![](http://datasheet.mmic.net.cn/Exar-Corporation/XRT72L52IQTR-F_datasheet_100115/XRT72L52IQTR-F_217.png)
XRT72L52
201
REV. 1.0.3
TWO CHANNEL DS3/E3 FRAMER IC WITH HDLC CONTROLLER
consists of three (3) M-bits that occur in a repeating 010 pattern. The M-bit search is declared successful if
three consecutive M-frames (or 21 F-frames) are detected correctly. Once this occurs an M-frame lock is
declared, and the Receive DS3 Framer block will then transition to the In-Frame state. At this point, the
Receive DS3 Framer block will declare itself in the In-Frame condition, and will begin Frame Maintenance
operations. The Receive DS3 Framer block will then indicate that it has transitioned from the OOF condition
into the In-Frame condition by doing the following.
Generate a Change in OOF Condition interrupt to the local P.
Negate the RxOOF output pin (e.g., toggle it "Low").
Negate the RxOOF bit-field (Bit 4) within the Receive DS3 Configuration and Status Register.
The Receive DS3 Framer can be configured to operate such that 'valid parity' (P-bits) must also be detected
before the Receive DS3 Framer can declare itself In Frame. This configuration is set by writing the appropriate
data to the Rx DS3 Configuration and Status Register, as depicted below.
Table 40 relates the contents of this bit field to the framing acquisition criteria.
Once the Receive DS3 Framer block is operating in the In-Frame condition, normal data recovery and
processing of the DS3 data stream begins. The maximum average reframing time is less than 1.5 ms.
4.3.2.2
Frame Maintenance Mode Operation
When the Receive DS3 Framer block is operating in the In-Frame state (per Figure 68), it will then begin to
perform Frame Maintenance operations, where it will continue to verify that the F- and M-bits are present, at
their proper locations. While the Receive DS3 Framer block is operating in the Frame Maintenance mode, it
will declare an Out-of-Frame (OOF) condition if 3 or 6 F-bits (depending upon user selection) out of 16
consecutive F-bits are in error.
This selection for the OOF Declaration criteria is made by writing the
appropriate value to bit 1 (F-Sync Algo) of the Rx DS3 Configuration and Status Register, as depicted below.
RX DS3 CONFIGURATION AND STATUS REGISTER, (ADDRESS = 0X10)
BIT 7
BIT 6
BIT 5
BIT 4
BIT 3
BIT2
BIT 1
BIT 0
RxAIS
RxLOS
RxIdle
RxOOF
Reserved
Framing on
Parity
F-Sync Algo
M-Sync Algo
RO
R/W
X
TABLE 40: THE RELATIONSHIP BETWEEN THE CONTENTS OF BIT 2 (FRAMING ON PARITY) WITHIN THE RX DS3
CONFIGURATION AND STATUS REGISTER, AND THE RESULTING FRAMING ACQUISITION CRITERIA
FRAMING
ON
PARITY
(BIT 2)
FRAMING ACQUISITION CRITERIA
0
The In-frame is declared after F-bit synchronization (10 F-bit matches) followed by M-bit synchronization (M-
bit matches for 3 DS3 M-frames)
1
The In-frame condition is declared after F-bit synchronization, followed by M-bit synchronization, with valid
parity over the frames. Also, the occurrence of parity errors in 2 or more out of 5 frames starts a frame search