編程器，開發系統 >> 評估板 - 模數轉換器 (ADC) 系列:ZoomingADC™ 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:- ADC 的數量:1 位數:12 采樣率（每秒）:94.4k 數據接口:USB 輸入范圍:±VREF/2 在以下條件下的電源（標準）:- 工作溫度:-40°C ~ 85°C 已用 IC / 零件:MAX11645 已供物品:板，軟件 |
| XE8000EV121 | 功能描述:BOARD EVAL FOR SX8723/24 RoHS:是 類別:編程器，開發系統 >> 評估演示板和套件 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:- 主要目的:電源管理，電池充電器 嵌入式:否 已用 IC / 零件:MAX8903A 主要屬性:1 芯鋰離子電池 次要屬性:狀態 LED 已供物品:板 |
| XE8000MP | 功能描述:PROG BOARD AND PROSTART2 CARD RoHS:否 類別:編程器，開發系統 >> 獨立編程器 系列:- 產品目錄繪圖:CHIPPROG-G4 標準包裝:1 系列:- 類型:成組編程器 適用于相關產品:EEPROM，EPROM，F(xiàn)LASH，MCU，NVRAM，PLD 所含物品:編程器，線纜，CD 產品目錄頁面:598 (CN2011-ZH PDF) 相關產品:AE-TS56-16I-3-ND - ISP CABLEADAPTER 14-PIN HEADERAE-TS40N-ND - ADAPTER SOCKET 40-TSOP TO 40-DIPAE-TS32N-ND - ADAPTER SOCKET 32-TSOP TO 32-DIPAE-TS28-ND - ADAPTER SOCKET 28-TSOP TO 28-DIPAE-T44-P16-ND - ADAPTER SOCKET 44-QFP TO 40-DIPAE-T44-I51/505-ND - ADAPTER SOCKET 44-QFP TO 40-DIPAE-SS56-16I-ND - ADAPTER SOCKET 56-SSOP TO 40-DIPAE-SP8U-ND - ADAPTER SOCKET 8-SSOP TO 8-DIPAE-SP28U2-ND - ADAPTER SOCKET 28-SSOP TO 28-DIPAE-SP28U1-ND - ADAPTER SOCKET 28-SSOP TO 28-DIP更多... |
| XE8801A | 制造商:SEMTECH 制造商全稱:Semtech Corporation 功能描述:Data Acquisition with ZoomingADC? |
發布緊急采購，3分鐘左右您將得到回復。