參數資料
型號: XRT75L04IVTR-F
廠商: Exar Corporation
文件頁數: 43/57頁
文件大?。?/td> 0K
描述: IC LIU E3/DS3/STS-1 4CH 176LQFP
標準包裝: 1,000
類型: 線路接口裝置(LIU)
驅動器/接收器數: 4/4
規程: DS3,E3,STS-1
電源電壓: 3.135 V ~ 3.465 V
安裝類型: 表面貼裝
封裝/外殼: 176-LQFP
供應商設備封裝: 176-TQFP(24x24)
包裝: 帶卷 (TR)
XRT75L04
46
FOUR CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH JITTER ATTENUATOR
REV. 1.0.4
0x04 (ch 0)
0x0C (ch 1)
0x14 (ch 2)
0x!C (ch 3)
R/W
Transmit
Control
D0
TxLEV_n
Set this bit for cable length greater than 225
feet.
NOTE: See section 4.03 for detailed description.
0
D1
TxClkINV_
n
Set this bit to sample the data on TPOS/TNEG pins
on the rising edge of TxClk.
0
D2
TAOS_n
Set this bit to send a continuous stream of marks (All
Ones) out at the TTIP and TRing pins.
0
D3
Reserved
D4
INSPRBS_
n
Setting this bit causes the PRBS generator to insert
a single-bit error onto the transmit PRBS data
stream .
NOTE: PRBS Generator/Detector must be enabled
for this bit to have any effect.
0
D5
TxMON_n
Setting this bit causes the driver monitor its own
transmit
driver.
When
the
transmit
failure
is
detected, DMO output pin goes “High” and DMOIS
bit is set.
When this bit is “0”, MTIP and MRing are connected
to other transmit channel for monitoring.
0
D7-D6
Reserved
0x05 (Ch 0)
0x0D (Ch 1)
0x15 (Ch 2)
0x1D (ch 3)
R/W
Receive
Control
D0
REQEN_n
Set this bit to enable the Receive Equalizer.
NOTE: See section 5.01 for detailed description.
0
D1
RxMON_n
Set this bit to configure the Receiver in monitoring
mode. In this mode, the Receiver can monitor a sig-
nal at the RTIP/RRing pins that has be attenuated
up to 20dB flat loss.
0
D2
LOSMUT_
n
Setting this bit causes the RPOS/RNEG outputs to
“0” while the LOS condition is declared.
NOTE: If this bit has been set, it will remain set even
after the LOS condition is cleared.
0
D3
RxClkINV_
n
Set this bit to configure the Receiver to output
RPOS/RNEG data on the falling edge of RxClk_0.
0
D4
ALOSDIS_
n
Set this bit to disable the ALOS detector.
0
D5
DLOSDIS_
n
Set this bit to disable the DLOS detector.
0
D7-D6
Reserved
TABLE 21: REGISTER MAP DESCRIPTION
ADDRESS
(HEX)
TYPE
REGISTER
NAME
BIT#
SYMBOL
DESCRIPTION
DEFAULT
VALUE
相關PDF資料
PDF描述
VI-23V-IU-F1 CONVERTER MOD DC/DC 5.8V 200W
VE-B1T-MW-F3 CONVERTER MOD DC/DC 6.5V 100W
XRT75L04IVTR IC LIU E3/DS3/STS-1 4CH 176LQFP
VI-23R-IU-F3 CONVERTER MOD DC/DC 7.5V 200W
IDT72V841L15TF IC FIFO SYNC 2048X18 15NS 64QFP
相關代理商/技術參數
參數描述
XRT75L06 制造商:EXAR 制造商全稱:EXAR 功能描述:SIX CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH JITTER ATTENUATOR
XRT75L06D 制造商:EXAR 制造商全稱:EXAR 功能描述:SIX CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH SONET DESYNCHRONIZER
XRT75L06DES 功能描述:時鐘合成器/抖動清除器 6CH T3/E3/STS1 LIU+DESYNCH 3.3V RoHS:否 制造商:Skyworks Solutions, Inc. 輸出端數量: 輸出電平: 最大輸出頻率: 輸入電平: 最大輸入頻率:6.1 GHz 電源電壓-最大:3.3 V 電源電壓-最小:2.7 V 封裝 / 箱體:TSSOP-28 封裝:Reel
XRT75L06DIB 功能描述:接口 - 專用 6CH E3/DS3/STS1 LIU w/DeSynch RoHS:否 制造商:Texas Instruments 產品類型:1080p60 Image Sensor Receiver 工作電源電壓:1.8 V 電源電流:89 mA 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:BGA-59
XRT75L06DIB-F 功能描述:外圍驅動器與原件 - PCI 6-Ch DS3, E3, STS-1 RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray