參數資料
型號: XR16C2850IJ
廠商: EXAR CORP
元件分類: 微控制器/微處理器
英文描述: DUAL UART WITH 128-byte FIFO’s AND RS-485 HALF DUPLEX CONTROL
中文描述: 2 CHANNEL(S), 6.25M bps, SERIAL COMM CONTROLLER, PQCC44
封裝: PLASTIC, LCC-44
文件頁數: 16/43頁
文件大?。?/td> 611K
代理商: XR16C2850IJ
á
3.3V AND 5V DUART WITH 128-BYTE FIFO
XR16C2850
REV. 2.0.0
16
2.19 S
LEEP
M
ODE
WITH
A
UTO
W
AKE
-U
P
The 2850 supports low voltage system designs,
hence, a sleep mode is included to reduce its power
consumption when the chip is not actively used. With
EFR bit-4 and IER bit-4 of both channels enabled (set
to a logic 1), the 2850 DUART enters sleep mode
when no interrupt is pending for both channels. The
2850 stops its crystal oscillator to further conserve
power in the sleep mode. User can check the XTAL2
pin for no clock output as an indication that the device
has entered the sleep mode. The 2850 resumes nor-
mal operation by any of the following: a receive data
start bit transition (logic 1 to 0), a change of logic
state on any of the modem or general purpose input
pins: CTS#, DSR#, CD#, RI# or a transmit data byte
is loaded to the THR/FIFO by the user. If the 2850 is
awakened by one of the above conditions, it will re-
turn to the sleep mode automatically after all inter-
rupting condition have been serviced and cleared. In
any case, the sleep mode will not be entered while an
interrupt is pending from channel A or B. The 2850
will stay in the sleep mode of operation until it is dis-
abled by setting IER bit-4 to a logic 0.
A word of caution: owing to the starting up delay of
the crystal oscillator after waking up from sleep
mode, the first few receive characters may be lost. Al-
so, make sure the RX A/B inputs are idling at logic 1
or “marking” condition during sleep mode to avoid re-
ceiving a “break” condition upon the restart. This may
occur when the external interface transceivers (RS-
232, RS-485 or another type) are also put to sleep
mode and cannot maintain the “marking” condition.
To avoid this, the system design engineer can use a
47k ohm pull-up resistor on the RXA and RXB pins.
2.20 I
NTERNAL
L
OOPBACK
The 2850 UART provides an internal loopback capa-
bility for system diagnostic purposes. The internal
loopback mode
is enabled by setting MCR register
bit-4 to logic 1. All regular UART functions operate
normally. Figure 13 shows how the modem port sig-
nals are re-configured. Transmit data from the trans-
mit shift register output is internally routed to the re-
ceive shift register input allowing the system to re-
ceive the same data that it was sending. The TX pin
is held at logic 1 or mark condition while RTS# and
DTR# are de-asserted, and CTS#, DSR# CD# and
RI# inputs are ignored. Caution: the RX input must be
held to a logic 1 during loopback test else upon exit-
ing the loopback test the UART may detect and report
a false “break” signal.
F
IGURE
12. I
NFRARED
T
RANSMIT
D
ATA
E
NCODING
AND
R
ECEIVE
D
ATA
D
ECODING
Character
Data Bits
S
S
0
0
0
0
0
1
1
1
1
1
Bit Time
1/16 Clock Delay
IRdecoder-1
RX Data
Receive
IR Pulse
(RX pin)
Character
Data Bits
S
S
0
0
0
0
0
1
1
1
1
1
TX Data
Transmit
IR Pulse
(TX Pin)
Bit Time
1/2 Bit Time
3/16 Bit Time
IrEncoder-1
相關PDF資料
PDF描述
XR16C2850IM DUAL UART WITH 128-byte FIFO’s AND RS-485 HALF DUPLEX CONTROL
XR16C2850IP DUAL UART WITH 128-byte FIFO’s AND RS-485 HALF DUPLEX CONTROL
XR16C2852 3.3V AND 5V DUART WITH 128-BYTE FIFO
XR16C2852CJ 3.3V AND 5V DUART WITH 128-BYTE FIFO
XR16C2852IJ 3.3V AND 5V DUART WITH 128-BYTE FIFO
相關代理商/技術參數
參數描述
XR16C2850IJ44 制造商:EXAR 制造商全稱:EXAR 功能描述:3.3V AND 5V DUART WITH 128-BYTE FIFO
XR16C2850IJ-F 功能描述:UART 接口集成電路 UART RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
XR16C2850IJTR-F 功能描述:UART 接口集成電路 UART RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
XR16C2850IM 制造商:EXAR 制造商全稱:EXAR 功能描述:2.97V TO 5.5V DUAL UART WITH 128-BYTE FIFOS
XR16C2850IM48 制造商:EXAR 制造商全稱:EXAR 功能描述:3.3V AND 5V DUART WITH 128-BYTE FIFO