參數資料
型號： XR88C92CJTR-F
廠商： Exar Corporation
文件頁數： 5/32頁
文件大?。?/td> 0K
描述： IC UART FIFO DUAL 44PLCC
標準包裝： 500
特點： *
通道數： 2，DUART
FIFO's： 16 字節
電源電壓： 2.97 V ~ 5.5 V
帶自動流量控制功能： 是
帶CMOS： 是
安裝類型： 表面貼裝
封裝/外殼： 44-LCC（J 形引線）
供應商設備封裝： 44-PLCC（16.59x16.59）
包裝： 帶卷 (TR)
XR88C92/192
13
Rev. 1.33
Users can program the counter to generate an interrupt
request for this condition on the -INT output by
unmasking the bit-3 in the Interrupt Mask Register (IMR,
address 0x5). After 0x0000 the count becomes
0xFFFF, and the counter continues counting down from
there. If the CPU changes the pre-load value, the
counter will not recognize the new value until it receives
the next start counter command (and is reinitialized).
When a read at the stop counter command register
(address 0xF) is performed, the counter stops the
countdown sequence and clears ISR Bit-3. The count
value should only be read while the counter is stopped
because only one of the count registers (either CUR, at
address 0x6 or CLR, at address 0x7) can be read at a
time. If the counter is running, a decrement of CLR that
requires a borrow from the CUR could take place
between the two register reads. Figure 2 shows the
C/T output in the counter mode. OP3 can be pro-
grammed to show the C/T output.
In addition to the watch dog timer described above, the
C/T can be used for receive timeout function (see
description under CRA, CRB in the registers section
also). The C/T is more accurate and the timeout period
is programmable unlike the watchdog timer. However,
only one channel can use the C/T for receive timeout at
any given time. The C/T timeout mode uses the received
data stream to start the counter. Each time a character
is shifted from the receive shift register to the receive
FIFO, the C/T is reloaded with the programmed value in
CTPU and CTPL and it restarts on the next C/T clock.
If a new character is not received before the C/T reaches
terminal count (= 0x0000), a counter ready interrupt
(ISR bit-3) is generated. The user can appropriately
program the CTPU and CTPL for the desired timeout
period. Typically this is slightly more than one character
time. Note that if C/T is used for receiver timeout, a
counter ready interrupt is generated whereas if the
watchdog timer is used, a receiver ready interrupt is
generated.
TIMER MODE
In the timer mode, the C/T runs continuously once the
start command is issued (by reading the start C/T
command register) and the CPU cannot stop it. When
the stop command is issued (by reading the stop C/T
command register), the CPU only resets the C/T inter-
rupt. This mode allows the C/T to be used as a program-
mable clock source for channels A and B (see CSRA,
CSRB register), and/or a periodic interrupt generator. In
this mode, the C/T generates a square-wave output (see
Figure 2) derived from the programmed timer input
clock source. The square wave generated by the timer
has a period of 2 X (pre-load value) X (period of clock
source) and is available as a clock source for both
channels A and B. Since the timer cannot be stopped,
the values in the registers (CUR:CLR) should not be
read. See description of ACR register to see how to
choose clock source for the C/T.
When the start counter command register (STCR,
PRELOAD
VALUE
TERMINAL
COUNT
C/T OUTPUT IN
COUNTER MODE
C/T OUTPUT IN
TIMER MODE
PRELOAD
VALUE
TERMINAL
COUNT
PRELOAD
VALUE
TERMINAL
COUNT
PRELOAD
VALUE
PRELOAD
VALUE
TERMINAL
COUNT
TERMINAL
COUNT
TERMINAL
COUNT
PRELOAD
VALUE
PRELOAD
VALUE
START C/T COMMAND
ISSUED
PRELOAD
VALUE
TERMINAL
COUNT
Figure 2: C/T output in Timer and Counter modes.
相關PDF資料
PDF描述
ST16C452CJ68TR-F IC UART W/PAR PORT DUAL 68PLCC
ST16C552CJ68TR-F IC UART FIFO 16B DUAL 68PLCC
XR68C681CJTR-F IC UART CMOS DUAL 44PLCC
ST16C2550CJ44TR-F IC UART FIFO 16B DUAL 44PLCC
XR16V2750IMTR-F IC UART FIFO 64B DUAL 48TQFP
相關代理商/技術參數
參數描述
XR88C92CP 制造商:EXAR 制造商全稱:EXAR 功能描述:DUAL UNIVERSAL ASYNCHRONOUS RECEIVER AND TRANSMITTER
XR88C92CV 制造商:EXAR 制造商全稱:EXAR 功能描述:DUAL UNIVERSAL ASYNCHRONOUS RECEIVER AND TRANSMITTER
XR88C92CV-0A-EVB 功能描述:界面開發工具 Supports 88C92 44 ld TQFP, ISA Interface RoHS:否 制造商:Bourns 產品:Evaluation Boards 類型:RS-485 工具用于評估:ADM3485E 接口類型:RS-485 工作電源電壓:3.3 V
XR88C92CV-F 功能描述:UART 接口集成電路 Dual Channel UART RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
XR88C92CVTR-F 功能描述:UART 接口集成電路 Dual Channel UART RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*